In-Sink-Erator F-201 General Manual

The Next

Necessity

Instant Hot Water Dispensers

Model

F-201 Filtration System

The only filtration system designed exclusively

™

For instant hot water dispensers

Dimensions

rf mo dloc

retaw telni

8-3/4

"

ot tecuaf

Submittal Sheet

• Ideal for any instant hot water dispenser,
refrigerator, icemaker, or virtually any
drinking water system

• Reduces Chlorine, taste and odor for
clean, refreshing taste

• Quick-connect fittings guarantee
easy installation

• Sanitary, quick-change filter cartridge
makes replacement easy. A simple twist
is all it takes!

• Automatically shuts off water when filter
cartridge is replaced

• 6-12 month recommended filter
cartridge replacement

Warranty:

1-year parts and in-home service*

(excluding replaceable filter cartridge)

* The complete InSinkErator warranty is included in the Care & Use
booklet packed with each unit.

F-201R Cartridge (included with this system) Chemical & Mechanical Reduction Filter Specifications: This
cartridge provides mechanical and chemical reduction of dirt/rust, chlorine taste and odor, and particulates.

System Teste d and Certif ied by NSF Inter national
agains t NSF/ANSI St andard 42 for the r eduction of
Chlori ne taste and odo r.

Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under
standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be
installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty
card for warranty. For service and parts, contact your local dealer or InSinkErator

Specifications

Filter Capacity

Temperature
Range

Pressure

Flow Rate

Shipping Weight

Pressure: 20-120 psi
Temperature: 33
Flow Rate: 0.75 gpm
Capacity: 500 gallons

º

F - 100ºF

500 gallons

Incoming cold water
can be from 33˚F to
100˚F (1˚C to 38˚C).
For cold water
use only.

20-120 psi

0.75 gpm

Approximately 2.2 lbs.

®

directly at 1-800-558-5700.

,

3-1/4

"

Application guidelines/Water Supply Parameters for NSF Testing: Service flow of 0.75 gpm, community or private

water supply, water pressure of 20-120 psi, water temperature of 33˚F–100˚F. Except as noted, all testing

well
performed at pH = 7.5 ± 0.5, Flow: 0.75 gpm, Pressure: 60 psi, Temp: 20˚±3˚C.

Contact an authorized InSinkErator service agent for repairs or replacement components.

Job Specifications

1-800-558-5700
www.insinkerator.com

HWD251-07D-45-02 Printed in USA

The Emerson logo is a trademark and

service mark of Emerson Electric Co.

InSinkErator may make improvements and/or

changes in the specifications at any time, in its sole

discretion, without notice or obligation and further

reserves the right ot change or discontinue models.

© 2009 InSinkErator, a division of

Emerson Electric Co. All Rights Reserved.