Insinkerator F-1000 User Manual

Instant Hot Water Dispensers

Model

F-1000 Replacement Filter

The Next

Necessity

Dimensions

For cleaner, fresher-tasting water

™

Submittal Sheet

• Includes 1 replacement filter for use
with InSinkErator water filtration system

• Reduces particulates, chlorine taste and
odor for clean, refreshing taste

• Sanitary, quick-change filter cartridge

makes replacement easy. A simple twist
is all it takes!

• Replace every 6 months at the rated
capacity or if a noticeable reduction
in flow rate occurs

F-1000 Cartridge (included with this system) Chemical & Mechanical Reduction Filter Specifications:

This cartridge provides mechanical and chemical reduction of chlorine taste & odor and particulate class III.

Tested & Cer tified by NSF I nternational ag ainst NSF/ANSI S tandard 42 in t he following
InSinkE rator Syste ms Only: GN1100, HC1100, GN220 0, HC2200, GN2 215, HC2215,
H3300 o r HC3300 for t he reduction of cla ims specified o n the Perfor mance Data Shee t.
For system s using two handle HC m odel faucets, op erate only one hand le at a time.

Filter Capacity: 500 gallons, depending on local water conditions. Note that while the testing was performed under
standard laboratory conditions, actual performance may vary. Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before or after the system. For cold water use only. Systems must be
installed and operated in accordance with the Manufacturer’s recommended procedures and guidelines. See warranty
card for warranty. For service and parts, contact your local dealer or InSinkErator

Specifications

Filter Capacity

Temperature
Range

Pressure

Flow Rate

Shipping Weight

500 gallons

Incoming cold water
supply line can be
from 33˚F to 100˚F
(1˚C to 38˚C).
Connect to cold water
supply line only.

30-120 psi

.75 gpm

Approximately 1.0 lbs.

Pressure: 30-120 (207-827 kPa) psi
Temperature: 33
Flow Rate: .75 gpm
Capacity: 500 gallons

®

directly at 1-800-558-5700.

º

F - 100ºF

11-3/4

"

2-1/4

"

Nominal
Particulate Class III,
≥5 µm to <15 µm

Application guidelines/Water Supply Parameters for NSF Testing: Service flow of .75 gpm, community or
private well water supply, water pressure of 20-120 psi (138-827 kPa), water temperature of 33˚F–100˚
noted, all testing performed at pH = 7.5 ± 0.5, Flow: .75 gpm, P ressure: 60 psi, Temp: 20˚± 3˚C.

Refer to the Performance Data Sheet for InSinkErator Filter System Model F-2000S
Replacement Cartridge: F-2000

Contact an authorized InSinkErator service agent for repairs or replacement components. Replacement filters
F-1000 and F-2000 can be ordered by calling 800-558-5700, visiting shop.insinkerator.com, or by contacting
an authorized InSinkErator reseller.

Job Specifications

USA
1-800-558-5700

www.insinkerator.com

Canada
www.insinkerator.ca

HWD440-13D-45-10 Printed in USA

2.1 mg/L 2.0 mg/L ± 10%

270,000 pts/mL

At least 10,000

particles/mL

0.06 mg/L 97.0% ≥ 50% J-00082587

82 pts/mL 99.9% ≥85%

The Emerson logo is a trademark

and a service mark of Emerson Electric Co.

InSinkErator may make improvements and/or changes

in the specifications at any time, in its sole discretion,

without notice or obligation and further reserves the

right to change or discontinue models.

©2013 InSinkErator, a business unit of

Emerson Electric Co. All Rights Reserved.

J-00119308

F Except as