Insignia NS-MB5000-C user guide
Quick Setup Guide
Mobile Battery Pack
|
NS-MB5000-C
PACKAGE CONTENTS
• Mobile Battery Pack
• Micro USB Charging Cable
• Quick Setup Guide
CHARGING THE MOBILE BATTERY
LEDs
Micro USB (input)
1 Plug the small end of the USB cable into the mobile battery’s
microUSB port (input).
2 Plug the large end of the included USB cable into a standard USB
port on your computer, vehicle charger, or wall charger (not
included).
The mobile battery automatically begins charging.
Before using your new product,
please read these instructions to prevent any damage.
CHARGING YOUR ELECTRONIC DEVICE
USB (output)
1 Plug the large end of the USB cable into one of the mobile
battery’s USB ports (output).
2 Plug the small end of the USB cable into your device.
The mobile battery automatically begins charging your
device.
Notes:
• You can use both outputs to charge your devices at the
same time. The total maximum output is 2A.
• If your device requires a dierent connector than the one
provided, use the cable that came with your device
CHECKING YOUR BATTERY LEVEL
• • • • 4 LEDs = 75-100% power
• • • • 3 LEDs = 50-75% power
• • • • 2 LEDs = 25-50% power
• • • • 1 LED = 0-25% power
SPECIFICATIONS
• Input: 5V, 1A
• Output: 5V, 2A max
• Capacity: 5000mAh
SAFETY INFORMATION/CAUTION
1 Do not expose your mobile battery pack and accessories to heat, re, or water.
2 Do not modify, disassemble, open, drop, crush, puncture, or shred the internal
battery.
3 Do not connect a cable to the microUSB (input) and USB (output) ports at the same
time.
4 This is not a toy. Young children should be supervised to make sure that they do not
play with the mobile battery.
5 Do not use the mobile battery while charging is in progress.
6 Recharge the mobile battery before use if it has not been used for more than 90
days.
This product is safe for regular use under normal conditions. As with any device using
electrical power, some situations may be unsafe and injuries or damages could result. To
minimize or avoid unsafe conditions, please read and follow the instructions before
using.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any
interference received, including interference that may cause undesired operation.
FCC Caution
Changes or modications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
ICES Statement
CAN ICES-3 (B)/NMB-3 (B)
ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call
U.S. and Canada (877-467-4289)
Mexico (01-800-926-3000)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Registered in some countries.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2014 Best Buy. All rights reserved.
Made in China
V2 ENGLISH 14-0691
Loading...