Insignia NS-DA29-2, NS-DA29-1-C, NS-DA29-2-C Quick Setup Guide

QUICK SETUP GUIDE
Refrigerator Filter
NS-DA29-2/NS-DA29-1-C/NS-DA29-2-C
PACKAGE CONTENTS
• Refrigerator lter(s) (1 or 2 pack)
Quick Setup Guide
GENERAL INSTALLATION GUIDELINES
• It is normal for black carbon nes (particles) to appear on the outside of your lter. This happens when the lter is jarred in shipping. It is safe, simply wipe it o.
The lter connectors are larger to prevent leaks. You might have to
twist the lter hard to make sure the connection is secure.
INSTALLING THE WATER FILTER
Carefully remove the plastic cap from the new lter before installation.
installing it in your refrigerator to remove air from the carbon block.
2 Twist the old lter a quarter-turn counter-clockwise. 3 Pull the lter straight down and discard. 4 Push the new lter up into the refrigerator until it stops. 5 Twist the lter a quarter-turn clockwise. 6 Run about two to three gallons of water through your refrigerator’s water
dispenser to remove air and loose carbon pieces. The water may be cloudy and sputter until the air is removed.
7 Reset your “change lter” indicator (if your refrigerator has one). See
below.
RESETTING YOUR CHANGE FILTER INDICATOR
Note: These are the most common lter reset instructions. If the instructions don’t
work for your refrigerator brand, see the documentation that came with your refrigerator.
Before using your new product, please read these instructions to prevent any damage.
REFRIGERATOR BRAND
Samsung
INSTRUCTIONS
Press and hold the ICE TYPE and CHILD LOCK buttons for three seconds. The water lter indicator should turn green.
Note: Only hold these buttons for three seconds. Holding these buttons for ve seconds cancels the reset. If you cancel the reset, repeat the procedure.
TROUBLESHOOTING STORAGE AND MAINTENANCE
PROBLEM
My refrigerator is not dispensing water
My water dispenser is dripping
My water is cloudy or contains black carbon pieces
My new lter is making noises or sputtering
My water tastes bad
SOLUTION
• Make sure that you soaked your lter in water for 15 minutes before installing.
• Make sure that the lter is securely connected to the receiver. Do not use tools to tighten the lter in place.
• Make sure that the water line to the refrigerator is turned on. The valve must be completely open for the refrigerator to receive water.
• Make sure that the refrigerator door is closed or the dispenser will not work.
• A few drops are normal. If the water is dripping constantly, have a service technician check your refrigerator’s water valve.
• Cloudy water is caused by microscopic air bubbles. Run two to three gallons of water from your dispenser to clear the air bubbles out.
• Black carbon pieces in the water are normal and appear with all carbon lters. Run two to three gallons of water through your dispenser to remove loose carbon pieces.
• Make sure that you soaked your lter in water for 15 minutes before installing.
• Noises and sputtering are caused by trapped air pockets. Run two to three gallons of water from your dispenser to push the air out.
• If you do not use your water dispenser for more than four days, run two gallons of water through the dispenser before using it.
• Make sure that you replace your lter every three to six months to prevent bacteria growth.
• Replace your lter every three to six months to prevent bacteria and fungus growth in your lter, supply lines, and storage tank.
• Stored lters do not expire. Keep your unused lters in a cool, dark, and dry place until you need them.
• If you do not use your water dispenser for more than four days, run two gallons of water before using it to prevent bad tasting water.
ONE-YEAR LIMITED WARRANTY
For complete warranty, visit www.insigniaproducts.com.
CONTACT INSIGNIA
1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico) www.insigniaproducts.com
CERTIFICATIONS:
Tested and Certied by NSF International in Model
EFF-6011S against NSF/ANSI Standard 42 for the
REPLACEMENT
ELEMENT
INSIGNIA is a trademark of Best Buy and its aliated companies. Distributed by Best Buy Purchasing, LLC 7601 Penn Ave South, Richeld, MN 55423 U.S.A. ©2018 Best Buy. All rights reserved.
Made in China
reduction of chlorine, taste and odor.
V3 ENGLISH 18-0532
Loading...