Innotek ULTRASMART User Manual

INNO TEK®UltraSmart

™

Micro Remote Trainer

IUT-300,IUT-302

About your INNOTEK®UltraSmart™Remote Trainer

Now you can experience the difference a remote trainer can make. Spend less time training your dog. INNOTEK®training
products have just the right touch,right when you need it.INNOTEK

®

products are the quicker way to a better-behaved dog.

This handheld remote is small yet full-featured. You’re in
complete control of stimulation levels 1 through 9.There’s even a

Bbutton for when you need a little more persuasionwith the press

of a single button. The remote signals the electronic collar to
produce a harmless yet effective stimulation or tone.

The display shows at a glance which
level your remote is set on. You can
even train 2 dogs at once – the display
shows D or d to indicate which dog
you are controlling.

The UltraSmart™collar has been designed by professionals to
offer optimal training stimulation in a sleek,low-profile design.The
collar is packed with features including PerfectFit

™

, an indication

that the collar is fitted properly to your dog.

Collar charging stationplugs into any 110v wall outlet.The collar
fits in the cradle and charges the collar in just 2-3 hours. It’s an
attractive unit designed for use in your home.

You MUST charge

collar for 3 hours prior

to first use.

Important: Never leave the collar on the dog

for more than 12 consecutive hours.

See “Important Advice”, page 8.

Step 2 Turning the collar ON and OFF

Step 1 Power Up

Quick Start Guide IUT-300 & IUT-302

INNOTEK®UltraSmart™Micro Remote Trainer, 300 yards

Remote: Insert 12v alkaline battery in the handheld remote.

Replace the access panel.
Collar: Charge the collar on the po wer outlet-mounted charging

station.The light on the collar will glow red while charging, and green when fully charged.

a. Press theC button (for collar) on the remote once or

twice until D appears in the display.

b. Hold the collar one inch from the remote,taking care not

to touch the metal contacts that touch your dog’s skin.

c. Press thetbutton.The collar will emit a

start-up tone,and the light will glow solid green.

d. To turn collar OFF, hold collar and remote one inch apart and press thetbutton.The collar

will emit a shut-down tone, and the light will glow solid red, then go out.
NOTE: IUT-302 users,repeat the procedure with the second collar.
This ON/OFF command only works when remote and collar are in close proximity; it will not work

at a distance. Never turn the unit ON/OFF while your dog is wearing the collar.

1

When turning the collar ON, hold thetbutton for 3 seconds. The collar will go into PerfectFit

™

mode. The collar will emit a click tone as the contacts touch your dog’s skin.A proper fit will be
acknowledged with 5 consecutive click tones.

To skip the PerfectFit

™

test,just turn the collar ON by pressing thetbutton less than 3 seconds.

The collar will function normally,bypassing the PerfectFit™test.

Cinch the collar around your dog’s neck to find proper fit.The collar fit
should be snug, yet loose enough to allow one finger to fit between
the strap and the dog’s neck.Fit is important because a loose collar
may cause inconsistent performance.

Step 4 Adjust the Collar

2

Optional

Step 3

PerfectFit

™