Ingersoll-Rand 7759 User Manual
OPERATOR’S MANUAL
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE Released: 2-22-93
Tool & Hoist Products
“0” SERIES POWER MOTOR
Model 7759
IMPORTANT: READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT.
Revised:
OPERATING AND SAFETY PRECAUTIONS
Pneumatic tools should always be installed and used in accordance with A.N.S.I. 6186.1 “Safety Code For Portable Air Tools.”
CAUTION:
l
Keep hands and clothing away from rotating end of tool.
l
Wear suitable eye protection while operating tool.
l
Use tool only for purposes for which it was intended.
l
SHUT OFF and DISCONNECT AIR SUPPLY from tool BEFORE performing maintenance, service or disassembly of
tool.
WARNING: Repeated prolonged operator exposure to vibrations
which may be generated in the use of certain hand-held tools
may produce Raynaud’s phenomenon, commonly referred to as
Whitefinger disease. The phenomenon produces numbness and
burning sensations in the hand and may cause circulation and
nerve damage as well as tissue necrosis. Repetitive users of
hand-held tools who experience vibrations should closely monitor duration of use and their physical condition.
ROUTINE LUBRICATION REQUlREMENTS
Lack of or an excessive amount of lubrication will affect the performance and life of this tool. Use only recommended lubricants at
below time intervals:
EVERY 8 HOURS OF TOOL OPERATION - Fill lubricator reservoir of recommended F.R.L. with spindle oil (29665). If an in line or
air line lubricator is not used, apply several drops of spindle oil
(29665) in air inlet.
EVERY 160 HOURS OF TOOL OPERATION - Lubricate gearing. Pack bearings, coat shafts and lubricate gears with NLGI #1
“EP” grease (33153).
AIR SUPPLY REQUIREMENTS
For maximum operating efficiency, the following air supply specifications should be maintained to this air tool:
l
AIR PRESSURE - 90 PSIG (6 bar)
l
AIR FILTRATION - 50 micron
l
LUBRICATED AIR SUPPLY
l
HOSE SIZE - 5/16” (8 mm) I.D.
An ARO® model 128231-800 air line FILTER/REGULATOR/LUBRICATOR (F.R.L.) is recommended to maintain the above air
supply specifications.
RECOMMENDED LUBRICANTS
After disassembly is complete, all parts, except sealed or shielded
bearings, should be washed with solvent. To relubricate parts, or
for routine lubrication, use the following recommended lubricants:
Where Used ARO Part #
_____
Air Motor 29665
“0” Rings & Lip Seals
Gears and Bearings 33153
36460
Description
1 qt. Spindle Oil
4 oz. Stringy Lubricant
5 lb. “EP”’ - NLGI #1
Grease
For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand Distribution Center, White House, TN at PH: (615) 67220321, FAX: (615) 672-0601.
ARO Tool & Hoist Products
Ingersoll-Rand Company
1725 U.S. No. 1 North l PO. Box 8000 l Southern Pines, NC 28388-8000
©1993 THE ARO CORPORATlON • PRlNTED IN U.S.A.
PROFESSIONALTOOLS
Loading...