Indesit PI604GB User Manual
Operating Instructions
HOB
GB
English, 1
PI 604GB
Contents
GB
Installation, 2-3
Positioning
Electrical connections
Description of the appliance, 4
Overall view
Precautions and tips, 5
General safety
Disposal
Practical Advice on Using the Electric Hot Plates
Maintenance and care, 6
Switching the appliance off
Cleaning the appliance
Technical data
Assistance, 7
20
Installation
GB
! Before operating your new appliance please read this
instruction booklet carefully. It contains important
information for safe use, installation and care of the
appliance.
! Please keep these operating instructions for future
reference. Pass them on to possible new owners of the
appliance.
Positioning
! Keep packaging material out of the reach of children. It
can become a choking or suffocation hazard (see
Precautions and tips).
! The appliance must be installed by a qualified person
according to the instructions provided. Incorrect
installation may damage property or cause harm to
people or animals.
Built-in
The electric hobs are prepared with protection degree
against excessive heating of Y type, it is therefore
possible to instal them next to furniture which is higher
than the working board. For a correct installation of
the cooking top the following precautions must be
followed:
The hob may be located in a kitchen, a kitonen/
diner or bed sitting room, but no in a bathroom or
shower room.
Fastening Clamps - Assembly Diagram
30
Clamp Position for Clamp Position for
H=20mm top H=30mm top
Front
40
Clamp Position for Back
H=40mm top
! Use the clamps contained in the "accessory kit."
In case a wooden panel should be fitted under the
top for insulation, it will have be fitted at a minimum
distance of 20 mm from the inferior part of the top.
Ventilation
The hoods must be installed according to the
requirements in the hood handbook.
The dimensions of the cutout for the appliance must
be those indicated in the figure. Clamps are
provided to fasten the cooktop to counters
measuring from 20 to 40 mm in thickness. To fasten
the cooktop securely, it is recommended that all the
clamps be used.
555 mm
55 mm
475 mm
When installing the cooktop above a built-in oven, the
oven should be placed on two wooden strips; in the
case of a joining cabinet surface, remember to leave a
space of at least 45 x 560 mm at the back (see
picture).
45 mm.
560 mm.
When installing on a built-in oven without forced
ventilation, ensure that there are air inlets and outlets
for ventilating the interior of the cabinet adequately
(see picture).
2
Supply cable installation
The electrcic hobs are supplied without cable. Use a
cable:
H05 VV-F 3x2.5mm
2
Open the terminal box by removing the "V" screw
and taking off the cover.
GB
Electrical connection
The following installation procedure must be carried
out by a qualified electrician.
! the cooker must be connected to the mains by a
switched (double pole) cooker outlet correctly fused
with a capacity appropriate to that shown on the hob
Rating Plate. All electrical wiring from the consumer
unit to the appliance, via the switched double pole
cooker outlet, must be of an acceptable type and
current rating as above. The supply cord, type H05
VV-F 3x2.5mm
reaches at any point a temperature 50°C higher than
the room temperature. The electrical installation must
comply with the IEE Regulations, Building Regulation
& local By-Lays.
! THIS APPLIANCE MUST BE EARTHED.
In the case of installation over a built-in electric oven
the electrical hook-up of the stove top and that of the
oven should be separate, for reasons of safety as well
as for ease of eventual removal of the oven.
2
, must be positioned so that it never
The wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow - Earth E
Blue - Neutral N
Brown - Live L
Connect the wires in accordance with the following
diagram
32154
NL
Fix the cable in place with the "F" cable clamp,
close the lid and fasten it with the "V" screw (see
picture).
1
2
4
V
3
5
F
3
Loading...