YOUR SAFETY AND SAFETY
OF OTHERS IS VERY IMPORTANT.
This manual and the appliance
itself provide important safety
warnings, to be read and
observed at all times.
This is the safety alert symbol.
This symbol alerts you to
potential hazards that can kill
or hurt you and others.
All safety messages will follow
the safety alert symbol and
either the word DANGER or
WARNING. These words mean
:
DANGER
and electric shock resulting
from improper use of the
appliance. Carefully observe
the following instructions.
Failure to observe these instructions may lead to risks.
The manufacturer cannot be
held liable for any damage
resulting from failure to respect this guide.
The Manufacturer declines any
liability for injury to persons or
animals or damage to property
if the above advice and precautions are not respected.
Keep these instructions close
at hand for future reference.
Do not store explosive substances such as aerosol cans
and do not place or use gasoline or other ammable materials in or near the appliance.
Therefore, make sure the
refrigerant circuit pipes are not
damaged. Keep special attention in case of damaged pipes
emptying the refrigerant
circuit.
C-Pentane is used as blowing
agent in the insulation foam
and it is a ammable gas.
Do not damage the appliance
refrigerant circuit pipes.
WARNING
Do not use mechanical, electric
or chemical means other than
those recommended by the
Manufacturer to speed up the
defrost process.
WARNING
Indicates a hazardous situation
which, if not avoided, will
cause serious injury.
WARNING
Indicates a hazardous situation
which, if not avoided, could
cause serious injury.
All safety warnings give specic details of the potential risk
presented and indicate how to
reduce risk of injury, damage
4
When scrapping the appliance,
make it unusable by cutting o
the power cable and removing
the doors and shelves (if present) so that children cannot
easily climb inside and become
trapped.
This appliance does not contain CFCs. The refrigerant
circuit contains R600a (HC).
Appliances with Isobutane
(R600a): isobutane is a natural
gas without environmental
impact, but is ammable.
Do not use or place electrical
devices inside the appliance
compartments if they are not
of the type expressly authorised by the Manufacturer.
WARNING
Ice makers and or water dispencers not directly connected
to the water supply must be
lled with potable water only.
EN
WARNING
Keep ventilation openings, in
the appliance enclosure or in
the built-in structure, clear of
obstruction.
WARNING
Automatic ice-makers and/or
water dispensers must be
connected to a water supply
that delivers potable water
only, with main water pressure
between 0,17 and 0,81 MPa (1,7
and 8,1 bar).
To guarantee adequate ventilation, leave a space on both
sides and above the appliance.
The distance between the rear
of the appliance and the wall
behind the appliance should
be at least 50mm.
A reduction of this space will
increase the Energy consumption of product.
INTENDED USE
OF THE PRODUCT
This appliance is designed
solely for use as domestic
usage. To aim the appliance as
professional use is forbidden.
The manufacturer declines
allresponsibility for innapropiate use or incorrect setting of
the controls.
The appliance is not intended
to be operated by means of an
external timer or separate
remote control system.
Do not use the appliance
outdoors.
This appliance is intended to
be used in household and
similar
applications such as:
– sta kitchen areas in shops,
oces and other working
environments;
– farm houses and by clients in
hotels, motels and other residential type environments;
– bed and breakfast type
environments;
– catering and similar nonretail applications.
The bulb used inside the appliance is specically designed for
domestic appliances and is not
suitable for general room
lighting within the home (EC
Regulation 244/2009).
INSTALLATION
Only activate the appliance
when the installation procedure has been completed.
Installation and repairs must
be carried out by a qualied
technician, in compliance with
the manufacturer’s instructions
and local safety regulations. Do
not repair or replace any part
of the appliance unless specically stated in the user manual.
Use protective gloves to perform all unpacking and installation operations.
The appliance must be disconnected from the power supply
before carrying out any installation operation.
After unpacking the appliance,
make sure that it has not been
damaged during transport. In
the event of problems, contact
the dealer or your nearest
After-sales Service.
During installation, make sure
the appliance does not dam-
age the power cable.
The appliance must be handled and installed by two or
more persons.
When installing the appliance
make sure that the four feet are
stable and resting on the oor,
adjusting them as required,
and check that the appliance is
perfectly level using a spirit
level.
Wait at least two hours before
switching the appliance on, to
ensure that the refrigerant
circuit is fully ecient.
Make sure the appliance is not
near a heat source.
ELECTRICAL WARNINGS
Make sure the voltage specied on the rating plate corresponds to that of your home.
The power supply ranges are
indicated on the rating plate.
Regulation require that the
appliance is earthed.
For installation to comply with
current safety regulations, an
omnipolar switch with minimum contact gap of 3mm is
required.
If the power cable is damaged
it must be replaced with an
identical one. The power cable
must only be replaced by a
qualied technician in compliance with the manufacturer
instruction and current safety
regulations. Contact an authorized service center.
The electrical components
must not be accessible to the
user after installation.
5
The power cable must be long
enough for connecting the
appliance, once tted in its
housing, to the main power
supply.
Do not use extension leads.
Do not pull the power supply
cable.
Do not use multiple plug
adaptors if the appliance is
tted with a plug.
For appliances with tted plug,
if the plug is not suitable for
you socket outlet, contact a
qualied technician.
Do not touch the appliance
with any wet part of the body
and do not operate it when
barefoot.
ELECTRICAL CONNECTION
FOR GREAT BRITAIN AND
IRELAND ONLY
Fuse replacement.
If the mains lead of this appliance is tted with a BS 1363A
13amp fused plug, to change a
fuse in this type of plug use an
A.S.T.A. approved fuse to BS
1362 type and proceed as
follows:
Socket outlet / plug (valid for
both countries)
If the tted plug is not suitable
for your socket outlet, please
contact After-sales Service for
further instruction. Please do
not attempt to change plug
yourself. This procedure needs
to be carried out by a qualied
technician in compliance with
the manufactures instructions
and current standard safety
regulations.
CORRECT USE
Use the refrigerator compartment only for storing fresh
food and the freezer compartment only for storing frozen
food, freezing fresh food and
making ice cubes.
Do not operate this appliance
if it has a damaged mains cord
or plug, if it is not working
properly, or if it has been
damaged or dropped. Do not
immerse the mains cord or
plug in water. Keep the cord
away from hot surfaces.
When using a residual current
circuit breaker (RCCB), only use
a model marked with
.
The appliance is arranged for
operation in places where the
temperature comes within the
following ranges, according to
the climatic class given on the
rating plate.
The appliance may not work
properly if it is left for a long
time at a temperature outside
the specied range.
Climatic Class Amb. T. (°C)
SN From 10 to 32
N From 16 to 32
ST From 16 to 38
T From 16 to 43
1. Remove the fuse cover (A)
and fuse(B).
2. Fit replacement 13A fuse into
fuse cover.
3. Ret both into plug.
Important:
The fuse cover must be retted
when changing a fuse and if
the fuse cover is lost the plug
must not be used until a correct replacement is tted.
Correct replacement are identied by the colour insert or the
colour embossed in words on
the base of the plug.
Replacement fuse covers are
available from your local electrical store.
For the Republic of Ireland
only
The information given in
respect of Great Britain will
frequently apply, but a third
type of plug and socket is also
used, the 2-pin, side earth
type.
Avoid storing unwrapped food
in direct contact with internal
surfaces of the refrigerator or
freezer compartments.
Appliances could have special
compartments for food storage.
In case not dierently specied
in the specic booklet of
product, they can be removed,
maintaining equivalent performances.
Do not swallow the contents
(non-toxic) of the ice packs (in
some models).
Do not eat ice cubes or ice
lollies immediately after taking
them out of the freezer since
they may cause cold burns.
For products designed to use
an air lter inside an accessible
fan cover, the lter shall be
always in position when the
refrigerator is in function.
Do not store glass containers
6
EN
with liquids in the freezer
compartment since they may
break.
Do not obstruct the fan (if
available) with food items.
After placing the food check if
the door of compartments
closes properly, especially the
freezer door.
Damaged gasket must be
replaced as soon as possible.
CHILDREN SAFETY
Very young (0-3 years) and
young children (3-8 years) shall
be kept away unless continuously supervised.
Childern from 8 years old and
above and persons with reduced physical, sensory or
mental capabilities or lack of
experience and knowledge can
use this appliance only if they
are supervised or have been
given instructions on safe
appliance use and if they
understand the hazards involved. Children shall not play
with the appliance. Cleaning
and user maintenance shall not
be made by childern without
supervision.
Keep the packaging materials
(plastic bags, polystyrene
parts, etc.) out of reach of
children.
CLEANING
AND MAINTENANCE
The appliance must be disconnected from the power supply
before carrying out any cleaning or maintenance operation.
Never use steam cleaning
equipment
SAFEGUARDING
THE ENVIRONMENT
DISPOSAL OF PACKAGING
MATERIALS
The packaging material is
100% recyclable and is marked
with the recycle symbol:
The various parts of the
packaging must therefore be
disposed of responsibly and in
full compliance with local
authority regulations
governing waste disposal.
SCRAPPING OF
HOUSEHOLD APPLIANCES
This appliance is manufactured
with recyclable or reusable
materials. Dispose of it in
accordance with local waste
disposal regulations.
For further information on the
treatment, recovery and
recycling of household
electrical appliances, contact
your competent local
authority, the collection service
for household waste or the
store where you purchase the
appliance.
This appliance is marked in
compliance with European
Directive 2012/19/EU, Waste
Electrical and Electronic
Equipment (WEEE).
By ensuring this product is
disposed of correctly, you will
help prevent potential
negative consequences for the
environment and human
health, which could otherwise
be caused by inappropriate
waste handling of this product.
This symbol on the
product or on the
accompanying
documentation indicates that
it should not be treated as
7
domestic waste but must be
taken to an appropriate
collection centre for the
recycling of electrical and
electronic equipment.
ENERGY SAVING TIPS
Install the appliance in a dry,
well ventilated room far away
from any heat source (e.g.
radiator, cooker, etc.) and in a
place not exposed directly to
the sun. If required, use an
insulating plate.
To guarantee adequate
ventilation follow installation
instructions. Insucient
ventilation on back of the
product increases energy
consumption and decreases
cooling eciency.
The internal temperatures of
the appliance may be aected
by the ambient temperature,
frequency of door opening, as
well as location of the
appliance. Temperature setting
should take into consideration
these factors.
Reduce to a minimum door
opening.
When thawing frozen food,
place them in the refrigerator.
The low temperature of the
frozen products cools the food
in the refrigerator.
Allow warm food and drinks to
cool down before placing in
the appliance.
Positioning of the shelves in
the refrigerator has no impact
on the ecient usage of
energy. Food should be placed
on the shelves in such way to
ensure proper air circulation
(food should not touch each
other and distance between
food and rear wall should be
kept).
You can increase storage
capacity of frozen food by
removing baskets and, if
present, Stop Frost shelve,
maintaining an equivalent
energy consumption.
High energy class products are
tted with high eciency
motors that remain operational
for longer, but have a low
power consumption. Do not
worry if the engine continues
to run for longer periods.
DECLARATION
OF CONFORMITY
This appliance has been
designed for preserving food
and is manufactured in
compliance with Regulation
(CE) No . 1935/2004 .
This appliance has been
designed, manufactured and
marketed in compliance with:
› safety objectives of the “Low
Voltage” Directive 2006/95/CE
(which replaces 73/23/CEE and
subsequent amendments);
› the protection requirements
of Directive “EMC” 2004/108/
EC.
Electrical safety of the
appliance can only be
guaranteed if it is correctly
connected to an approved
earthing system.
8
Use and Care guide
14
12
13
PRODUCT
DESCRIPTION
APPLIANCE
1
2
3
4
5
11
7
8
9
6
10
EN
1. Electronic control panel / light
unit
2. Shelves
3. Rating plate with commercial
name
4. Fruits and vegetables crisper
5. Door reversibility kit
6. Door trays
7. Egg tray
8. Bottle separator (if present)
9. Bottle balcony
10. Door seal
Freezer compartment
10. Door seal
11. Freezer drawers
12. Shelves
13. Bottom drawer: coolest zone
best for freezing fresh food
14. Ice tray
9
CONTROL PANEL
A. Light bulb
B. Thermostat knob
C. Thermostat seeting
indicator
D. Light button
A
BC
D
10
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.