Indesit IFG63KABKGB User Manual

Please phone us on

08448 24 24 24

to activate your

guarantee

IF 63 K.A UK S IF 63 K.A IX UK S

English

Operating Instructions

OVEN

Operating Instructions,1 Warnings,2 Description of the appliance,3 Installation,4 Electrical Connection,5 Start-up and use,6 Modes,6 The electronic programmer*,9 Precautions and tips,10 Maintenance and care,10 Afetr Sales Service,12 Guarantee,13

Contents

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Warnings

WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass.

Never use steam cleaners or pressure cleaners on the appliance.

WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Description of the appliance

Overall view

1. POSITION 1

2. POSITION 2

3. POSITION 3

4. POSITION 4

5. POSITION 5

6. GUIDES for the sliding racks

7. DRIPPING PAN

8. GRILL

9. Control panel

9 6

Control panel

1. SELECTOR Knob

2. ELECTONIC Programmer*

3. THERMOSTAT Knob

4. Indicator light THERMOSTAT

* Only available in certain models.

1 2

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Installation

595 mm.

! Please keep this instruction booklet in a safe place for future reference. If the appliance is sold, given away or moved, please make sure the booklet is also passed on to

the new owners so that they may benet from the advice

contained within it.

Ventilation

To ensure adequate ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely

at surface with an opening of at least 45 x 560 mm (see

diagrams).

! Please read this instruction manual carefully: it contains important information concerning the safe operation, installation and maintenance of the appliance.

Positioning

! Do not let children play with the packaging material; it should be disposed of in accordance with local separated waste collection standards (see Precautions and tips).

! The appliance must be installed by a qualied professional

in accordance with the instructions provided. Incorrect installation may damage property or cause harm to people or animals.

Built-in appliances

Use an appropriate cabinet to ensure that the appliance operates properly:

• The panels adjacent to the oven must be made of heat-

resistant material.

• Cabinets with a veneer exterior must be assembled with

glues which can withstand temperatures of up to 100°C.

• To install the oven under the counter (see diagram) or in a kitchen unit, the cabinet must have the following dimensions:

45 mm.

560 mm.

Centring and xing

Secure the appliance to the cabinet:

• Open the oven door.

• Remove the 4 rubber plugs covering the xing holes on

the perimeter frame.

• Fix the oven to the cabinet using the 4 wood screws.

• Replace the rubber plugs.

! All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool.

547 mm. min.

23 mm.

5 mm.

595 mm.

545 mm.

24 mm.

45 mm.

560 mm.

575-585 mm.

567 mm.

! The appliance must not come into contact with electrical parts once it has been installed. The indications for consumption given on the data plate have been calculated for this type of installation.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

Electrical Connection

The electrical connection to the mains must be made on the appliance. The power voltage and frequency are as indicated on the rating plate.

! THIS APPLIANCE MUST BE EARTHED.

Fitting the power supply cable

1. Open the terminal board by inserting a screwdriver into the side tabs of the cover. Use the screwdriver as a lever by pushing it down to open the cover (see diagram) .

2. Install the power supply cable by loosening the cable clamp screw and the three wire contact screws

L-N- . Connect the wires to the corresponding terminals: the Blue wire to the terminal marked (N), the Brown wire to the terminal marked (L) and the Yellow/Green wire

to the terminal marked (see diagram).

Unplug the appliance before all operations, even when replacing the oven lamp. Using the appliance without correct earthing is highly dangerous.

! After connecting the appliance to the exible cable,

tighten all the screws on the terminal board.

APPLIANCE SPECIFICATIONS

width 43.5 cm

Dimensions*

Volume*

Dimensions**

Volume**

Electrical connections

height 32,4 cm depth 40.3 cm

57 l

width 45.5 cm height 32,4 cm depth 40.3 cm

60 l

voltage: 230-240V~ 50/60 Hz maximum power absorbed 2800-3000 W

Directive 2002/40/EC on the label of electric ovens. Standard EN 50304

ENERGY LABEL

Energy consumption for Natural convection – heating mode: Traditional mode

Declared energy consumption for Forced convection Class – heating mode: Baking

3. Secure the cable by fastening the clamp screw.

4. Close the cover of the terminal board.

Electrical Connection:

Voltage Frequency: see data plate Fuse Section: 16A

Supply cable: 3x1.5mm

You can connect your oven to the system means of a terminal board. Refer to above information for the minimal cable sections and the calibration of the protective elements according to the connection. If the appliance is installed with a junction box, an omnipolar circuit breaker - with a minimum contact opening of 3mm - should be installed between the appliance and the mains.

Power cable supply connection to the electrical mains:

We recommend you use a power supply cable which is long enough to allow you to take the oven out of its recess in the event of maintenance operations (only use HAR - H

05 - RRF quality cables tted with a plug conforming to the

regulations in force. The plug must be accessible at all times.

This appliance conforms to the following European Economic Community directives: 2006/95/EEC dated 12/12/06 (Low Voltage) and subsequent amendm ents –

* Only for models with drawn rails. ** Only for models with wire rails.

2004/108/EEC dated 03/05/89 (Electromagnetic Compatibility) and subsequent amendm ents 93/68/EEC dated 22/07/93 and subsequent amendm ents. 2002/96/EC and subsequent amendments.

- 1275/2008 standby/off mode

+ 11 hidden pages