INDESIT I6VV2A(W)/AUS User Manual
Operating Instructions
COOKER AND OVEN
AU
AU
English, 1
I6VV2A/AUS
Contents
WARNING, 2
Installation, 3-4
Positioning and levelling
Electrical connection
Technical data
Description of the appliance, 5
Overall view
Control panel
Start-up and use, 6
Starting the oven
Using the cooking timer
Cooking advice, 7-8
Oven cooking advice table
Using the glass ceramic hob, 9
Switching the cooking zones on and off
Cooking zones
Precautions and tips, 10
General safety
Disposal
Respecting and conserving the environment
Care and maintenance, 11
Switching the appliance off
Cleaning the appliance
Replacing the oven light bulb
Cleaning the glass ceramic hob
Assistance
WARNING
AU
WARNING: The appliance and its
accessible parts become hot
during use.
Care should be taken to avoid
touching heating elements.
Children less than 8 years of age
shall be kept away unless
continuously supervised.
This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance in
a safe way and understand the
hazards involved. Children shall not
play with the appliance. Cleaning
and user maintenance shall not be
made by children without
supervision.
The internal surfaces of the
compartment (where present) may
become hot.
Never use steam cleaners or
pressure cleaners on the appliance.
Remove any liquid from the lid
before opening it.
Do not close the glass cover (if
present) when the gas burners or
electric hotplates are still hot.
! When you place the rack inside,
make sure that the stop is directed
upwards and in the back of the cavity.
WARNING: Unattended cooking on
a hob with fat or oil can be
dangerous and may result in fire.
NEVER try to extinguish a fire with
water, but switch off the appliance
and then cover flame e.g. with a lid
or a fire blanket.
WARNING: Danger of fire: do not
store items on the cooking surfaces.
WARNING: If the surface in glassceramic is cracked, switch off the
appliance to avoid the possibility of
electric shock.
Do not use harsh abrasive cleaners
or sharp metal scrapers to clean the
oven door glass since they can
scratch the surface, which may
result in shattering of the glass.
2
HOOD
420
Min.
min.
650
mm. with hood
min.
700
mm. without hood
mm.
600
Min. mm.
420
Min. mm.
Installation
NL
! Before operating your new appliance please read
this instruction booklet carefully. It contains
important information concerning the safe installation
and operation of the appliance.
Please keep these operating instructions for future
!
reference. Make sure that the instructions are kept
with the appliance if it is sold, given away or moved.
! The appliance must be installed by a qualified
professional according to the instructions provided.
! Any necessary adjustment or maintenance must be
performed after the appliance has been
disconnected from the electricity supply.
Positioning and levelling
! It is possible to install the appliance alongside
cupboards whose height does not exceed that of the
hob surface.
! This cooker should be installed directly on! This cooker should be installed directly on
! This cooker should be installed directly on
! This cooker should be installed directly on! This cooker should be installed directly on
the floor. Do not install this cooker on anthe floor. Do not install this cooker on an
the floor. Do not install this cooker on an
the floor. Do not install this cooker on anthe floor. Do not install this cooker on an
artificial base of any kind.artificial base of any kind.
artificial base of any kind.
artificial base of any kind.artificial base of any kind.
! Make sure that the wall in contact with the back of
the appliance is made from a non-flammable, heatresistant material (T 90°C).
! Important: Do not install this appliance! Important: Do not install this appliance
! Important: Do not install this appliance
! Important: Do not install this appliance! Important: Do not install this appliance
adjacent to the door or other means ofadjacent to the door or other means of
adjacent to the door or other means of
adjacent to the door or other means ofadjacent to the door or other means of
access to minimise the likelihood of personsaccess to minimise the likelihood of persons
access to minimise the likelihood of persons
access to minimise the likelihood of personsaccess to minimise the likelihood of persons
using the door making contact with pans onusing the door making contact with pans on
using the door making contact with pans on
using the door making contact with pans onusing the door making contact with pans on
the hob surface.the hob surface.
the hob surface.
the hob surface.the hob surface.
Levelling
If it is necessary to level the
appliance, screw the
adjustable feet* into the places
provided on each corner of the
base of the cooker (
see figure
The legs* provided with the
appliance fit into the slots on
the underside of the base of
the cooker.
Electrical connection
Ovens with a three-pole power supply cable are
designed to operate with alternated current at the
supply frequency and voltage indicated on the data
plate (at the bottom of the oven dashboard). The
earthing conductor of the cable is the yellow-green
conductor.
Opening the terminal board:
••
• Using a screwdriver, prise
••
on the side tabs of the
terminal board cover;
••
• Pull open the cover of the
••
terminal board.
AU
).
To install the appliance correctly:
• Place it in the kitchen, dining room or the bed-sit
(not in the bathroom).
• If the top of the hob is higher than the cupboards,
the appliance must be installed at least 200 mm
away from them.
• If the cooker is
installed underneath a wall
cabinet, there must be a
minimum distance of
420 mm between this
cabinet and the top of
the hob.
This distance should be
increased to 700 mm if
the wall cabinets are
flammable (
see figure
• Do not position blinds behind the cooker or less
than 200 mm away from its sides.
• Any hoods must be installed according to the
instructions listed in the relevant operating manual.
To install the cable, proceed as follows:
••
• Remove the wire clamp
••
screw and the three contact
screws L-N-
• Fasten the wires beneath
the heads of the screws using
the following color scheme :
Blue (N) Brown (L) YellowGreen
• Fasten the supply cable in place with the clamp
and close the cover of the terminal board.
).
Connecting the supply cable to the mains
WARNINGS: THIS APPLIANCE MUST BEWARNINGS: THIS APPLIANCE MUST BE
WARNINGS: THIS APPLIANCE MUST BE
WARNINGS: THIS APPLIANCE MUST BEWARNINGS: THIS APPLIANCE MUST BE
EARTHED.EARTHED.
EARTHED.
EARTHED.EARTHED.
! The cooker must be connected to the mains by a
switched (double pole) cooker outlet correctly fused
with a capacity appropriate to that shown on the
3
AU
cooker Rating Plate. All electrical wiring from the
consumer unit to the cooker, via the switched double
pole cooker outlet, must be of an acceptable type
and current rating as above.
! the supply cable must be positioned so that it
never reaches at any point a temperature 50°C
higher than the room temperature. The cable must
be routed away from the rear vents.
x
y
HOT PARTS
Anti-tilt Wall Bracket
! In order to prevent accidental
tipping of the appliance, for
example by a child climbing onto
the oven door, the supplied "antitilt bracket" MUST be installed!
To install the Anti-Tilt Wall Bracket:To install the Anti-Tilt Wall Bracket:To install the Anti-Tilt Wall Bracket:
1. Fit the cooker between the cabinets and adjust the
height of the appliance (if necessary) by means of
adjustable feet.
2. Take out the lower compartment.
3. On the wall behind the cooker draw a line along
the horizontal edge A and then along the vertical edge
B so that the lines cross (see figures below).
4. Pull the cooker out of the space between cabinets
and attach the Anti-tilt Bracket with (its shorter arm
to the wall) in the position shown in the picture below:
37 mm left and 5 mm up from the crossing of the lines
A and B, inserting two bolts of 6mm diameter in the
holes: x and y.
5. Place the cooker back between the cabinets so that
the Anti-Tilt Wall Bracket fits inside the appliance.
6. Reinsert the lower compartment.
! The Anti-Tilt Wall Bracket may be installed both on the
! The Anti-Tilt Wall Bracket may be installed both on the
! The Anti-Tilt Wall Bracket may be installed both on the
left and on the right handside of the cooker.
left and on the right handside of the cooker.
left and on the right handside of the cooker.
TECHNI CAL D ATA
Oven dim ens i ons
(HxWxD)
Volume 60 l
Useful
measurements
relating to the oven
compartment
Power supply
voltage and
frequency
Electric hob
Front left
Back left
Back right
Fron t right
Maximum absorptio n
o f the el ectric hob
ENERGY LABEL
32x43,5x40 cm
width 42 cm
depth 44 cm
height 8,5 cm
see data plate
1700 W
1200 W
2100 W
1200 W
6200 W
Directive 2002/40 /EC on the
label of electric ovens.
Standard EN 50304
Energy consumpt ion for N atural
convection – heating mode:
Traditional mode;
Declared energy consumption
for Forced convection C lass –
heating mode: Fan assisted
EC Directives: 2006/95/EC
dated 12/12/06 (Low Voltage)
and subsequen t amendm ent s 04/108/EC dated 15/1 2/0 4
(Electroma gnet ic Compat ib ility )
and subsequen t amendm ent s 93/68/EEC dated 22/07/93 and
subsequent am endm ent s 2002/96/EC.
4
Description of the appliance
Overall view
Glass
ceramic hob
AU
Control panel
VARIABLE GRILL
Control panel
DRIPPING pan
Adjustable foot
THERMOSTAT
indicator light
knob
GRILL rack
COOKING TIMER*
knob
GUIDE RAILS
for the sliding racks
position 5
position 4
position 3
position 2
position 1
Adjustable foot
ACTIVE HOTPLATE
indicator light
SELECTOR
knob
ELECTRIC HOTPLATE
control knobs
5
Loading...