INDESIT CTAA 55 NF WD UK User Manual

CTAA 55 NF WD UK

Water dispenser instruction

7

11

13

14

15

REFRIGERATOR-FREEZER REFRIGERATOR-FREEZER

Plug replacement(UK&lreland only)

Should you need to replace the plug,the
wires in the power cable are colour in the
following way:
Blue - Neutral ’N’
Brown - Live ‘L’
Green&Yellow - Earth ‘E’
As the colours of the wires in the power cable
may not correspond with the coloured
markings identifying the terminals in your
plug,and proceed as follows:
The green&yellow wire must be connected to
the terminal in the plug that is marked with
the letter E or by the earth symbol.
The blue wire must be connected to the
terminal that is marked with the letter N.
The brown wire must be connected to the
terminal that is marked with the letter L.
If power supply cord is damaged,it must
replaced by the manufacturer or its service
agent or a similar qualified person in order to
avoid a hazard.

UNPACKING YOUR REFRIGERATOR­FREEZER
WARNING: Use two or more people to move

refrigerator-freezer.Failure to do so can result
in back or other injury.
Remove tape and any labels from your
refrigerator-freezer before using(except the
rating label).
To remove any remaining tape or glue, rub the
area briskly with your thumb.
Tape or glue residue can also be easily
removed by rubbing a small amount of liquid
dish soap over the adhesive with your fingers.
Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to
remove tape or glue. These products can
damage the surface of your refrigerator­freezer.
When moving the refrigerator-freezer, do not
tilt the refrigerator-freezer beyond 45°from
upright position

CLEANING BEFORE USE：

After you remove all of the packaging
materials, （especially the foam between
outside condenser and cabinet should be
removed）clean the inside of your refrigerator­freezer before using it.

the hinge side to allow for the door to swing
open.
Never install your refrigerator-freezer near
heat source and direct sun shins.

ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND
PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.

Failure to follow these instructions can result in
death, fire or electrical shock.
Before you move your refrigerator-freezer into
its final location, it is important to make sure
you have the proper electrical connection.

RECOMMENDED EARTHING METHOD

AC220-240Volt /50Hz ,AC only 10 ampere
fused and properly earthed electrical supply is
required. It is recommended that a separate
circuit serving only this appliance be provided.
Use a receptacle which cannot be turned off
with a switch or pull chain. Do not use an
extension cord.
NOTE: Before performing any type of
installation, disconnect the refrigerator-freezer
from the electrical source. When you are
finished, connect the refrigerator-freezer to the
electrical source and reset the control to the
desired setting.

3

SPACE REQUIREMENTS
WARNING: Keep flammable materials and

vapors, such as gasoline, away form
refrigerator-freezer.Failure to do so can result
in death, explosion, fine or burns.
To ensure proper ventilation for your
refrigerator-freezer, allow for 200mm space on
each side between walls, 200mm space
between back of your refrigerator-freezer and
the wall, and 300mm space between counter
top and the roof or ceiling.
If you are installing your refrigerator-freezer
next to a fixed wall, leave sufficient space on

LEVELING

If the refrigerator-freezer is not leveled during
installation. The doors may not close or seal
properly, causing cooling, frost, or moisture
problems. It is very important of the
refrigerator-freezer to be level in order to
function properly.
To level your refrigerator-freezer you may
either turn the adjustable foot clockwise to
raise that side to the refrigerator-freezer or turn
counter – clockwise to lower that side.
NOTE: Having someone push against the top
of the refrigerator-freezer, take some weight
off. This makes it easier to adjust the
adjustable foot.

4