Inateck WP1001 User Manual

WP1001
Wireless Presenter

Instruction Manual

www.inateck.com

WP1001 Wireless Presenter

Instruction Manual (EN)

I. Packing list

● WP1001*1

● USB Receiver*1

● Carrying Case*1

● Users manual*1

II. WP1001 Diagram

③

⑤

⑦ ⑧

① LED indicator
② LCD
③ Timer Set
④ Laser
⑤ Page Up
⑥ Page Down
⑦ Full Screen

①
②

④

⑥

⑨

⑩

⑪

⑫

⑧ Stop playing slides
⑨ USB Receiver
⑩ Volume + / Time +

⑪ Volume - / Time -
⑫ Laser
⑬ Power On / Off
⑭ Battery Cover

⑬

⑭

III. Specs

Product Name
Product Model
RF Frequency
RF Distance

Wavelength
Power Output

System Compatibility

IV. Features

● 2.4GHz wireless connection allows you to move freely while
presenting

● Red laser pointer works up to 65 feet (20m) away

● The multifunction feature and low-battery indicator

Wireless Presenter

Inateck WP1001

2.4GHz

65 ft. (20m)
650nm ± 5nm (Class II Laser Product)

< 1mW

Windows XP/Vista/7/8/8.1

V. Install Batteries

Slide to open the battery cover, and insert two
AAA batteries (not included) in the battery
compartment symbols (+ and -) marked inside.

Battery Notes:

● Make sure the ON/OFF switch is at the OFF position before
installing or replacing batteries.

● If the battery indicator is not full and laser indicator flashes under
normal operation, replace the batteries.

● Dispose of batteries promptly and properly. Do not burn or bury

them.

● Use only fresh batteries of the required size and type.

● Do not mix old and new batteries, different types of batteries
(alkaline or rechargeable), or rechargeable batteries of different

capacities.

● If you do not plan to use the presenter for a long time, remove the
batteries. Batteries can leak chemicals that can damage

electronic parts.

VI. Plug in the Receiver

1. Turn on your computer

2. Take out the USB Receiver, and plug the receiver into your

computer’s USB port.

3. Slide the ON/OFF switch to ON. Your presenter and receiver
automatically pair.

Note:

● Insert the receiver back into the presenter’s receiver slot when not

in use.

● If you do not plan to use your presenter for several minutes, slide

ON/OFF to OFF to save battery power.

VII. Set the Timer

1. Press and hold TIMER for 3 seconds until the LCD screen lights
blue. The minute digit flashes.

2. Press VOL+ or VOL- to set the minute.

3. Press << or >> to move between the hour or minute digit. Press
VOL+ or VOL- to set the hour.

4. Press TIMER to confirm and exit the timer setting.

Note:

● The presenter vibrates to let you know when you have 5 minutes,
1minute, and no time remaining. The LCD screen turns off when you

have no time remaining.

● Press and hold TIMER for 3 seconds to enter the timer setting

again to reset the timer.

VIII. Troubleshooting

If you have difficulty pairing your presenter with your computer:

● Make sure you have properly installed fresh batteries.

● Pair the presenter and receiver again:

1. Place the presenter within 12 inches (30.5cm) of the receiver.

2. Slide the ON/OFF switch to ON.

IV. Care and Maintenance

● Use and store the presenter only in room temperature

environments.

● Keep the presenter dry; if it gets wet, wipe it dry immediately.

● Keep the presenter away from dust and dirt, and wipe it with a
damp cloth occasionally to keep it looking new.

● Handle the presenter carefully; do not disassemble or drop it.

(Service me: Mon - Fri 9:00AM - 5:00PM CET)

Tel: [phone]

Email: [e-mail]

Website: Hp://www.inateck.com