Inateck KT2001 Instruction Manual
Instruction Manual
English · Deutsch · 日本語
KT2001 USB 3.1 PCI-E Card
1
Chapter 1: Introduction
1.1 Product Introduction
KT2001 brings your computer two ports. One is USB Type A and the other is USB Type C.
The speed of data transmission can reach 10Gbps, the standard of USB3.1, which is faster
than the speed of USB3.0 standard. KT2001 is also downwards compatible with USB3.0
and USB2.0. It is convenient to use the Type C port as it supports both positive and
negative plug.
Product schematic
1.USB3.1 Type A Port
2.USB3.1 Type C Port
3.Power Input of Chassis（15pin）
4.PCI-E Card Slot
5.Screw Socket
6.Side Face of Chassis
1 2
4
3
6
5
English
1.2 Features
•Fit for any motherboard with PCI-E x4 x8 x16 slot , simple and easy to install and use.
•Minimal list design, fit with all kinds of USB devices, your ideal option for USB port
expansion.
•Expand two USB3.1 ports for you, data transfer speed of which reaches up to 10Gbps.
•Support external power adapter(15Pin) for power supply.
1.3 Package Contents
•1 x USB 3.1 PCI-E Card
•1 x Installation screws
•1 x 4 Pin to 15 Pin SATA Power Cable
•1 x Drive disk
•1 x User Manual
Chapter 2: Getting Started
2.1 Hardware Installation
1. Turn o the power to your computer.
2. Unplug the power cord and remove your computer’s cover/side panel.
3. To install the card, carefully align the card’s bus connector (golden portion) with the
selected PCI-E slot on the motherboard. Push the card down rmly.
4. It is mandatory step to connect the power cord of the computer to the SATA power
port of the card.
5. Use the included screw (or the screw from the slot bracket) to secure the card to the
case.
6. Replace the computer cover/side panel and reconnect the power cord.
3
2.2 Driver Installation
Normally the driver will be automatically installed on Windows OS when the card is
installed, and user can use it without further operation. Suppose that driver is not installed
automatically, please do that with the provided CD, or you can download driver from our
ocial site http://www.inateck.com/support
Note
Please make sure the hardware (card) is installed before installing the driver.
Once you have nished installing the drivers, you must restart your computer.
Chapter 3: Troubleshooting Tips
• If the card or devices connected to the computer do not seem to be working properly,
please perform the following basic troubleshooting steps:
1. Check that all cables are securely connected in the proper places.
2. Make sure the USB device’s power is turned on.
3. Make sure the PCI-E card is properly installed and is connected to power.
4. Make sure there is no problem with the card installation.
• If your computer fails to start after installing the USB 3.1 PCI-E card:
1. Turn o the computer, remove the USB 3.1 PCI-E card, and try restarting the computer.
2. If the computer starts successfully, it means the card is not inserted into the PCI-E slot
correctly. Please clean the golden PCI-E connector on the card using a soft brush, soft
rubber, or a cotton swab. If this does not resolve the issue, try changing to a dierent
PCI-E slot.
• Is it possible to connect current USB 3.0 or USB 2.0 devices to the USB 3.1 PCI-E card?
Yes. Devices will not obtain the USB 3.1 data transmission speeds but are fully compatible.
Loading...