Impex TPL-48 User Manual

MARCY® AEROBIC REBOUNDER

MODEL TPL-48

IMPORTANT SAFETY NOTICE

1. DO NOT leave children unattended with the equipment.

2. Do not position the equipment over concrete, asphalt, packed earth, or any other hard surface. This equipment is
intended to use indoor.

3. Position the equipment on a clear, leveled surface. Make sure the surfaces are free of objects that may cause
tipping over.

4. Always wear appropriate workout clothing when exercising.

5. Disabled person should not use the equipment without a qualified person or physician in attendance.

6. Never use the equipment if it is not functioning properly.

7. Before exercising, always do stretching exercises to properly warm up.

8. Maximum user weight is 250 lbs.

9. If the user experience dizziness, nausea, chest pain, or any other abnormal symptoms,
STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.

Care and Maintenance

1. Periodically inspect all parts for tightness and tighten as required.

2. Replace any worn and damaged part immediately.

3. Use mild household spray cleaners and/or a damp rag to wipe clean. Do not use harsh cleaning
chemicals.

4. Sand rusted areas on tubular members and repaint using a non-lead based paint meeting the
requirements of Title 16 CFR Part 1303.

5. Disposal Instructions – The equipment can be safely disassembled and disposed without unreasonable
hazards. Call your local recycle agency regarding details of recycling.

Save the Instructions.

WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR PHYSICIAN. THIS IS
ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF 35 OR PERSONS WITH PRE­EXISTING HEALTH PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS
EQUIPMENT. IMPEX INC. ASSUMES NO RESPONSIBIL ITY FOR PERSONAL INJURY OR PROPERTY
DAMAGE SUSTA INED BY OR THROUGH THE USE OF THIS PRODUCT.

SAVE THESE INSTRUCTIONS.
Impex Fitness Products
14777 Don Julian Road
City Of Industry, CA 91746

Phone: [phone]
Fax: [phone]
Email: [e-mail]

06-10-08

ASSEMBLY INSTRUCTION

Step-1

Turn the Jumping Surface (#1) over. There are
plastic caps covering the threaded connector
where the Legs will mount on.
Remove these caps and discard.

Step-2

Insert the Leg (#2) through the sleeve on

the Handrail Support (#3), and then
firmly thread the Leg onto the
threaded connector.

Skip the next open connector and repeat

same procedure to mount the other
Balance Bar Support and Leg onto
the 3rd open threaded connector.

Step-3

Firmly thread the other six Legs (#2) onto

the remaining six open threaded
connectors.