INTRODUCTION
Thank you for choosing a I Luv coffee machine! We are sure that your new machine will meet with your
satisfaction. The I Luv Coffee machines are designed and manufactured to the most up-to-date processes
in compliance with stringent quality standards in order to provide reliable and durable service. Please read
the instructions for use contained in this brochure very carefully. By following them, you will be able to
take advantage of all the capacities of your machine, and ensure that it has a long and trouble-free working
life. Lastly, we would like to remind you that the reneka network is at your disposal for any information you
might need and for the maintenance of your reneka coffee machine.
TECHNOLOGY
Our aim
We have used the best materials and processes to ensure
customer’s satisfaction.
Heat exchange system
The system for instant heating of the cold water with which the coffee is made uses a special process
which guarantees quality and reliability.
Internal design
The machine is continuously ventilated, regardless of the number of cups on the cup tray. It provides
thermal protection to the electronic system and the pump unit.
Electronic
The electronic system performs most of the controls.
RECOMMENDATIONS
Only I Luv Coffee's After Sales Service or its distributor are authorized to carry out the servicing of I Luv
Coffee machines.
Please post this notice next to your machine. It will thus be readily available for consultation by users as
need be.
I Luv Coffee declines all responsibility for any damage that may arise as a result of failure to maintain the
machines as need be, of inappropriate operations on the machine, or from the use of non-reneka parts.
I Luv Coffee reserves the right to carry out any desirable modification without notice so as to update the
product to meet market requirements or make technical improvements.
SECURITY
During installation of the machine, check that the cup holder is at a minimum height of 1,20 meter above the ground
The machine should be placed on a horizontal surface, enough stable and sturdy to bear its weight, in a sufficiently
ventilated atmosphere, so that there is no danger from the humidity caused by the machine.
Leak enough space around the machine so that air circulates around it.
Air admission louvers of the machine should not be obstructed by towels etc.
The supply cable should not be in contact with the source of heat nor should it be hanging from the surface on which the
machine is placed nor be crushed by the machine.
Do not immerse all or even part of the machine.
Do not place the machine in an area where there may be projections.
Set the ON/OFF machine on “O” (Off) before moving the machine and before plugging it out.
Leave the machine to cool down and plug it out before taking on any repairs on the machine.
Do not use the machine for any other use except for that for which it is meant.
If the power cord is damaged, it must be replaced by our after-sales service or persons with similar qualifications, to avoid a
potential danger.