OPERATIONAL INSTRUCTIONS
3 | iLuv
iLuv | 4
i720 | V10M10_IM_EN_03282008
GETTING STARTED
Authentication of your iPod
In order to support a variety of iPod models, the i720 has an authentication procedure
that takes a few moments to complete. During this procedure, bars will appear on the
LCD screen in increasing number (see image below) until complete. Authentication is
finished when the bars disappear.
Connecting the Earphones and your iPod
1. Plug the 3.5mm plug into the headphone jack
as shown here.
2. With the 30pin connector attached to your iPod,
attach the mini USB plug to the mini USB jack on
the i720 as shown.
Bluetooth Functions
Pairing Mode
1. Press and hold MULTI-FUNCTION button for approximately five (5) seconds.
2. The Bluetooth symbol on i720 LCD will flash repeatedly and a confirmation “double
beep” will sound.
3. If your mobile phone is equipped with Bluetooth wireless technology, follow the
directions on your mobile phone to set it to SEARCH mode.
4. Your phone will find the i720 and will identify it on the LCD screen. To confirm, press
YES or OK.
5. When asked for a PIN code or number, enter “0000,” (four zeros) and press YES or OK
to confirm.
6. Your mobile phone is now successfully paired with i720. Bluetooth symbol light remain
on steadily.
Call Accept / End / Transfer / Reject
1. Press the MULTI-FUNCTION button once when call is incoming to answer the call.
Press again to end the call. The unit has a built in microphone so the caller can hear you.
2. To transfer a call, press and MULTI-FUNCTION button for three (3) seconds during
call activating.
3. To reject a call, press PREV / RW button when call is incoming.
Voice Dialing
Press the MULTI-FUNCTION button when there is no incoming call or call in progress in
order to dial.
Note: You can only dial a call using voice dialing if your Bluetooth mobile phone supports
voice dialing.