Ikegami ICD-E11, ICD-E11_ACDC User Manual

TROUBLESHOOTING

WARRANTY CARD

FEATURES

1. When the image does not appear on the screen, check the power source for the monitor and camera.
Make sure that the voltage and polarity are properly connected and correctly supplied.

2. When the image is too dim, check if the lens is stained.
If dirty, clean the lens with a clean soft cloth. If clean, adjust the back focus of the lens.

3. When the camera does not work properly, the camera housing is too hot or black lines appear on the screen,
check if you have connected the camera to a proper power source. If there is no problem with
the power connection, turn the camera off immediately and contact our service department for assistance.

4. When the screen blinks too much, check if the camera is facing directly toward the sun or a fluorescent light.
If so, adjust the angle or location of the camera.

User's Manual

MINI CORNER MOUNT
CAMERA

1/3"SonySuperHADIICCD

WARRANTY

1. Products are supplied with 3 year limited warranty from the date of purchase.
We will repair or replace the defective item with a new or factory rebuilt replacement.

2. Transportation of the product to our service center is the responsibility of the user.
Repaired or replaced product will be returned prepaid during the warranty period.

3. This warranty applies to the original purchaser only.

4. This warranty will be invalid if unauthorized repair or modifications are made to the unit or in any
case of accident, misuse or damage caused by improper installation or altered serial numbers.

5. The liability of the company has limited the cost of repair/replacement of the unit under warranty.

6. If you need warranty service, please return the product to your distributor/dealer.
Proof of pruchase may be required.

PRODUCT NAME

DATE OF PURCHASE
WARRANTY DATE

ADDRESS OF CUSTOMER

CONTACT

- Please read the instruction manual again before asking for the A/S

- Please explain exacity what the problem you have is,

/ DAY /M /Y

NAME

TEL

NAME

AGENT

TEL

WARRANTY YEAR

3 YEAR

ICD-E11

ROHS 3-AXIS

High Resolution 630TV Lines

-

Fixed Board Lens (Options)

-

Corner Mount Camera (IP66)

-

0 Lux for Infrared Lighting Conditions

-

Ikegami Electronics (U.S.A.), Inc.
37 Brook Avenue, Maywood, N. J. 07607-1195
ph: [phone] fax [phone]
[URL: www.ikegami.com]

DAY & NIGHTBoard Lens

SETTING & INSTALLATION

Sensor

1/3 Sony Super HADII CCD

Caution : Please Use Regulated DC 12V

SPECIFICATIONS

ITEM NTSC PAL
Total Pixels 811(H) x 508(V) 795(H) x 596(V)
Effective Pixels 768(H) x 494(V) 752(H) x 582(V)

Scanning System 2:1 Interlace
Frequency

Resolution More than 630 TV Lines
Video Output 1.0Vp-p Composite Signal ( 75ohm )
AGC
S/N (Y signal)
Min.Illumination

E

White Balance

L

Electronic shutter speed 1/60s - 1/100,000s 1/50s - 1/100,000s

E
C

3D-DNR ON

T

D&N Selection EXT

R

BLC OFF

I

D-WDR OFF

C

HLM OFF

A

Defect Pixel Compensation

L

IR SMART OFF
Motion Detection OFF
Privacy Masking OFF
MIRROR OFF

SHARPNESS OFF
IR LEDs 6 IR LEDs
Lens Mount 2.97mm Fixed Board Lens
Operating temperatur e/Humidity -10℃~+50℃ / 0~80% RH
Power Supply DC12V 110mA (CDS O N : 170mA)
Dimensions 120(H) x 120(W) x 90(D)mm
Weight Appx. 320g

"

Horizontal :15.734KHzVertical : 59.94Hz Horizontal :15.625KHzVertical : 50.00Hz

ON

52dB or more (AGC OFF)

0 Lux for Infrared Lighting Conditions

ATW

OFF

<DIMENSION>

[ Unit : mm ]

CONNECTOR ACCESSORIES

!

When you install the

camera, please glue up the

end of cable to keep it

stable in order to protect the

camera from the humidity

problems.

▶L-Wrench

▶Screw for fixing