iHV317 - QSG (English Only)
Size: 260 x 160mm
Front
Cover
Front CoverBack Cover
FCC Information
FCC ID: EMOIHV317
This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
• Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT SAFETY INSTRUCTIONS
When used in the directed manner, this unit has been designed and manufactured to ensure your
personal safety. However, improper use can result in potential electrical shock or fire hazards. Please
read and follow all safety and operating instructions carefully before installation and use, and keep
these instructions handy for future reference. Take special note of all warnings listed in these instructions
and on the unit.
Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl,
kitchen sink, laundry tub, swimming pool or in a wet basement.
Cleaning – The unit should be cleaned only with dry cloth. Do not use solvents, etc
Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or
other appliances (including amplifiers) that produce heat.
Only use attachments/accessories specified by the manufacturer.
Damage Requiring Service – The unit should be serviced by qualified service personnel when:
A. the power supply cable or plug has been damaged.
B. objects have fallen into or liquid has been spilled into the enclosure.
C. the unit has been exposed to rain.
D. the unit has been dropped or the enclosure damaged.
E. the unit exhibits a marked change in performance or does not operate normally.
Attention should be drawn to the environmental aspects of battery disposal.
No naked flame sources, such as lighted candles, should be placed on this product.
This product is suitable for use in tropical and/or moderate climates.
CAUTION – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.
Do not dispose of batteries in the household trash or fire
Quick Start Guide
Color Changing Wireless Speaker
Model: iHv317
What’s Included:
• iHv317 Speaker
• USB Charging Cable
For warranty information:
visit https://www.ihome.com/support
Printed in ChinaiHv317_022519-A
iHV317 - QSG (English Only)
GETTING STARTED
Charging your speaker
USB charging
cable (included)
Speaker must be charged before use.
• Connect small plug of USB charging cable to USB port and
connect the other end to a powered USB adapter.
• LED indicator will glow red while charging and turn o once charged.
• Speaker should provide about 3-4 hours of audio when fully charged.
• When battery is low, 3 tones will sound every 10 seconds until the unit shuts o.
USB AC
adapter
(not included)
Basic Controls
Power Button
Press and hold to turn ON/OFF
Play/Pause
• Short press
play/pause/resume audio
• Press and hold
manual Bluetooth pairing
Plus Button Minus Button
• Short press
next track
• Press and hold
increase volume
Light/Speakerphone
• Short press
cycle through light modes
• Short press
answer/end calls
• Press and hold
decline incoming call
• Short press
restart track
• Short press x2
previous track
• Press and hold
lower volume
Questions? Visit www.ihome.com
or call 1-800-288-2792 Toll Free
BC
LED INDICATORS
LED Indicator
Charging LED (red) Pairing LED (blue)
solid = charging
OFF = fully charged
flashing = pairing
solid = connected
slow flash = playing audio
BLUETOOTH
Pairing establishes a unique communication connection between your Bluetooth
device and the speaker. Once paired, you will be able to stream audio wirelessly to
your iHv317 speaker.
The speaker will enter auto-pairing mode whenever you turn it ON. The LED
1.
indicator on the back of the speaker will flash blue.
Turn on Bluetooth mode on your device (under Settings, Connections or similar).
2.
iHv317
3. Select “iHv317” on your device’s menu of Bluetooth devices. When
pairing is successful, the LED will glow solid blue. You can now
begin to stream audio and calls from your device. To conserve the
battery, remember to shut o the speaker when you are done
listening.
SPEAKERPHONE
Press the Light/Speakerphone Button to answer or end a call.
Press and hold the Play/Pause Button to decline a call.
AUX MODE
Connect one end of an audio cable (not included) into the AUX-IN jack
and the other end to the headphone jack of your audio device.
• Press PLAY on your audio device to start playback.
• Control/navigate tracks from your audio device, too.
• Press the Play/Pause Button on the speaker to mute audio.
• Unplug the audio cable to resume Bluetooth audio operation.
RESET
To reset the unit, insert the extended tip of a paper clip or other thin tool
into the AUX-in jack.
Back CoverInside page