Ihome IHV210 User Manual

FCC Information

FCC ID: 2AEPRIHV210

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of

the device.

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

IMPORTANT SAFETY INSTRUCTIONS

When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read and follow all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit.

Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.

Cleaning – The unit should be cleaned only with dry cloth. Do not use solvents, etc Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or

other appliances (including amplifiers) that produce heat. Only use attachments/accessories specified by the manufacturer. Damage Requiring Service – The unit should be serviced by qualified service personnel when:

A. the power supply cable or plug has been damaged. B. objects have fallen into or liquid has been spilled into the enclosure. C. the unit has been exposed to rain. D. the unit has been dropped or the enclosure damaged. E. the unit exhibits a marked change in performance or does not operate normally.

Attention should be drawn to the environmental aspects of battery disposal.

Quick Start Guide

Wireless Stereo

Headphones

Model: iHv210

What’s Included:

• Wireless Stereo Headphones with on-ear controls

• USB Charging Cable

For warranty information: visit https://www.ihome.com/support

GETTING STARTED BL

Charging your headphones

Headphones must be charged before use.

• Connect small plug of USB charging cable to USB port and connect the other end to a powered USB port.

• Indicator will glow red while charging and turn off once charged.

• Headphones should provide about 4 hours of audio when fully charged.

Basic Controls

Raise Volume/Forward Button

• Short press next track

• Press and hold increase volume

Lower Volume/Reverse Button

• Short press previous track

• Press and hold

decrease volume

LED Indicator

MultiFunction Button

• Press and hold 3-4 seconds power headphones ON or OFF

• Short press play/pause/resume audio

• Short press answer/end calls

USB charging

port

Microphone

Printed in ChinaiHv210-052918-A

Aux-in jack

Questions? Visit www.ihome.com or call 1-800-288-2792 Toll Free

UETOOTH

Pairing establishes a unique communication connection between your Bluetooth device and the headphones. Once paired, you will be able to stream audio wirelessly to your iHv210 Headphones.

1 The FIRST TIME HEADPHONES ARE POWERED ON they enter

3-4s

auto-pairing mode. The LED indicator on the earcup will flash blue and red and a voice will announe “Power on” and “Pairing”.

2 Turn on Bluetooth mode on your device (under Settings,

Connections or similar)

iHV210

3 Select “iHv210” on your device’s menu of Bluetooth devices.

When pairing is successful, a voice will announce “Your device is connected”, a tone will sound and the LED indicator slowly flashes blue. If prompted for a password, enter “0000” on your device. You can now begin to stream audio and calls from your device.

SPEAKERPHONE

Press the MultiFunction Button to answer or end a call.

AUX-IN

To use the headphones as a wired device, connect a standard 3.5 mm stereo audio cable (not included) to the aux-in jack located on the bottom of the left ear cup and connect the other end to the headphone jack on your audio device. NOTE: While using Aux-in, Bluetooth connection is disabled and media playback and volume adjustment must be controlled using your audio device.