iHome iHMP5 User Manual

Model iHMP5

Headphone

Speaker System

Questions? Visit www.ihomeaudio.com

Headphone Mode

In headphone mode, privately enjoy full rich sound in comfort with noise
isolation padding.

1. Connect the plug at the end of the headphone cable to the headphone or
audio out jack on your audio device. Make sure audio device is turned on.

2. Turn the volume knob to adjust the volume. You may also want to adjust
the volume on your audio device for the best sound level.

CAUTION: Avoid using headphones near magnets, including magnetic
jewelry such as earrings, bracelets or necklaces, as the magnetic speaker
switch could be activated, resulting in an abrupt unwanted increase in volume.

Speaker Mode

In speaker mode, a magnetic proximity switch activates the battery preamp to kick up the output for listening
at room volume.

Step 1

1. Connect the plug at the end of the headphone cable to the headphone or audio out jack on your audio
device. Make sure audio device is turned on.

2. Turn the headphone cups so they are facing up when on a flat surface.

3. Press the square switch on the bottom of one cup (near the headphone cable) into the square switch socket
on the other. The red power LED will light up when the connection is complete.

4. Tune the volume knob to adjust the volume. You may also want to adjust the volume on your audio device
for the best sound level.

NOTE: Separate phone cups/break the connection when not using as speakers to avoid draining the batteries.

Step 2

Controls and Indicators

Step 3