iHome IH-H400AB User Manual
FCC Statement
This device complies with part 15 of FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation. This equipment has been tested and
found to comply with the limits for a Class B digital device,
pursuant to part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference
when the equipment is operated in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instruction guide, may cause harmful interference
to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and the •
receiver.
Connect the equipment into an outlet on a circuit different •
from that to which the receiver is connected.
Consult a service representative for help.•
Properly shielded and grounded cables and connectors must
be used in order to comply with FCC emission limits. LifeWorks
is not responsible for any radio or television interference
caused by using other than recommended cables and
connectors or by unauthorized changes or modications to this
equipment. Unauthorized changes or modications could void
the user’s authority to operate the equipment.
Responsible party:
LifeWorks Technology Group LLC
1412 Broadway, New York, NY 10018
Tested To Comply With FCC Standards
FOR HOME OR OFFICE USE
Warning Improper setup, use and care of this product can
increase the risk of serious injury, death or device damage.
Read and keep this guide and all other printed guides for future
reference. For updated guides or replacements, go to
www.life-works.com
Do Not Attempt Repairs Do not attempt to take apart,
open, repair, service or modify the device(s). Doing so may
risk electric shock or other hazard. Evidence of any attempt to
open or modify the device, including any peeling, puncture or
removal of labels, will void the Limited Lifetime Warranty.
Printed in China
© 2008 LifeWorks Technology Group LLC.
iHome™ is a trademark of SDI Technologies Inc. used under license.
Windows Vista
Mac
All other brands and logos are trademarks of their respective companies.
®
is a registered trademark or trademark of Microsoft Corporation in the United States and/or other countries.
®
is a trademark of Apple Inc., registered in the U.S. and other countries.
Headset Warning
Extended exposure to high volumes may result in temporary or
permanent hearing loss.
technical support
for technical support please visit
www.life-works.com
or call (877) LIFE-540 (877-543-3540)
lifetime warranty
for warranty information, please visit
www.life-works.com/warranty
IH-H400AB
LifeTalks™
basic headset
quick start guide
Congratulations on the purchase of your new
LifeTalks basic headset.
This product comes with a limited lifetime warranty.
Before using your product, please thoroughly read and follow the
instructions inside this guide.
If you still need help, see the back page for other support options.
If you want to know more about our products, visit us online at
www.life-works.com.
system requirements
3.5 mm (1/8”) headphone •
output and microphone input
document version number 0811-0
for model number(s)
IH-H400AB
setup
quick start guide
VOLUME
MIC
MUTE
ON
volume control
microphone mute switch
noise canceling
microphone
adjustable
boom
1•
verify package contents
quick start guide
(in your hands right now)
To adjust the volume on your computer:
Windows
®
XP
Click the volume control in the system tray.
You can also adjust the volume by clicking Start > Control Panel > Sounds, Speech,
and Audio Devices.
Windows Vista
®
Click the volume control in the system tray.
You can also adjust the volume by clicking Start > Control Panel > Hardware and
Sound, then clicking Adjust system volume under Sound.
®
Mac
OS X
Click the volume control on the menu bar.
LifeTalks basic headset
2•
connect headset to computer
Plug the green connector into the 3.5 mm (1/8”) headphones output. Plug the pink
connector into the 3.5 mm (1/8”) microphone input.
3•
adjust headset and microphone volume
You can adjust the headset volume on your computer or
using the volume control on the headset cable. You can
also adjust the microphone volume on your computer.
Mute the microphone by using the switch on the headset cable. You can also mute the
microphone using the volume controls on your computer.
You can also adjust the volume by clicking the Apple menu and choosing System
Preferences, then clicking Sound.
4•
start using your new headset!
troubleshooting
situation try this
cannot hear
audio
microphone
does not
work
Ensure the green headphone connector is inserted properly into the •
headphone output.
Ensure the volume on your computer is not muted and the •
headphone volume is adjusted so it is high enough to hear.
Ensure the pink microphone connector is inserted properly into the •
microphone input.
Ensure the microphone volume on your computer is not muted and •
the microphone volume is properly adjusted.
Loading...