Igo MY WAY, HUNGARY 2005 User Manual

Quick Start Guide

iGO GPS navigation software

Thank you for choosing iGO as your in-car
navigator. The SD card version of the program is
very easy to use. You only need to plug the card into
your PDA. A simple setup procedure will run
automatically, and later on inserting the card into the
PDA will automatically start iGO and removing it
will exit the program (without losing any data).

2.

Plug & Go – as simple as that

Contents of this manual:

•_What's in the box?

•_What's on the SD card?

•_Automatic setup

•_How to start the setup manually

•_Ready to navigate

•_•_The first steps if you have no GPS

•_•_The first steps if you have a GPS

•_•_•_Automatic GPS detection

•_•_•_Manual GPS configuration

•_Out on the road

What's in the box?

Unpacking the iGO Hungary 2005 | SD™ you
will find a preprogrammed SD card and this printed
Quick Start Guide. That is all you need to use iGO.

What's on the SD card?

The iGO SD card contains everything you need to
use the system. There is no need for additional
downloads from the Internet, product registration
or other time consuming and/or infrastructure
demanding procedures. You can start using iGO
wherever you are. Right out of the box, in just
seconds.

The contents of the SD card:

•_iGO application (no further registration needed)

•_Autorun facility to let you run iGO by simply

•_inserting the SD card

•_Detailed map of your region with cities, postal

•_codes, streets, house numbers and thousands of

•_POI (Points of Interest)

•_The electronic format of this Quick Start Guide

•_The detailed iGO User Manual

Automatic setup

Installing iGO is really simple. All you need to do is
plug the SD card into your PDA and the setup
procedure will start automatically*. It will perform all
the necessary actions for you. You need only do this
once for each PDA you intend to use iGO with, then
iGO will start and quit automatically as you insert or
remove the SD card.

* Some PDA models prevent the installation from running

automatically. In this case follow the instructions in 'How to start
the setup manually'

3.

To complete the one time setup you need to do
the following:

•_If you already have a GPS device at hand, connect
it to your PDA before starting the setup.

•_Insert the iGO SD card into your PDA.

•_In the next screen read carefully and Accept the
End User License Agreement or Cancel the
installation if you do not agree with the conditions
and limitations.

Note: the Accept button remains disabled until you reach the last
page of the agreement.

•_After a few seconds the first screen of the setup
program appears. Choose the language of the
program and the voice profile for the guidance, then
tap OK to confirm your selection.

4.

•_Setup will be completed within a few seconds.

•_The iGO main screen will then automatically
appear. You are now ready to use the program