Page 1
adapter in direct sunlight or next to heat sensitive materials.
the touch during use. This is normal. Avoid placing your iGo
with your electronic device, this iGo adapter may get warm to
norme NMB-003 du Canada
Cet appareil numériqué de la classe B est conformé à la
Made in China. P/N 8040099 Rev. 03
device, protected by 6,700,808. Other United St ates and Foreign Patents pending.
5,347,211,6,643,158, 6,650,560 and 6,064,177 and when used with a dual charging
Specifications are subject to change without notice. Protected under P atents
logos are trademarks or registered trademarks of their respective owners.
and iGo is a trademark of Mobility Electronics, Inc. All other brand names and
©2002-2004 Mobility Electronics, Inc. Mobility Electronics is a registered trademark
Support hours: Mon. – Fri., 10 am – 7 pm EST
Web: http://www.igo.com/help/techsupport.asp
iGoCustServ@pfsweb.com
Email: Techsupport@igo.com
Phone: 1-800-474-7593
You can receive help in a variety of ways:
first-class customer service and technical support.
We are committed to providing our customers with
Tech Support
ICES-003.
T
his Class B digital apparatus complies with Canadian
Note: We
Canada Compliance
for help
• Consult the dealer or an experienced radio/TV technician
from that to which the receiver is connected
• Connect the equipment into an outlet on a circuit different
receiver
• Increase the separation between the equipment and
• Reorient or relocate the receiving antenna
following measures:
try to correct the interference by one or more of the
urning the equipment off and on, the user is encouraged to
t
to radio or television reception, which can be determined by
installation. If this equipment does cause harmful interference
guarantee that interference will not occur in a particular
interference to radio communications. However, there is no
accordance with the instructions, may cause harmful
radio frequency energy and, if not installed and used in
Certifications
installation. This equipment generates, uses and can radiate
protection against harmful interference in a residential
Note: In some
FCC Rules. These limits are designed to provide reasonable
Storage temperature is -40ºC to 85ºC
Ambient operating temperature is 0ºC to 35ºC
Environmental Requirements
limits for a Class B digital device, pursuant to Part 15 of the
This equipment has been tested and found to comply with the
FCC Compliance
specifications. CAUTION: Like the power adapter that came
batteries that meet or exceed the original manufacturer's
recommend that you use iGo power adapters only with device
whether your electronic device is turned on or off.
connected, your battery will automatically charge regardless of
Standard Wall Outlet: As in your car or on the plane, once
the power on and off to the seats in the plane.
to make sure the power is on in the aircraft. Pilots can turn
connections. You may also need to check with a flight attendant
If the LED on the adapter does not illuminate, check all of the
outlet.
located, plug the in-flight connector into the airline power
a flight attendant for the exact location of the outlet. Once
headphones. It may also be located under your seat. Please ask
seat, typically near the same location you use to plug in
airplane. The power outlet is usually located in the arm of your
Air: You will need to find the in-flight power outlet in the
he power may be interrupted causing your system to reset.
T
connected to your electronic device when starting the engine.
CAUTION – It is not recommended to have this iGo adapter
vehicles may not require the ignition to be turned on.
vehicles, power to the cigarette lighter is always on. These
need to replace the cigarette lighter's fuse.
instructions on how to check the fuse box. Ultimately, you may
cigarette lighter fuse. Please refer to your vehicle manual for
is still not illuminated, you may need to check the vehicle's
order to get power. If after checking the connections the LED
Auto, Boat or RV: Your vehicle may need to be running in
iGo Combination Power Adapter
How to Use This
device.
your product may result in injury or damage to your
c
ables, connectors or other accessories not supplied with
with your adapter as shown in this user’s guide. Use of
10. Always use the appropriate cables and connectors supplied
support.
immediately discontinue use, and contact iGo technical
adapter can cause injury. If the adapter malfunctions,
serviceable or replaceable parts inside. Voltage in the
9. Do not attempt to disassemble the adapter. It has no user-
hot.
you smell something burning or the adapter becomes overly
8. Turn off the computer’s power and unplug the adapter if
7. Do not place anything on top of the adapter.
6. Do not drop the adapter or subject it to undue shock.
as cleaning fluids).
moisture, and avoid exposure to corrosive chemicals (such
5. For indoor use only. Keep the adapter free of dust and
heaters) and avoid direct exposure to sunlight.
4. Keep the adapter away from heat sources (such as electric
outlet each time you attach a new “tip” to the cable.
3. Unplug EverywherePower 7500 Series from the power
damage your computer or cause it to malfunction.
attached tip Compatibility Guide–using the wrong tip may
2. Select the correct tip for your notebook by reviewing the
when inser ting or removing it.
1. Never pull on the adapter’s cords. Always hold the plug
will ensure its optimal per formance.
safety information. Proper care of your adapter
Before installing, please read this impor tant
Patented itips Technolog y
The beauty of iGo’s power products is that they deliver the
precise amount of power to each device through the use of
interchangeable itips technology. This way, you don’t have to
worry about selecting the correct amount of power output
as you do with other products—we do it for you! The
attached Compatibility Guide will help you to determine
which tips are needed for your various devices. Simply attach
the correct tip and you’re ready to get energized. If your tip
isn’t included in this package, visit www.igo.com to locate
additional tips for purchase.
WARNING – Using the wrong tip may damage your device
or cause it to malfunction.
obile Phones, Handhelds/PDAs, MP3 Players,
M
Digital Cameras...
So, you’d like to power and charge an additional portable
electronic device. Great, iGo EverywherePower does that
too. All you need is the included iGo DualPower accessory
to simultaneously power/charge 2 electronic devices.
Troubleshooting Help for
Minor Operation Issues
Issue Probable Cause(s) Possible Solution(s)
Laptop is not charging Tip was removed Unplug from outlet,
Laptop is not charging No input or output Check plug connector
Blue LED does No electricity to unit See above solutions
ght
i
t l
o
n
Blue LED does not Light burned out Contact iGo customer
light but unit appears service (see contact
ower devices information on the
o p
t
Laptop not listed on Compatibility is See www.igo.com for
enclosed compatibility always changing current compatibility
chart information
ice is Tip not installed on Install tip on Notebook
v
e
D
ging Notebook Input Cord Input Cord
r
a
h
t c
o
n
when DualPower
is configured
without unplugging wait 30 seconds and
unit plug unit back into outlet
power Check cable connections
Check outlet circuit
breaker
back of this guide)
Specifications
AC input: 100-230 VAC; 50/60 Hz; 3A
DC input: 11.75-30 VDC; 10A MAX
DC output to notebook: Up to 90 Watts continuous
Unit dimensions: 6.07”L x 2.54”W x 1.30”H
Unit weight: 13 oz
engths: AC input-3.0'
d l
r
o
C
S
afety Features
Over voltage protection
Current limit
Over temperature protection
Short circuit protection
C input-3.0’; DC output-6.0’
D
Product Registration
Thank you for purchasing one of iGo’s mobile solutions. Help us
serve you better by taking a moment to register your product at
www.igo.com/registration. Just by registering, you’re eligible for
benefits including 90 days of free tech support, automatic
notification of product updates, and other special promotions.
Warranty
2-year product limited warranty.
Visit http://igo.com/help/Warranty.asp for complete details.
Package Contents
book power adapter
e
t
o
o n
iG
l outlet cord (AC)
l
a
W
uto/air outlet cord (DC)
A
Notebook input cord
iGo DualPower accessory
Nylon carrying case
Powe r tips
(See attached guide for corresponding models and tips)
r's guide
e
s
U
ompatibility guide
C
DualPower guide
17800 North Perimeter Drive, Ste. 200, Scottsdale, AZ 85255 USA
Tel: 1-480-596-0061, 1-800-588-4593; Fax: 1-480-596-0349
Mobility Electronics Inc.
User’s Guide
ngratulations on your iGo power purchase!
o
C
sally compatible with most popular brands, iGo
r
e
v
i
n
U
EverywherePower allows you to power/charge notebook
mputers from any st andard power source. iGo
o
c
erePower can even simultaneously power/charge an
h
w
ry
e
v
E
additional portable electronic device with the included iGo
ualPower accessory. No other adapters are as powerful or as
D
tile as iGo’s line of power products.
a
s
r
e
v
go.com
.i
www
Page 2
®
EMPOWER
outlet as
®
Quick Connect Guide
uncover the
auto connector to
connector for use with the
Air: Remove the
Tech note:
When using DualPower with this iGo adapter, the maximum
charged.
If a device attached to DualPower is not charging properly, it may
need more charging power than can be delivered at that particular
computer and a portable electronic device by
using the included DualPower accessory
Simultaneously power/charge a notebook
Simply insert the accessory into the Connection Port on the
Notebook Input Cord and select the appropriate tip.
Connection Port
Notebook Input Cord
power output of 90 Watts is shared between both devices being
time. When this happens, the LED on the adapter will start pulsing
and we recommend charging each device separately.
Note: Although most
shown.
EMPOWER
airlines use the
outlet, some airlines may
use the standard auto
unnecessary to remove the
socket. In this case it is
auto connector.
Out
Slide
Push
DC Power Cord
Auto: Use as shown.
AC Power Cord
Trouble
EverywherePower body.
tention!
t
unit’s Notebook Input Cord.
1. Connect the correct tip to the
nplug EverywherePower 7500
eries from the power outlet each
able.
ime you attach a new “tip” to the
c
t
S
A
U
into
2. Insert the Notebook Input Cord
EverywherePower body.
cord and insert into
3. Select appropriate power input
4. Plug into the appropriate socket. The
to check all connections. Check
LED on the adapter will now
illuminate, indicating that power is
available. If the LED is not lit, be sure
Shooting for additional information.
5. Plug into the notebook.
Wall outlet: Use as shown.
Loading...