Igo CE4+ User Manual

iGo CE4+

USER MANUAL

E-CIGARETTE

INSTRUCTION MANUAL

WHAT'S IN THE BOX:

Open the iGo CE4+ presentation box lid.

The top tierincludes:

2 x ecig covers with removable mouth piece & screw on.

2 x battery

2 x CE4+

Second tier includes :

1x juice bottle with needle

1x USB charging lead

1x adaptor plug

For safe and effective use of iGo CE4+, please read

through the following information carefully before using and

follow the standard operating procedures strictly.

INSTRUCTIONS FOR FIRST TIME USING:

Remove a battery from your box, screw into the charger lead,

connect the lead to the adapter plug & charge for the first time for

eight hours. The light on the charging lead will, at first red. It will

turn green when fully charged on a normal charge. Even when the

light turns green for the first charge, wait for eight hours to gainthe

best future performance of battery life. The subsequentchargewill

take considerably less time to charge.

Battery can be turned on/off by rapidly pressing the button 5 times.

Your iGo CE4+ will light up when the powers on. Batteries can also

be charged using a USB port.

Do not use the charger in damp areas. Do not charge the power

supply near a high-temp heat source. Do not weld or pierce the

power supply. If the power supply is found to be emitting any heat

or be discolored or deformed or have anyabnormality during

charging, please out off the power supplyfrom iGo CE4+ body or

charger or suspend the use of it. The iGo CE4+ charger can only

be used with iGo CE4+ dedicated power supply. Do not try to use

this charge on other kinds of power supply. Please keep the

iGo CE4+ components and tank atomizer from the reach of the

children or animals.

POWER SUPPLY REPLACEMENT:

The battery requires to be recharged when the kit produces no

more vapor. Unscrew the power supply battery off from the kit,

and screw the fully charged one on to continue vaporizing.

POWER SUPPLY:

Input voltage of the USB home charger is AC 100V-240V 50/60HZ.

Input voltage of the USB car charger is DC 12V-24V. Input voltage

of the USB battery charger is 5V, 500mA and the output voltage

is 4.2v 420mAh. Pay attention to the value of the local voltage to

be in accordance of that of the iGo CE4+ charger. iGo CE4+

<1> <2> <3>

<4>

power supply has about 300 times charging cycle. After more

than 300 charging cycles, their functioning span lessens

significantly. This may be time for a new battery.

Do not use iGo CE4+ in a vertical position, since liquid could leak

out. Push the manual button for no longer than 5 seconds to avoid

overheating of the atomizer.

In case of iGo CE4+ vaporizing continuously or shows signs of

overheating, stop the usage, wait about 10 seconds to start use

again.

iGo CE4+ MAINTENANCE:

It should be maintained regularly.

Do not let the CE4+ run completely dry.

Clean the screw threads of the different parts such as CE4+,

chargers and power supply with a tissue dipped in purified

un-perfumed alcohol (please refer to your local drugstore). Clean

screw thread will provide better electronic conduction.
Blow into the CE4+ once and a while to evacuate left over liquid．

When the vapour diminishes significantly the battery needs to be

charged.

iGo CE4+ ATOMIZER REPLACEMENT:

During the use of this unit, if the battery is fully charged but the

vapour is found to be significantly reduced, it indicates that the

CE4+ may need to be replaced.

Unscrew the CE4+ from the battery, and replace with the newly

filled CE4+.

COURTESY:

iGo CE4+ does not cause harm to surrounding environment and

people. We recommend to ask for permission to use your iGo CE4+

in public places beforehand,however out of courtesy.

CAUTION:

We do not accept any warranty or indemnity claims in case of

wrong usage. Using other cartridges or liquids other than

HOW TO CHARGE

Screw the dedicated power supply in the optional USB charger

cable. Insert the USB charger cable into the USB port of your

computer, USB home charger and USB car charger.

Do not charge power supply outdoors or in a damp environment.

Keep all parts out of children’s reach.

Chargering

<5> <6> <7> <8> <9>

Injecting E-liquid

HOW TO FILL THE E-LIQUID

1). Screw off the clearomizer from the e-cigarette .

2). Turn the clearomizer upside-down.

3). Screw off the connector.

4). Fill e-Liquid 0.4ml-1.6ml into

the plastic tube at the edge.

DO NOT over fill it.

5). Screw on the connector to

the clearomizer.

6). DO NOT screw off it directly

to refill when it's upright.

USING YOUR iGo CE4+:

Screw the filled CE4+ onto the battery (don't over tighten).

Keep your finger on the button whilst inhaling the vapour.Release

the button when you remove your iGo CE4+ from your lips.

Pressing the button too often when not Inhaling may damage

the CE4+.

what iGo CE4+ recommends may cause damage to the CE4+ or unit

which may be beyond repair.Please dispose of the old power supply

in your localpower supply recycling collection point.