ENGLISH Instructions for use Page 3
РУССКИЙ Инструкции по пользованию прибором Стр 8
2
INSTRUCTIONS FOR USE
BEFORE USING THE COOKTOP
SUGGESTIONS FOR ENVIRONMENT
PROTECTION
PRECAUTIONS AND GENERAL ADVICE
ENERGY SAVING TIPS
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
INSTALLATION
3
BEFORE USING THE COOKTOP
• To get full satisfaction of your cooking hob,
please read these instructions carefully and
keep them for future consultation.
• Keep the packaging material (plastic bags,
polystyrene parts, etc.) out of the reach of
children, as they are potentially dangerous.
• Check whether the cooking hob has been
damaged during transport.
• Ensure that the installation and electrical
connections are performed by a qualified
technician, following the manufacturer’s
instructions and in compliance with current local
safety regulations.
• Before first use of appliance, be sure to clean
stainless steel cooktop surface with specific
commercial cleaning product. Also remove any
labels applied on hob upper side
SUGGESTIONS FOR ENVIRONMENT
PROTECTION
1. Packaging
The packaging material is entirely recyclable, and is
marked with the recycling symbol , which
identifies it as a type of material that must be sent
to local waste-disposal centres.
2. Product
This appliance is marked according to the European
directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the
documents accompanying the product, indicates
that this appliance may not be treated as household
waste. Instead it shall be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment.
Disposal must be carried out in accordance with
local environmental regulations for waste disposal.
For more detailed information about treatment,
recovery and recycling of this product, please
contact your local city office, your household waste
disposal service or the shop where you purchased
the product.
PRECAUTIONS AND GENERAL ADVICE
• Before any cleaning or maintenance operation,
disconnect the cooking hob from mains power
supply.
• In case of prolonged use, additional ventilation
may be needed (opening a window or increasing
the extraction force of the hood).
• Keep children away from the cooking hob when
it is in use.
• After use, ensure that the knobs are in position
zero.
• This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities or lack of
experience and knowledge unless they have
been given initial supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
• Young children should be kept away from the
appliance and supervised to ensure that they do
not play with it.
• Is designed solely for private household use for
cooking food. Do not use this appliance as a
space heater to heat or warm the room.
• The appliance is not intended to be operated by
means of an external timer or separate remotecontrol system.
Declaration of conformity
• This appliance has been designed, constructed
and marketed in compliance with:
- safety objectives of the “Low Voltage”
Directive 2006/95/EC (which replaces
73/23/EEC and subsequent amendments).;
- protection requirements of EEC Directive
“EMC” 2004/108/EC.
• This appliance is suitable for contact with
foodstuffs and complies with EEC (CE)
Regulation n. 1935/2004.
4
ENERGY SAVING TIPS
• The cooking hob is equipped with hotplates having different
diameters. Use pots and pans whose bottom diameter is
equal to that of the hotplates, or slightly larger.
• Only use flat-bottomed pots and pans.
• Do not operate a hotplate without placing a container on it.
• If possible, keep the container covered when cooking.
• Cook vegetables, potatoes, etc. with a small amount of water
in order to cut down cooking time.
• A pressure cooker allows you to save even more energy and
time.
CARE AND MAINTENANCE
Important: Never clean the appliance with high pressure water
or steam cleaning equipment.
Cleaning the hob
• Before cleaning the cooking hob, disconnect it from mains
power supply and wait until it has cooled down.
• Wipe it with a cloth moistened with hot water and soap or
diluted liquid detergent.
• Do not use abrasive or corrosive products, chlorine products
or steel wool.
• Do not leave acid or alkaline substances, such as vinegar, salt
or lemon juice, etc., on the cooking hob.
Stainless steel surface
• Clean it with a specific commercial product.
Note: if the cooking hob is used continuously, the high
temperatures may alter the colour of the hotplates.
Cleaning the electric hotplates
The electric hotplates must be cleaned when they are
lukewarm.
Wipe them with a cloth moistened with water and salt, and
polish with a cloth moistened with oil.
TROUBLESHOOTING GUIDE
The hob does not work:
• Check for the presence of mains electrical
power.
• Set the knob to “0” and switch on the hob again
to ensure that the fault has been remedied.
The hob does not turn off:
• disconnect the hob immediately by disconnecting
the power cable from the socket.
• In case of direct connection to the power grid,
disconnect immediately using the fuse box.
5
AFTER SALES SERVICE
Before you call the After Sales Service:
1. Re-start the cooktop, to check whether correct
operation has been restored.
2. If the malfunction persists, call the After Sales
Service.
Give the following information:
• type of malfunction;
• model of cooktop;
• service number (i.e., the number that follows
the word SERVICE on the rating plate under
the cooktop and on the guarantee paper);
•your complete address;
• your telephone number and area code.
If any repairs are required, please contact an
authorised After-Sales Service, as indicated in the
warranty.
In the unlikely event that an operation or repair is
carried out by an unauthorised technician, always
request a certification of the job carried out and
insist on the use of original spare parts.
Failure to comply with these instructions may
compromise the safety and quality of the product.
INSTALLATION
Technical information for the Installer
This cooking hob can be embedded in a worktop 20 to 50 mm
thick.
If another appliance is not fitted under the cooking hob, insert a
separator panel, at a distance of at least 90 mm from the
cooking hob bottom.
• If a vertical piece of furniture is installed, there must be a gap
of at least 100 mm between it and the edge of the cooking
hob.
Installation of cooking hob
• Apply the supplied gasket to the cooking hob (unless it has
already been fitted), after having cleaned its surface as shown
in the figure.
A - If the worktop is made out of wood, use the springs supplied.
1. Fit the 4 springs into the relevant seat under the box.
2. Make an opening in the worktop, respecting the dimensions
indicated in the enclosed product description sheet.
3. Install the cooking hob in the worktop.
B - If the worktop is made out of marble or other materials
(plastics, ceramics or stone), the cooking hob must be fixed
by means of brackets , to be ordered from the After-
Sales Service (code 4819 310 18528).
1. Align the brackets with the bores and fix them with the screws.
2. Make an opening in the worktop, respecting the dimensions
indicated in the product description sheet.
3. Install the cooking hob in the worktop.
• Before installing the cooking hob, remove the plastic film that
protects it, if present.
• Installation must comply with current local safety regulations.
6
INSTALLATION
Electrical connection
• The electrical connections must comply with local
regulations.
• The data relevant to the voltage and power absorption are
indicated on the rating plate.
• The earthing of this appliance is compulsory by law.
The manufacturer cannot be held responsible for injury to
persons or animals or damage to property arising from failure
to comply with these requirements.
• When the appliance is installed, provide a multi-pole circuit
breaker with a contact separation (at least 3 mm) in all poles
that provide full disconnection under overvoltage category III
and must be incorporated in the fixed wiring in accordance
with the national wiring rules.
• After installation, the electric parts must not be accessible.
• For electrical connection, use an H05RR-F cable
(see table in product description sheet).
• The power cable must be long enough for connecting the
appliance, once fitted in its housing, to the power supply.
• The electrical components must not be accessible to the user
after installation.
ELECTRICAL COOKING HOBS WITH SIDE
CONTROLS
Connection to terminal board
1. Open the cover of the terminal board and loosen screw
by means of a tool, as shown in the figure.
2. Unsheathe the cable for about 70 mm.
3. Peel off the internal cables for about 10 mm loosen cable
clamp screw , and insert the cable in the cable clamp.
• The terminal board has 4 terminals:
1-2 interconnected (line)
3 (neutral)
4 (earth): marked with symbol .
4. Connect the cable to the terminal board, following the
indications of the connection diagram punched on the
bottom of the cooking hob. Fasten the cable clamp and close
the cover.
7
5019 600 00163
GB RU
03/11
© Copyright Whirlpool Europe s.r.l. 2011. All rights reserved
Loading...