Igloo MIS1530 User Manual

Model/Modèle: MIS1530

User Manual

Manuel de l'utilisateur

BEVERAGE AND WINE CENTER
REFROIDISSEUR DE VIN ET BREUVAGES

Please Read and Save this Use & Care Book

Por favor lea este instructivo antes de usar el producto

1

WARNING: Read all of the instructions before using this appliance.

When using this appliance, always exercise basic
safety precautions, including the following:

1) Read all of the instructions before using this appliance.

2) Use this appliance only for its intended purpose as described in this use and
care guide.

3) This beverage and wine center must be properly installed in accordance
with the installation instructions before it is used. See grounding instructions
in the installation section.

4) Never unplug your beverage and wine center by pulling on the power
cord. Always grasp the plug firmly and pull straight out from the outlet.

5) Repair or replace immediately, all electric service cords that have become
frayed or otherwise damaged. Do not use a cord that shows cracks or
abrasion damage along its length, the plug or the connector end.

6) Unplug your beverage and wine center before cleaning or before making
any repairs. Note: If for any reason this product requires service, we strongly
recommend that a certified technician performs the service.

7) If your old beverage and wine center is not being used, we recommend that
you remove the doors and leave the shelves in place. This will reduce the
possibility of danger to children.

8) This beverage and wine center should not be recessed or built-in in an
enclosed cabinet. It is designed for freestanding

installation only.

9) Do not operate your beverage and wine center in the presence of explosive
fumes.

10) Your beverage and wine center was NOT designed to store perishable

foods. Store only bottled or canned beverages.

SAVE THESE INSTRUCTIONS

DANGER

Risk of child entrapment. Before you throw away your old

appliance, take off the doors. Leave the shelves in place so

that children may not easily climb inside.

Staple your receipt to your manual.

You will need it to obtain warranty service.

English

GENERAL SAFETY RULES

2

English

1. Interior Light

2. Glass Shelves (3)

3. Chrome Wire Shelf (1)

4. Adjustable Leveling Legs

5. Glass Touch Control Panel

6. Tinted Double Pane Glass Door

7. Drip Tray in Back (not shown)

Parts and Features

1

2

3

4

6

5

F

3

English

1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the beverage and wine center accessories
inside and outside.

2. Inspect and remove any remaining packing, tape or printed
materials before powering on the beverage and wine center.

• Your beverage and wine center has two leveling legs which are

located in the front corners. After properly placing your beverage
and wine center in its final position, you can level your beverage
and wine center.

• Leveling legs can be adjusted by turning them clockwise to lower your

beverage and wine center or by turning them counterclockwise to
raise your beverage and wine center. The beverage and wine center
door will close more easily when the two front leveling legs are
extended slightly.

• To ensure that your beverage and wine center works at the

maximum efficiency it was designed for, you should install it in a
location where there is proper air circulation and electrical connections.

• The following are recommended clearances around the beverage

center:
Sides……………2" (50mm)

Top....................2" (50mm)

Back..................2" (50mm)

• Do not over fill your beverage and wine center for proper cooling.

Note: If your beverage and wine center has been tilted for any reason,

wait 24 hours before plugging it in.

• Ensure the drip tray in the rear of the unit is in the proper position.

Installing Your Beverage And
Wine Center

Unpacking Your Beverage And Wine Center

Proper Air Circulation

Leveling Your Beverage And Wine Center

Drip Tray

4

English

Electrical Requirement

• Make sure there is a suitable power outlet (115 volts, 15 amps

outlet) with proper grounding to power the beverage and wine center.

• Avoid the use of three prong adapters or cutting off the third

grounding prong in order to accommodate a two prong outlet. This is

a dangerous practice since it provides no effective grounding for the

beverage and wine center and may result in shock hazard.

• Do not install your beverage and wine center in any location not

properly insulated or heated (e.g., garage etc.). Your beverage and

wine center was not designed to operate in temperature settings below

55˚ Fahrenheit.

• Select a suitable location for the beverage and wine center on a

hard even surface away from direct sunlight or heat source (e.g.,

radiators, baseboard heaters, cooking appliances, etc.). Any floor

unevenness should be corrected with the leveling legs located on the

front and rear bottom corners of the beverage and wine center.

• Your beverage and wine center is designed for freestanding

installation only. It is not designed for built-in application.
Note: This unit is for indoor use only.

• Avoid the use of an extension cord because of potential safety

hazards under certain conditions. If it is necessary to use an extension

cord, use only a 3-wire extension cord that has

a 3-blade

grounding
plug and a 3-slot outlet that will accept the plug. The marked rating
of the extension cord must be equal to or greater than the electrical
rating of the appliance.

Installation Limitations

Use of Extension Cord

WARNING: ELECTRICAL REQUIREMENT - SHOCK HAZARD

Initial Setup

1. Plug the unit into an electrical outlet. You will hear a beep, which is normal.
The display will revert to the actual internal temperature.

2. The control panel will be active. You must press before
accessing any of the control pads.

5

English

Beverage And Wine Center
Features and Use

Control Panel (Fig. 2)

Control Panel Settings

The temperature range of the beverage and wine center is 32ºF to 61ºF.
The LED display shows the actual internal temperature. Your beverage and
wine center when it is first turned on, will have a factory setting of 46ºF.
Note: It is normal for the actual temperature to vary slightly during normal

operation.

Control Panel Auto-Lock

Your beverage and wine center has an automatic control panel lock. You
may manually activate or deactivate the control panel lock by pressing
the control pad . To operate any of the functions on the control panel,
press the control pad before making a selection. The control panel lock
will automatically activate if the control panel is not touched for 30 seconds.

F