Iget HGDVK-84408, HGDVK-44404, HGDVK-84402, HGDVK-84404, HGDVK-164408 Quick Start Manual

Helpdesk / Technical Support

www.iget.eu/cs/helpdesk-centrum-cs
https://helpdesk.intelek.cz/

SMART

DETECTION

MOTION & HEAT TRIGGER ACCURATE ALERTS

H

eat-sensing HD CCTV Kit

Quick Start Guide - EN

For the latest, up-to-date manual, please visit

www.iget.eu

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE THE COVER.

NO USER SERVICABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert
the user to the presence of non-insulated “dangerous voltage” within the product’s enclosure
that may be of sufficient magnitude to constitute a risk of electric shock.

The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the literature
accompanying the appliance.

1

WARNING:

CAUTION:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT

EXPOSE THIS UNIT TO RAIN OR MOISTURE

TO PREVENT ELECTRIC SHOCK, ENSURE THE PLUG

IS FULLY INSERTED INTO A MAINS SOCKET

IMPORTANT SAFEGUARD

All lead-free products offered by the company comply with the requirements of the

RoHS

conform

European law of the Restriction of Hazardous Substances (RoHS) directive, which means
our manufacturing processes and products are strictly “lead-free” and without the
hazardous substances cited in the directive.

The crossed-out wheeled bin mark symbolizes that within the European Union the
product must be collected separately at the product’s end-of-life. This applies to your
product and any peripherals marked with this symbol. Do not dispose of these products
as unsorted municipal waste. Contact your local dealer for procedures for recycling this
equipment.

DISCLAIMER

We reserve the right to revise or remove any content in this manual at any time. We do not warrant or assume any
legal liability or responsibility for the accuracy, completeness, or usefulness of this manual. The content of this
manual is subject to change without notice.

RECOMMENDATIONS

• AVOID DUSTY LOCATIONS:

• INSTALL IN VENTILATED SPACE:

• DO NOT EXPOSE TO MOISTURE:

• DO NOT DROP:

• DO NOT OPEN CHASSIS:

Excessive build-up of dust may cause the unit to fail.
Ensur

e adequate airflow around the DVR to prevent overheating.
Exposing the unit to water poses high risk of electric shock.
Doing so could damage internal components.
No user-serviceable parts inside.

TRADEMARKACKNOWLEDGEMENTS

• Internet Explorer™, Microsoft™&Windows™ are registered trademarks of Microsoft Corporation.

• Apple™, iPhone™, iPad™ and iTunes™ are registered trademarks of Apple Computer, Inc.

• AndroidTM and Google Play™ are registered trademarks of Google Inc

WARRANTY AND TECHNICAL SUPPORT

To help you make the most of this product you’ll find a host of information including full product manuals, FAQ,
troubleshooting guides and a support service if you have specific questions, available at our support website :

homeguardworld.com/support.

2

CONTENTS

CONNECTING YOUR SYSTEM

4

BASIC OPERATION

13

5

Introduction

6

Package Contents

7

DVR Layout

9

Connecting the DVR

10

Mounting the Cameras

11

Using Remote Control

12

Using the Mouse

14

Start-up Wizard

17

Main Interface

19

PIR Setup

20

Record

21

Playback

CONNECTING SMART DEVICE

22

CONNECTING TO PC&MAC

28

TECHNICAL SUPPORT

36

23

Before Start

23

Get the App

24

User Interface

25

For iPhone

26

For iPad

27

For Android Phone

29

Homeguardsafe Software for PC & Mac

32

Remote Access via Web Client

35

Cloud Access

37

Technical Specifications

38

Technical Q&A

39

Warranty & Support

40

Camera Installation Template

3

CONNECTING

YOUR SYSTEM

1

4

1.1 Introduction

Congratulations on your purchase of this Homeguard Hybrid DVR. Homeguard offers a complete CCTV solution for
home or office security, featuring high quality cameras, easy setup and configuration, motion detection and network
connectivity.

This system features:

• H.264 Video compression and G.711 audio compression

• Support CVBS, AHD, TVI, CVI and IPC

• Provides a convenient User Interface

• 4/8 CH Composite Input Connectors

• Supports 1080p/720p/960H/D1/CIF recording formats

• With the network specific codec, network transfer enabled regardless of the recording conditions

• Hard Disk overwrite function

• Mass storage hard disk backup through high-speed USB 2.0

• Simultaneous Record and Playback of 4/8/16-channel video data

• Various Search Modes (Search by Time, Event, Backup and Motion Detection)

• Various Recording Modes (Manual, Scheduled Recording)

• Remote Monitoring function by Network Viewer and Mobile Viewer

5

1.2 Package Contents

Please unwrap the product, and place the product on a flat place or in the place to be installed.
Please check the following contents are included in addition to the main unit.

• The appearance of the components may differ from the image shown.

• Accessory category and quantity may differ depending on sales region.

Check the contents of your DVR package against this checklist. If anything is missing or damaged, please do not use
the system, and inform your supplier as soon as possible.

HDD NET PWR

1080P HD DIGITAL VIDEO RECORDER

Hybrid DVR Power Adapter Mouse

USB

NOTE

User Manual / SoftwareRemote Control / Battery (AAA x 2) Quick Start Guide

Ethernet Cable

SATA Cable

(for models having no installed HDD)

This manual covers both 4 channel and 8 channel versions of the Homeguard DVR kits model:
HGDVK-44402 / 44404 / 84402 / 84404 / 84408 / 164408 / 164416.

HDD Fixing Screw

6

1.3 DVR Layout

Rear Panel

4CH DVR

DVR Kits Model: HGDVK-44402 / 44404

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRICAL SHOCK

DO NOT OPEN COVERS. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

WARNING : TO PREVENT FIRE OR SHOCK HAZARD. DO NOT

EXPOSE UNITS NOT SPECIFICALLY DESIGNED
FOR OUTDOOR USE TO RAIN OR MOISTURE.

AUDIO

OUTPUT

1 2 3 4 5 6 7 8 9

8CH DVR

DVR Kits Model: HGDVK-84402 / 84404 / 84408

31

2 4

AUDIO
INPUT

2 8

AUDIO

OUTPUT

1 23 4 5 6 7 8 9

3 1

4 42 2

VIDEO
INPUT

3

1

4

VIDEO INPUT

AUDIO
INPUT

5 7

6

13

HDMI VGA

CAUTION : TO REDUCE THE RISK OF ELECTRICAL SHOCK

DO NOT OPEN COVERS. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

WARNING : TO PREVENT FIRE OR SHOCK HAZARD. DO NOT

EXPOSE UNITS NOT SPECIFICALLY DESIGNED
FOR OUTDOOR USE TO RAIN OR MOISTURE.

HDMI VGA

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

LAN

+ -

12V

RS485

LAN

+ -

12V

RS485

16CH DVR

DVR Kits Model: HGDVK-164408 / 164416

11

13

15

14

16

7

VIDEO INPUT

CAUTION

RISK OF ELECTRIC SHOCK

13

AUDIO

OUTPUT

VGA

+ -

RS485

HDMI

LAN

1

3

5

7

9

2

4

6

8

1012

4 2

AUDIO
INPUT

DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRICAL SHOCK

DO NOT OPEN COVERS. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

WARNING : TO PREVENT FIRE OR SHOCK HAZARD. DO NOT

EXPOSE UNITS NOT SPECIFICALLY DESIGNED
FOR OUTDOOR USE TO RAIN OR MOISTURE.

12V

132 5 4 7 68 9

Front Panel

10 11 12

HDD NET PWR

1080P HD DIGITAL VIDEO RECORDER

Part Names Functions

1

2

3

4

5

6

7

8

RCA Audio Output: For speakers

4x / 8x / 16x BNC Video Connectors: For each camera input

4x RCA Audio Connectors: For each audio input*

HDMI Output: For most modern TVs

VGA Output: For most monitors

USB Ports: For USB mouse and external storage

LAN Port: To connect your DVR to the network

RS485: Connect to PTZ devices

USB

13 14

9

10

11

12

13

14

Power Connector: To power the DVR

HDD LED: Flashes when the HDD is in use

Network LED: Flashes when the internet is connected

Power LED: Indicates the DVR is turned ON when lit

IR Receiver: Receives the signal from the remote control

USB Ports: For USB mouse and external storage

8

1.4 Connecting the DVR

53 4

6

LAN

+ -

12V

RS485

2 4

AUDIO
INPUT

5 7

31

AUDIO

OUTPUT

341

VIDEO INPUT

6

2 8

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION : TO REDUCE THE RISK OF ELECTRICAL SHOCK

DO NOT OPEN COVERS. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

WARNING : TO PREVENT FIRE OR SHOCK HAZARD. DO NOT

EXPOSE UNITS NOT SPECIFICALLY DESIGNED
FOR OUTDOOR USE TO RAIN OR MOISTURE.

HDMI VGA

1

2

Connect the camera's video input (yellow) and power supply (red) connectors to the BNC extension cables. Then

1

connect the BNC video input (yellow) to the video input port on the rear panel. (Repeat Step 1 for the remaining
cameras.)

Connect the camera's power supply (red) to the power splitter. Then connect the other end of the power splitter

2

to the power adapter for Cameras and plug in the adapter to a wall outlet. (Repeat Step 2 to connect the camer­as to the second set of power splitter and power adapter.)

Depending on the monitor port, connect the HDMI or VGA cable from your monitor to the HDMI or VGA Port on

3

the rear panel.

Connect one end of the Ethernet cable into your router’s LAN port, and the other end of the cable to the Ethernet

4

port on the rear panel.

5

Connect the mouse to the USB Port on the front or back panel of the DVR.

Connect the power adapter for DVR to the DC 12V port on the rear panel and the power plug into a wall outlet.

6

The DVR will automatically power on and the startup wizard will appear on your monitor.

9

1.5 Mounting the cameras

Twist to lock

connectors

1

Video Output

Power Input

Video & Power Cable

2 3

connects here

Power Adapter
connects here

Video Input Video & Power Cable

Power Adapter

Connect this to the DVR

Power Splitter connects herePower Output

Connect to a spare
wall socket

Power Splitter

Connect the video output and power input connection on the camera to the corresponding connections on the

1

supplied video & power cable.

Connect the supplied power splitter to the other end of the video & power cable. This provides power to multiple

2

cameras using a single power adapter.

Connect the other end of the power splitter to the supplied power adapter then connect the power adapter to

3

a power outlet.

TIP

Each Homeguard camera is supplied with a mounting kit for attaching it to a wall. Before you affix the
camera in position, please ensure the cable is of adequate length to reach the DVR.

10

1.6 Using Remote Control

Part Names Functions

1-8

9, 0

ALL

Menu

Mute

Submenu

▲

Sel

◄►

▼

◄◄

►►

►

●

■

▌▌

Numeric keys. Press to display channel 1~8

Numeric keys

Press to display all channels. Multiple display mode

Press to enter or exit the Main Menu

Mute On/off

Go to submenu

Up arrow key; Volume increase

Press to enter the selected menu item and edit the setting

Left/Right key; Decrease/increase parameter value of control bar

Down arrow key; Volume decrease

Press to rewind during video playback

Press to fast forward during video playback

Press to play recorded video or enter the recording search menu

Press to start manual recording

Press to stop manual recording or stop the video playback

Press to pause the video playback or enter frame-playback mode

11