iCR 3600 Flat Gear and Motor Replacement
Please read and understand the entire work instruction before beginning any procedures.
WARNING: iCRco assumes no liability for damage done to the CR unit while following these instructions. These instructions should be carried out by an iCRco approved technician. If at any point these instructions become unclear, please contact Technical Support at 1-310-921-9559.
1.Make sure the CR unit is powered off. Remove the power cord from the unit.
2.Remove nine (9) 6-32 x 38 ” flathead undercut screws from the back cover.
WARNING: This unit is operated with hazardous voltages which can shock, burn, or cause death. Residual charge may still be present in the power supply boards. Exercise extreme caution when removing power plugs from power boards.
3.Remove the internal USB connector from its external connection, the power switch plugs from the main power supply and the eraser power supply and the external fan power plug.
1 of 13 |
Document # 3600FGMR-01A Rev A |
July 1, 2009 |
iCR 3600 Flat Gear and Motor Replacement
4. Remove four (4) 10-32 x 12 ” truss head screws from the feet.
5. Remove four (4) 6-32 x 38 ” flathead screws from the front cover.
6. Slide the top cover back, then lift the cover off.
7. Slide the door to the open position.
2 of 13 |
Document # 3600FGMR-01A Rev A |
July 1, 2009 |
iCR 3600 Flat Gear and Motor Replacement
8.There is a plastic release latch on the underside of the door. Squeeze the latch towards the feet of the unit to release the door from the door slide, then slide the rail back, removing it from the door.
9. Remove two (2) 6-32 x 14 ” & two (2) 6-32 x 1” truss head from the brush bar cover.
3 of 13 |
Document # 3600FGMR-01A Rev A |
July 1, 2009 |
iCR 3600 Flat Gear and Motor Replacement
10. Cover the scan slot with a piece of masking tape to prevent dust entry into the system.
11. Remove nine (9) 6-32 x 14 ” screws from the Eraser Cover.
12. Remove the Eraser Cover by gently pulling it away from the machine.
4 of 13 |
Document # 3600FGMR-01A Rev A |
July 1, 2009 |
Loading...