Page 1
CF-FR5000MC
CF CARD
FORWARD
Thank you for purchasing the CF-FR5000MC CF CARD. The CF
card will upgrade your UC-FR5000 TRUNKING /NETWORK CON-
TROLLER and enable the Multi Site Conventional mode use.
Please read these instructions carefully before using the CF
card.
PRECAUTIONS
RWARNING! Turn OFF the repeater before inserting the CF
card into the UC-FR5000. Otherwise a fire, electric shock may
occur, or the data on the CF card may become corrupted.
CAUTION: NEVER insert the CF card into the UC-FR5000 if
dust or dirt is on the connector. This may cause the CF card,
and the UC-FR5000, to malfunction.
CAUTION: NEVER touch the connector part of the CF card directly. It may cause a breakdown of the internal circuit by static
electricity.
CAUTION: N EVER turn OFF the repeater while the data is
being transferred. Otherwise, the data on the CF card may become corrupted.
CAUTION: Use the CF card only in the UC-FR5000. Inserting
the CF card into other equipment may corrupt the card’s data.
NEVER keep the CF card in areas with extremely high temperatures, high humidity, or in direct sunlight.
DO NOT submerge the CF card in water, or get it wet.
DO NOT bend the CF card.
DO NOT drop or strike the CF card against another object.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, United Kingdom, Germany, France,
Spain, Russia and/or other countries.
Page 2
INSERTION AND REMOVAL
UC-FR5000
CF card slot
Serial label
CF card
UPGRADE
• Insertion
Be sure to insert the CF card with the “CF-FR5000MC”
label (serial label) facing up.
Slowly insert the CF card into the CF card slot of the UC-FR5000.
•
If the CF card seems to jam, or is too tight, carefully remove it.
Ensure that the card is properly oriented and that there are no
obstructions in the sides of the card insertion slots, then reinsert the card.
• Removal
Hold the edge of the CF card, and slowly pull it out.
When no CF card is inserted, the UC-FR5000 cannot be
used for Multi Site Conventional mode operation, even after
the up
grade.
To upgrade the UC-FR5000, and enable the Multi Site Conventional mode, perform the following steps after inser ting
the CF card. The following instructions are for reference only.
Please refer to the UC-FR5000’s help file for upgrade details.
q Access the setting screen of the UC-FR5000.
• The opening screen appears.
Refer to the UC-FR5000’s instruction manual for information on how to access the setting screen.
w Click “Maintenance” in the Top Menu.
• The Maintenance menu appears on the left side of the screen.
e Click “Application Add-on” in the Maintenance menu.
r Select “by on board CF Card” in the Application Package,
then click [CHECK].
• The Application Package list appears.
t Select “ucfr5000_application” from the list, then click [Add].
• A confirmation screen appears.
y After carefully reading the warning text on the confirmation
screen, check the “Yes, I agree” box. Then click [Start].
• The installation starts to upgrade the firmware of the UC-FR5000.
“Now Adding, Please Wait...” appears during the installation.
u After the installation is completed, “Finish.” appears. Then
click [OK].
• The installed application appears on the Application list.
i Turn OFF the repeater, then turn it ON again.
• The upgrade process is now complete.
A-6774H-1EX-q © 2009 Icom Inc.
Loading...