Telephone Expansion Module
ICC’s Telephone Expansion Module is an 8-port bridged telephone solution. This module offers a 8P8C input and an expansion jack
for additional connectivity. It supports up to 8 telephony outlets for phone, fax, modem devices, and has access up to 4 incoming
phone lines. Available in these different styles: Premier, Deluxe and Compact
Telephone Expansion Module
INSTALLATION INSTRUCTIONS
Residential Cabling Solutions
ASSEMBLY INSTRUCTIONS
CUSTOMER CARE / TECHNICAL SUPPORT • CSR@ICC.COM / 888-275-4422 (ASK-4-ICC)
www.icc.com
© Copyright 2008, ICC. ICC and ICC logo are registered trade name and trademark. All rights reserved. 0208 MSR-0411-4 REV B
8-Port Telephone Expansion Module, 1 piece
A
Fastener, 4 pieces
B
Step 1.
1. Place module horizontally and align fasteners
with the enclosures peg board. Make sure the fasteners are NOT
in locked positions.
Step 3.
3. Once module bracket is in the desired location,
push the fasteners to the locked position.
Step 2.
2. Push the module so that the fasteners go into
the peg board of the enclosure.
Locking Button (4x)
110 IDC’s
Enclosure
Module
A
B
ICRESVPB1C
ICRESVPB2C
ICRESVPB3C
INCLUDES:
This installation instruction is designed
for the following part numbers:
Deluxe
Compact
Step 4.
4. Connect the telephone expansion board to the Telephone Module with the included 6” 8P8C jumper cord. Use a 110 punch down tool to terminate each wire between contact blades. Identify each outlet cable and connect to 110 block labeled “To Locations.” Punch down twisted pairs
depending on which lines are desired to be activated at each location.
NOTE: Line#1 = Blue, Line#2 = Orange, Line#3 = Green, Line#4 = Brown
Example: Each 110-block represents one location. If you want to activate Line#1 at Location#1, simply punch down the twisted pair (White
Blue/Blue) to the first 110-block. If you want to use a 2-line phone (Line#1 & Line#2) at Location#1, simply punch down twisted pairs (White
Blue/Blue & White Orange/Orange) to the first 110-block to support 2-line phone.
WIRE INSTALLATION: For 110 IDC connector, follow the wire color-code and only use the 110 punch-down tool to terminate the wire between the
contact blades.
RJ-45 Jacks: Phone and data lines are wired according to the TIA T-568-A standard.
ASSEMBLY INSTRUCTIONS
Also available
ICRESVPB2C
ICRESVPB3C
Loading...