ICC ICRESVPA3C User Manual

8-Port Telephone Module with RJ31X Jack

INSTALLATION INSTRUCTIONS

Residential Cabling Solutions

ASSEMBLY INSTRUCTIONS

CUSTOMER CARE / TECHNICAL SUPPORT • [e-mail] / 888-275-4422 (ASK-4-ICC)

www.icc.com

© Copyright 2008, ICC. ICC and ICC logo are registered trade name and trademark. All rights reserved. 0208 MSR-0411-3 REV E

A

Step 1.

1. Place module horizontally and align fasteners
with the peg board. Make sure the fasteners are
NOT

in locked positions.

Step 3.

3. Once the module bracket is in the desired
location, push the fasteners to the locked position.

Step 2.

2. Push the module so that the fasteners goes into
the peg board of the enclosure.

Fasteners (4x)

110 IDC’s

Enclosure

Bracket

B

ICRESVPA1C
ICRESVPA2C
ICRESVPA3C

INCLUDES:

Telephone Module with RJ31X Jack

ICC’s Telephone Module with RJ31X Jack is an 8-port bridged telephone solution. This module offers a 110 IDC input and an expan­sion jack for additional connectivity. It supports up to 8 telephone outlets for phone, fax, modem devices, and has access up to 4
incoming phone lines. Available in three different styles: Premier, Deluxe, and Compact.

8-Port Telephone Module with RJ31X Jack, 1 piece

A

Fasteners, 4 pieces

B

This installation instruction is designed
for the following part numbers:

A

4. Connect the incoming phone line to the 110 IDC labeled “From Source.” Use a 110 punch down tool to terminate each wire between contact
blades. Identify each outlet cable and connect to 110 block labeled “To Locations.” P unch down twisted pairs depending on which lines are desired

to be activated at each location.

NOTE: Line#1 = Blue, Line#2 = Orange, Line#3 = Green, Line#4 = Brown
Example: Each 110-block represents one location. If you want to activate Line#1 at Loc

ation#1, simply punch down the twisted pair (White
Blue/Blue) to the first 110-block. If you want to use a 2-line phone (Line#1 & Line#2) at Location#1, simply punch down twisted pairs (White
Blue/Blue & White Orange/Orange) to the first 110-block to support 2-line phone.

WIRE INSTALLATION: For 110 IDC connector, follow the wire color-code and only use the 110 punch-down tool to terminate the wire between the
contact blades.

RJ-45 Jacks: Phone and data lines are wired according to the TIA T-568-A stand

ard.

Step 4.

ASSEMBLY INSTRUCTIONS

Deluxe

Compact

Also available:

ICRESVPA2C ICRESVPA3C