Telephone Module with RJ31X Jack
ICC’s Telephone Module with RJ31X Jack is an 8-port bridged telephone solution. The module offers a 110 IDC input and an expansion jack for additional connectivity. It supports up to 8 telephone outlets for phone, fax, modem devices, and has access up to 4
incoming phone lines.
8-Port Telephone Module with RJ31X Jack
INSTALLATION INSTRUCTIONS
Residential Cabling Solutions
ASSEMBLY INSTRUCTIONS
CUSTOMER CARE / TECHNICAL SUPPORT • CSR@ICC.COM / 888-275-4422 (ASK-4-ICC)
16800 Edwards Road, Cerritos CA 90703 • 562-356-3111 • Fax 562-356-3100
© Copyright 2006, ICC. ICC and ICC logo are registered trade name and trademark. All rights reserved. MSR-0411-3 REV C
8-Port Telephone Module with RJ31X Jack, 1 piece
A
Bracket, 1 piece
B
Fasteners, 4 pieces
C
ICRESVPA1C
INCLUDES:
A
Step 1.
1. Place module horizontally and align fasteners
with the peg board. Make sure the fasteners are
NOT in locked positions.
Step 3.
3. Once the module bracket is in the desired location, push the fasteners to their lock position.
Step 2.
2. Push the module so that the fasteners goes into
the peg board of the enclosure.
Fasteners (4x)
110 IDC’s
Enclosure
Bracket
A
B
C
Step 4.
4. Connect the incoming phone line to the 110 IDC labeled “From Source.” Use a 110 punch down tool to terminate each wire between contact
blades. Identify each outlet cable and connect to 110 block labeled “To Location.” Punch down twisted pairs depending on which lines are desired
to be activated at each location.
NOTE: Line#1 = Blue, Line#2 = Orange, Line#3 = Green, Line#4 = Brown
Example: Each 110-block represents one location. If you want to activate Line#1 at Location#1, simply punch down the twisted pair (White
Blue/Blue) to the first 110-block. If you want to use a 2-line phone (Line#1 & Line#2) at Location#1, simply punch down twisted pairs (White
Blue/Blue & White Orange/Orange) to the first 110-block to support 2-line phone.
WIRE INSTALLATION: For 110 IDC connector, follow the wire color-code and only use the 110 punch-down tool to terminate the wire between the
contact blades.
RJ-45 Jacks: Phone and data lines are wired according to the TIA T-568-A standard.
ASSEMBLY INSTRUCTIONS
Security Board
if Available
ICRESVPB1C
Telephone Module with Expansion Jack
For up to 8 More Locations if Required
Telephone Module With RJ31X Setup
Wiring a 110 Connector
1. Strip 2” of cable jacket.
2. Untwist about 0.5” wire and
keep jack close to 110
connector.
3. According to the color code
only use a 110 punch down
tool to push the wire between
the contact blades, or wire may
be damaged when using other tools.
Punch Down Tool
Brown
Brown/White
Green
Green/White
Orange
Orange/White
Blue
Blue/White
PR2
PR3 PR1 PR4
TRTRTRTR
123456 78
Band-Striped
Twisted Pair Wire
Pair 1
Pair 4
Band Color
Base Color
Solid Color
Twisted Pair Wire
White/Blue T1
Blue R1
Pair 2
Pair 3
White/Orange T2
Orange R2
White/Green T3
Green R3
White/Brown T4
Brown R4
Green
Red
Black
Yellow
White
Blue
Wiring RJ-45 Jack
Loading...