IAO5
IAO5 IAO8
Multifunction Oven 600mm
USER MANUAL
Installation & Operation Manual for 600mm Multifunction ovens
USER INSTRUCTIONS
SPECIAL NOTE
This Installation and Operation Manual is utilised for many different models
throughout the world and not all the instructions or features covered within this
manual will relate to your specific model.
GENERAL WARNINGS
Read carefully all the instructions contained in this booklet. It provides you with important
information regarding the safe installation, use and maintenance of the appliance as well as useful
advice for getting the best out of your oven. Keep this booklet in a safe place for future reference.
After removing the packing, check that the appliance is not damaged in any way.
Be careful not to leave the packing materials (plastic sheeting, expanded polystyrene etc.) where
children can get at them, as they can be dangerous.
• The appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervised or instruction concerning use of the appliance by a responsible
person for their safely.
• Young children should be supervised to ensure that they do not play with the appliance.
• WARNING: Accessible parts may become hot during use. To avoid burns young
children should be kept away
• If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid a hazard.
• During use the appliance becomes hot. Care should be taken to avoid touching heating
elements inside the oven. Please keep children away from the oven.
• WARNING: Ensure the appliance is switched off before replacing the lamp to avoid the
possibility of electric shock.
• Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door since
they can scratch the surface, which may result in shattering of the glass.
• Do not use a steam cleaner to clean the oven.
• If the range is not fitted with a flexible cord, the instruction manual must clearly state the
type and size of cord to be used.
Installation & Operation Manual for 600mm Multifunction ovens
IMPORTANT: do not use the oven door handle to move the appliance, such as to remove it
from the packaging
The first time you switch the oven on, acrid smelling smoke may appear. This is caused by the
heating of the adhesive used on the insulation panels surrounding the oven. There is nothing
unusual about this. If it happens, simply wait until the smoke disappears before putting any food in
the oven. Never roast or bake on the oven base, nor should any kind of drip tray or aluminium foil
be placed on the base of the oven as damage to ENAMEL could occur.
Safety is a good habit to get into
◎ This appliance is designed for non-professional, household use and its functions must not be
changed.
◎ The electrical system of this appliance may be used safely only when it is correctly connected
to an efficient earthing system in compliance with the safety standards currently in effect.
◎ The manufacturer will not be held liable for any damages that might arise out of incorrect
installation or improper, incorrect or unreasonable use of the appliance.
The following items are potentially dangerous, and therefore, appropriate measures must be taken
to prevent children and the disabled from coming into contact with them:
- Controls and the appliance in general;
- Packaging (bags, polystyrene, nails, etc.);
- The appliance immediately after use of the oven or grill due to the heat generated;
- The appliance when no longer in use (potentially dangerous parts must be made safe).
Avoid the following:
- Touching the appliance with wet parts of the body;
- Using the appliance when barefoot;
- Pulling on the appliance or the supply cord to unplug it from the electrical outlet;
- Obstructing the ventilation or heat dissipation slots;
- Allowing power supply cords for small appliances to come into contact with the hot parts
of the appliance;
- Exposing the appliance to atmospheric agents (rain, sun);
- Using the oven for storage purposes;
- Using flammable liquids near the appliance;
- Using adaptors, multiple sockets and/or extension cords;
- Attempting to install or repair the appliance without the assistance of qualified personnel.
ATTENTION
The oven is an appliance which, for its nature, becomes hot, especially in
correspondence of the glass door.
It is therefore a good rule that children do not approach the oven when it is
functioning, particularly when the grill in used.
Installation & Operation Manual for 600mm Multifunction ovens
WARNING- Accessible parts will become hot when in use. To avoid burns and scalds children should
be kept away
During use the appliance becomes hot, Care should be taken to avoid touching heating elements
inside the oven.
Qualified personnel must be contacted in the following cases:
- Installation (following the manufacture’s instructions);
- When in doubt about operating the appliance;
- Replacing the electrical outlet when it is not compatible with the plug for the appliance.
Service Centres authorized by the manufacturer must be contacted in the following cases:
- If in doubt about the soundness of the appliance after removing it from the packaging;
- If the power supply cord has been damaged or needs to be replaced;
- If the appliance breaks down or functions poorly; ask for original spare parts.
It is a good idea to do as the following:
- Only use the appliance to cook food, nothing else;
- Check the soundness of the appliance after it has been unpacked;
- Unplugged the appliance from the electrical mains if it is not functioning properly and
before cleaning or performing maintenance;
- When the appliance is not used for an extended period of time, unplugged the appliance
and close the gas cock (it present);
- Use cooking gloves to place cookware in the oven or when removing it;
- Always grasp the oven door in the centre because the ends may be hot due to the
escape of hot air;
- Make sure that the control knobs are on the “o”setting when the appliance is not in use;
- Unplug the appliance when you decide not to use the appliance any longer.
◎ The manufacturer may not be held responsible for any damage due to: incorrect installation,
improper, incorrect and irrational use.
SPECIFICATION
The ovens are designed to operate with a monophase alternating current of 220-240V 50Hz.
anyway, before the installation of the appliance, we suggest you to check always these
specifications on the rating label applied on the outside rear part.
Powers absorbed in accordance with models
Accessories according to
models
Oven lower heatin
g
el.
1200Watt
Oven inside hearting el. 1900
Watt
synchromotor 4 Watt
Oven upper heatin
g
el.
1000Watt
Total grill heating el. 1000+1900
Watt
Shaded motor (back) 25 Watt
Oven li
g
ht
15Watt
Circle heatin
g
el.
2100Watt
Shaded motor (top) 15Watt
Overall dimensions for oven volume: width 436mm-height 315mm-depth 410mm=56liters
Installation & Operation Manual for 600mm Multifunction ovens
INDICATOR LIGHTS
The indicator lights situated above the control panel go on and off when the heating elements are
inserted or removed. During the thermostatic functioning of the oven, the neon light remains on until
the pre-chosen temperature is reached and when it goes out, this is a sign that the temperature has
been reached. When the oven cools, the thermostat determines the re-insertion of the heating
elements with consequent re-lighting of the indicator lights. In models the internal oven light, which
is always on when any function is in operation, is considered as an operation, is considered as an
operating warning light.
INSTALLING THE APPLIANCE
Important: Unplug your oven before performing installation or maintenance!
Installation should be carried out according to the instructions by a professionally qualified person.
The manufacturer declines all responsibility for
any damage to persons, animals or things due to
a wrong installation.
FITTING THE APPLIANCE
Fit the appliance into its surround (beneath a
work-top or above another appliance) by
inserting screws into the 2 holes that can be seen in the frame of the oven when the door is open.
For the most efficient air circulation, the oven should be fitted according to the dimensions shown in
fig. 1-2 of page 2.
The rear panel of the cabinet must be removed so that air can circulate freely. The panel to which
the oven is fitted should have a gap of at least 70 mm at the rear.
NB: where ovens are to be matched with hobs, it is essential to follow the instructions contained in
the booklet supplied with the other appliance.
IMPROTANT
During use the appliance becomes hot, Care should be taken to avoid touching heating elements
inside the oven.
Accessible parts may become hot during use. Yong children should be kept away.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they
can scratch the surface, which may result in shattering of the glass.
For a built-in oven to work well the cabinet must be of the right type.
The panels of the adjoining furniture should be heat resistant. Particularly when the adjoining
furniture is made of veneered wood, the adhesives should be able to withstand a temperature of
120Ԩ. Plastic materials or adhesive which cannot withstand this temperature will become deformed
or unstuck.
To comply with safety regulations, once the appliance has been fitted it should not be possible to
make contact with the electrical parts.
All parts which offer protection should be fixed in such a way that they cannot be removed without
Installation & Operation Manual for 600mm Multifunction ovens
the use of a tool.
Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of
electric shock.
CONNECTION TO THE MAINS SUPPLY
THE APPLIANCE MUST BE CONNECTED ACCORDANCE WITH THE RULES CURRENTLY.
IN FORCE, AND ONLY BY AN AUTHORIZED ELECTRICAL INSTALLER.
WARNING: THIS APPLIANCE MUST BE EARTHED
Check that the power rating of the mains supply and of the sockets are suitable for the maximum
power of the appliance as indicated on the specification plate.
plug should be accessible after installation. Fit the plug into a socket fitted with a third contact
which corresponds with the earth connection. This should be properly connected.
If the appliance just fitted with supply leads but does not come already fitted with a plug, then
permanently connect to fixed wiring as follow:
The “yellow/green” earth wire, which must be connected to terminal, has to be about 10mm longer
than the other wires; the “blue” neutral wire has to be connected to the terminal marked with letter
N.
“Black, brown, red” live wires have to be connected to terminal L. Mains connection can also be
made by fitting a double pole switch with a minimum gap between the contacts of 3mm,
proportionate to the load and complying with the regulations in force.
The yellow/green earth wire should not be controlled by the switch.
The plug or a double pole switch used for mains supply connection should be easy to get at, once
the appliance is in position.
Important: position the mains supply cable so that it is never subjected to a temperature which is
more than 50Ԩ above ambient temperature.
The electrical safety of the appliance can only be guaranteed when it has been correctly
connected to an efficient earthed power supply, as laid down in the regulations for electrical
safety.
Important: the manufacturer cannot be held responsible for any damage to persons or objects due
to lack of an earth connection.
Installation & Operation Manual for 600mm Multifunction ovens
Installation & Operation Manual for 600mm Multifunction ovens
INSTRUCTIONS FOR USE: to switch off the oven, turn the knobs on position
( ) and ( )
SELECTOR KNOB
THERMOSTAT
MULTIFUNCTIONAL OVENS 5 FUNCTIONS
N.B.: All functions will start after selecting the temperature
with the thermostat knob.
The oven is fitted with:
z an upper heating element, which according to the
cooking mode can be used for grilling or baking.
50 - MAX
Defrosting with fan
The air at ambient temperature is distributed inside the oven
for defrosting food more quickly and without proteins
adulteration.
50 - MAX
Fan assisted total grill
The air which is heated by the grill heating element is
circulated by the fan and so helps to distribute the heat
between 50 and 200 ℃ . This function can be used for
sterilizing glass jars
50 - MAX
Total grill
It is indicated for grilling and gratinating traditional food.
This function must always be used with half-open door and
control protection in position (see fig. 10-10b)
50 - MAX
Light
A light in the oven.
50 - MAX
Fan oven
Both the fan and the circular heating element operate
together. The hot air adjustable between 50 and MAX
℃
is
evenly distributed inside the oven. This is ideal for cooking
several types of food (meat, fish) at the same time without
affecting taste and smell. It is indicated for delicate pastries.
Installation & Operation Manual for 600mm Multifunction ovens
MULTIFUNCTIONAL OVENS 8 FUNCTIONS
N.B.: All functions will start after selecting the temperature with the thermostat knob.
SELECTOR KNOB
THERMOSTAT
N.B.: All functions will start after selecting the oven
temperature with the thermostat knob.
The oven is fitted with:
z a lower heating element;
z an upper heating element, which according to the
cooking mode can be used for grilling or baking.
z A circular heating element, which surrounds the fan.
N.B.: All functions will start after selecting the oven
temperature with the thermostat knob.
50 - MAX
Defrosting with fan
The air at ambient temperature is distributed inside the
oven for defrosting food more quickly and without proteins
adulteration.
50 - MAX
Natural convection
Both the lower and upper heating elements operate
together.
This is the traditional cooking, very good for roasting joints,
ideal for biscuits baked apples and crisping food. You
obtain very good results when cooking on a shelf adjusting
the temperature between 50 and MAXԨ
Loading...