Hyundai HYU-559 Quick Start Manual
VIDEO INTERCOM
INDOOR STATION
(HYU-559)
Quick Start Guide
Video Intercom Indoor Station·Quick Start Guide
i
Quick Start Guide
This quick start guide is intended for users of the indoor station.
It includes instructions on how to use the Product. The software embodied in the
Product is governed by the user license agreement covering that Product.
Disclaimer
REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE OF PRODUCT SHALL BE WHOLLY
AT YOUR OWN RISKS. OUR COMPANY SHALL NOT TAKE ANY RESPONSIBILITES FOR ABNORMAL
OPERATION, PRIVACY LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER ATTACK, HACKER
ATTACK, VIRUS INSPECTION, OR OTHER INTERNET SECURITY RISKS; HOWEVER, OUR COMPANY
WILL PROVIDE TIMELY TECHNICAL SUPPORT IF REQUIRED.
SURVEILLANCE LAWS VARY BY JURISDICTION. PLEASE CHECK ALL RELEVANT LAWS IN YOUR
JURISDICTION BEFORE USING THIS PRODUCT IN ORDER TO ENSURE THAT YOUR USE CONFORMS
THE APPLICABLE LAW. OUR COMPANY SHALL NOT BE LIABLE IN THE EVENT THAT THIS PRODUCT IS
USED WITH ILLEGITIMATE PURPOSES.
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATER
PREVAILS.
Support
Should you have any questions, please do not hesitate to contact your local dealer.
Video Intercom Indoor Station·Quick Start Guide
ii
Regulatory Information
FCC Information
Please take attention that changes or modification not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
FCC compliance: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
EU Conformity Statement
This product and - if applicable - the supplied accessories too are
marked with "CE" and comply therefore with the applicable harmonized
European standards listed under the EMC Directive 2014/30/EU, the
RoHS Directive 2011/65/EU.
2012/19/EU (WEEE directive): Products marked with this symbol cannot
be disposed of as unsorted municipal waste in the European Union. For
proper recycling, return this product to your local supplier upon the
purchase of equivalent new equipment, or dispose of it at designated
collection points. For more information see: www.recyclethis.info
2006/66/EC (battery directive): This product contains a battery that
cannot be disposed of as unsorted municipal waste in the European
Union. See the product documentation for specific battery information.
The battery is marked with this symbol, which may include lettering to
indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling,
return the battery to your supplier or to a designated collection point.
For more information see: www.recyclethis.info
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (A)/NMB-3(A) standards requirements.
Video Intercom Indoor Station·Quick Start Guide
iii
Safety Instruction
These instructions are intended to ensure that user can use the product correctly to
avoid danger or property loss.
The precaution measure is divided into Warnings and Cautions:
Warnings: Neglecting any of the warnings may cause serious injury or death.
Cautions: Neglecting any of the cautions may cause injury or equipment damage.
Warnings
z The working temperature of the device is from -10º C to 55º C.
z All the electronic operation should be strictly compliance with the electrical safety
regulations, fire prevention regulations and other related regulations in your local
region.
z Please use the power adapter, which is provided by normal company. The power
consumption cannot be less than the required value.
z Do not connect several devices to one power adapter as adapter overload may cause
over-heat or fire hazard.
z Please make sure that the power has been disconnected before you wire, install or
dismantle the device.
z When the product is installed on wall or ceiling, the device shall be firmly fixed.
z If smoke, odors or noise rise from the device, turn off the power at once and unplug
the power cable, and then please contact the service center.
z If the product does not work properly, please contact your dealer or the nearest
service center. Never attempt to disassemble the device yourself. (We shall not
assume any responsibility for problems caused by unauthorized repair or
maintenance.)
Cautions
z Do not drop the device or subject it to physical shock, and do not expose it to high
electromagnetism radiation. Avoid the equipment installation on vibrations surface
or places subject to shock (ignorance can cause equipment damage).
z Do not place the device in extremely hot (refer to the specification of the device for
the detailed operating temperature), cold, dusty or damp locations, and do not
expose it to high electromagnetic radiation.
z The device cover for indoor use shall be kept from rain and moisture.
Warnings Follow
these safeguards to
prevent serious
injury or death.
Cautions Follow these
precautions to prevent
potential injury or
material damage.
Video Intercom Indoor Station·Quick Start Guide
iv
z Exposing the equipment to direct sun light, low ventilation or heat source such as
heater or radiator is forbidden (ignorance can cause fire danger).
z Do not aim the device at the sun or extra bright places. A blooming or smear may
occur otherwise (which is not a malfunction however), and affecting the endurance
of sensor at the same time.
z Please use the provided glove when open up the device cover, avoid direct contact
with the device cover, because the acidic sweat of the fingers may erode the surface
coating of the device c o v er.
z Please use a soft and dry cloth when clean inside and outside surfaces of the device
cover, do not use alkaline detergents.
z Please keep all wrappers after unpack them for future use. In case of any failure
occurred, you need to return the device to the factory with the original wrapper.
Transportation without the original wrapper may result in damage on the device and
lead to additional costs.
z Improper use or replacement of the battery may result in hazard of explosion.
Replace with the same or equivalent type only. Dispose of used batteries according
to the instructions provided by the battery manufacturer.
Video Intercom Indoor Station·Quick Start Guide
v
Table of Contents
1 Appearance .................................................................................................. 1
1.1 Appearance of 8-Series Indoor Station ..................................................................................... 1
1.2 Appearance of Type I 6-Series Indoor Station ........................................................................... 2
1.3 Appearance of Type II and Type III 6-Series Indoor Station....................................................... 3
2 Terminals and Wiring ................................................................................... 5
2.1 Terminal Description ................................................................................................................ 5
2.1.1 Terminals and Interfaces of 8-Series Indoor Station .......................................................... 5
2.1.2 Terminals and Interfaces of Type I 6-Series Indoor Station ................................................ 6
2.1.3 Terminals and Interfaces of Type II and Type III 6-Series Indoor Station ............................ 7
2.2 Wiring Description ................................................................................................................... 7
2.2.1 Wiring of 8-Series Indoor Station ...................................................................................... 7
2.2.2 Wiring of Type I 6-Series Indoor Station ............................................................................ 8
2.2.3 Wiring of Type II and Type III 6-Series Indoor Station ........................................................ 9
3 Installation ................................................................................................. 10
3.1 Installation Accessory Description .......................................................................................... 10
3.2 Wall Mounting with Junction Box ........................................................................................... 10
4 Getting Started ........................................................................................... 12
4.1 Activate Indoor Station ........................................................................................................... 12
4.2 Set SIP Sever ........................................................................................................................... 13
4.2.1 Set Private SIP .................................................................................................................. 13
4.2.2 Set Standard SIP .............................................................................................................. 14
4.3 Set Network ............................................................................................................................ 16
4.3.1 Set Indoor Station Network Parameters .......................................................................... 16
4.3.2 Set Linked Device IP ......................................................................................................... 17
4.4 Set Indoor Station No. ............................................................................................................ 19
5 Appendix .................................................................................................... 22
5.1 Installation Notice .................................................................................................................. 22
5.2 Wiring Cables ......................................................................................................................... 22
Video Intercom Indoor Station·Quick Start Guide
1
1 Appearance
1.1 Appearance of 8-Series Indoor Station
Figure 1-1 Front Panel
Table 1-1 Components Description
No. Description
1 Built-in Camera
2
Power Supply Indicator
3 Information Indicator
4 Alarm Indicator
5 SOS Touch Key
6
Unlock Touch Key
7 Live View Touch Key
8 Management Center Touch Key
9
LCD Display Screen
10
Microphone
Figure 1-2 Rear Panel
Table 1-2 Components Description
No. Description
11
TF Card Slot
12
Serial Port
13
Mechanical Switch
14
Power Supply Indicator
15
Network Interface
16
Loudspeaker
z Hold the SOS touch key to trigger a SOS alarm and upload the alarm message to the
management center (the client software or the master station).
z The Unlock key (
) is valid only when does the indoor station speak with the door
station or open the live view of the door station.
Video Intercom Indoor Station·Quick Start Guide
2
1.2 Appearance of Type I 6-Series Indoor Station
Figure 1-3 Front Panel
Table 1-3 Components Description
No.
Description
1 Power Supply Indicator
2 Information Indicator
3 Alarm Indicator
4
SOS Key
5 Unlock Key
6 Live View Key
7 Management Center Key
8
LCD Display Screen
9
Microphone
Figure 1-4 Rear Panel
Table 1-4 Components Description
No. Description
10
Power Supply Interface
11
Network Interface
12
Terminals
13
Loudspeaker
z Hold the SOS touch key to trigger a SOS alarm and upload the alarm message to the
management center (the client software or the master station).
z The Unlock key (
) is valid only when does the indoor station speak with the door
station or open the live view of the door station.
Video Intercom Indoor Station·Quick Start Guide
3
1.3 Appearance of Type II and Type III 6-Series Indoor
Station
Figure 1-5 Front Panel
Table 1-5 Components Description
No.
Description
1
Power Supply Indicator
2 Information Indicator
3 Alarm Indicator
4 SOS Key
5 Unlock Key
6 Live View Key
7 Management Center Key
8
LCD Display Screen
9
Microphone
Figure 1-6 Rear Panel
Table 1-6 Components Description
No.
Description
10
Power Supply
11
Network Interface
12
Terminals
13
Loudspeaker
z Hold the SOS touch key to trigger a SOS alarm and upload the alarm message to the
management center (the client software or the master station).
z The Unlock key (
) is valid only when does the indoor station speak with the door
station or open the live view of the door station.
z For type III 6-series indoor station, there are different meanings when you press or
hold the four mechanical keys.
Loading...