H-1627
PORTABLE RADIO RECEIVER
ПОРТАТИВНЫЙ
РАДИОПРИЕМНИК
Руководство по эксплуатации Instruction manual
Instruction manual
Dear customer!
Thank you for purchasing our product. For safety, it is strongly recommended to read
this manual carefully before connecting, operating and/or adjusting the product and keep
the manual for reference in future.
Description
Front panel
1. button
2. MODE button
3. button
4. button
5. PRESET button
6. RPT(Repeat)/MEM Button
7. VOL- Button
8. VOL+ Button
9. USB port & SD/MMC card slot
Not shown on the picture:
• 3.5mm AUX-IN Jack
• Power ON/OFF Switch
• USB Charge port
• DC 5V Jack (for charging only)
• Battery compartment
• FM Telescopic Antenna
1
9
2
3
4
5
6
7
8
2
Instruction manual
Utilization of the product
If you want to dispose this product, do not
mix it with general household waste. There is a
separate collection system for used electronic
products in accordance with legislation that
requires proper treatment, recovery and
recycling.
Please contact your local authorities for
the correct method of disposal. By doing so,
you will ensure that your disposed product
undergoes the necessary treatment, recovery
and recycling and thus prevent potential
negative effects on the environment and
human health.
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration, direct
sunlight, too high or low temperature or humidity.
• If you are not going to use the unit within
a long period of time, remove the batteries to
avoid their leakage.
• Do not use the unit near TV sets,
computers, fluorescent lamps and other
electric equipment; this may jam AM reception.
• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel.
2.) Follow the polarity to install the
accompanied 3.7V lithium ion battery
3.) Replace the battery compartment door.
WARNING:
• Be sure that the battery is installed
correctly.
• Only batteries of the same or equivalent
type as recommend are to be used.
• If the unit is not to be used for an extended
period of time, remove the battery to prevent
damage or injury from possible battery
leakage.
• Do not dispose of the battery in fire, the
battery may explode or leak.
WARNING: The rechargable lithium ion
battery is a consumable and its malfunction is
not a warranty case.
AС operation
• The appliance is for household use only.
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Insert the power cord into the AC socket,
then connect its plug to the power supply.
General operations
Headphone socket
For private listening please insert the
earphones (not included) into the earphone
jack (the speaker inside the radio disconnects
automatically), now you can listen to the radio
by earphones.
Power supply
Power source
This unit is operated by 1pc 3.7V
rechargeable lithium ion battery (included).
Battery installation
To install the battery:
1.) Remove the battery compartment door.
Volume level
When listening to MP3 or radio press Vol- or
Vol+ Button to adjust the sound volume level.
Radio operation
• Slide the Power ON/OFF switch to ON
position to turn on the unit.
3
Instruction manual
• Press MODE button on the main unit until
FM icon appears on the display to enter Radio
mode.
• Press / button to fine tune the radio
frequency.
• Press and hold / button for
searching radio frequency automatically.
Preset Stations
The unit allows you to store up to 30 FM
stations for easy recall at any time.
• Tune to the radio station you want to store
in memory by using or button .
• Press RPT/MEM button, the memory
channel number ”P 01” will show on the
display, meanwhile, the Radio icon “FM”
flashes simultaneously
• Press / button to select the channel
number you desire to set.
• Press RPT/MEM button again to confirm
the preset location.
• Repeat steps 2-4 to store more stations if
necessary.
Antenna
Extend the telescopic antenna fully for best
reception.
Recalling Stored Preset Stations
1. Press PRESET button on the unit during
Radio mode to enter the radio memory
selecting mode.
2. Press / button to select the preset
channel.
USB/SD/MMC operation
Playback
• Connect your USB device or SD/MMC
card to the unit to access “USB” or “CARD”
mode, the relevant “USB” or “CARD” icon
appears on the display. The USB or SD/MMC
card will start playing automatically once the
contents scanning is finished.
• Press button to pause or resume
playback.
• Press VOL+ or VOL- button to raise up/
lower the volume level.
• Press button to skip to next track or
press button to the previous track.
• Press and hold or button to search
during the desired music.
• Press “RPT/MEM” button to change the
Repeat mode.
• To remove your USB device or SD/MMC
card, simply stop the playback and gently
unplug it from the connector.
According to the USB 1.1/2.0 Standard,
usage of a USB device with power current
consumption exceeding 500 mA is not
recommended without supplementary power
supply. Failure to use supplementary power for
connected USB drives with power consumption
exceeding this value as well as defective
USB drives may cause mechanical or thermal
changes of elements of this unit as well as
failure of internal elements of the USB port.
Such damages are not warrantee cases.
Warning: usage of external USB drives
containing BIN files in the root directory may
cause malfunction of the unit or damage to the
software.
AUX-IN (line in) operation
If you are using an iPod or other MP3/digital
audio player which can not plug in this unit
directly, you can still play it on the unit via an
audio connecting cable.
• Plug one end of the 3.5mm audio cable
(not included) into the headphone or line out
jack on your player, plug the other end of cable
into the unit AUX-IN jack of the unit.
• Turn on the external audio source and play
your device.
• Press MODE button until “AUX” icon
appears on the display.
• The volume level can now be controlled
through the main unit. Operate all other
functions on the external device as usual.
4