Hydra-Tech S8M User Manual
8” HYDRAULIC SUBMERSIBLE
AXIAL FLOW HIGH VOLUME PUMP
MODEL S8M
8” (200 mm) Discharge
The S8M offers a cost effective
solution for pumping high volumes
of water at low to medium heads.
This pump is great for retention
ponds, flood control, marine
salvage and many other jobs that
require quick and easy set-up.
FEATURES
High Volume Axial Flow design
•
High Efficiency mixed flow impeller
•
Small Overall Size allows for use in
•
tight spaces
Variable Speed hydraulic drive
•
Oil Lubricated Seals (can run dry)
•
Dependable gear type hydraulic motor
•
Safe Hydraulic Drive can be used
•
where electric power is hazardous or
impractical
Operates with our HT20 to HT35 power
•
units or other hydraulic power sources
capable of flows to 18 GPM
B0109
SPECIFICATIONS
WEIGHT:....................................................... 190 lbs. (86 kg)
HEIGHT:.............................................................. 31" (79 cm)
DIAMETER (@ widest point w/o flange):............ 17" (43 cm)
DISCHARGE:.............................. 8-5/8" O.D. Pipe or Flange
SOLIDS HANDLING:........................................... 1" (25 mm)
HOSE PORTS:....................................................... 3/4" NPT
HYDRAULIC COUPLINGS:................... 3/4" Wing Nut Style
PUMP BODY:......................................................... Cast Iron
IMPELLER:................................................................ Bronze
SHAFT:......................................................... Stainless Steel
SHAFT SEALS:.................................. Carbon/Ceramic (Std)
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:................................. Max. 18 GPM (68 LPM)
OPERATING PRESSURE:............ Max. 2800 PSI (190 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
Specifications are subject to change without notice
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
: www.hydra-tech.com E-Mail: htpump@hydra-tech.com
Model S8M Overall Dimensions
S8M Typical Performance
15 1/2"
(39 cm)
31"
(79 cm)
13 1/2"
8 5/8" Pipe O.D.
19 1/2" (49 cm) w/flange
Optional 8", 125# ASA Flange
17" (43 cm) w/o flange
U.S.G.P.M.
0
80
70
60
50
40
30
20
10
10
20
Cu.Mtr./Hr.
Feet
Meters
50
CAPACITY
TOTAL HEAD
HYDRAULIC INPUT:
(A) 12 GPM @ 1150 - 1650 PSI
(B)* 15 GPM @ 1750 - 2600 PSI
(C)** 16 -18 GPM @ 2800 PSI
* Typical performance when driven by
HT25 Power Unit.
** Maximum performance
A
B
C
2000
1800
1600
1400
1200
1000
800
600
400
200
150
100
450
400
350
250
300
200
Curves are based on pumping water at 60°F. For performance curves other than shown above, consult factory.
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
: www.hydra-tech.com E-Mail: htpump@hydra-tech.com
Loading...