Page 1
1 1/2” HYDRAULIC SUBMERSIBLE
SLIM-LINE PUMP
MODEL S1.5A
1 1/2” (38 mm) Discharge
The S1.5A is designed to be used as a
dewatering pump in areas where space
is limited . Typical uses for this pump
include manhole, vault, blasthole, mine
and construction jobsite dewatering.
FEATURES
Small Overall Size Allows Pump To Fit
•
Through 6" Diameter Opening
Oil Lubricated Seals (can run dry)
•
Variable Speed hydraulic drive
•
Stainless Steel Impeller resists wear
•
Rubber Coated Suction Case resists
•
abrasion
Safe Hydraulic Drive can be used where
•
electric power is hazardous or impractical
Dependable gear type hydraulic motor
•
Operates with our HT6 to HT13 power units
•
or other hydraulic power sources capable of
flows of 3-7 GPM
B0109
SPECIFICATIONS
WEIGHT: ............................................... 17 lbs. (8 kg)
HEIGHT:............................................. 15 1/2" (39 cm)
DIAMETER:....................................... 5 5/16" (14 cm)
DISCHARGE:.................................... 1 1/2 ", NPT(F)
SOLIDS HANDLING:................................1/4" (7 mm)
HOSE PORTS:...................................... 3/8" NPT (F)
PUMP BODY:............................. Anodized Aluminum
IMPELLER:........................................ Stainless Steel
SUCTION CASE: ................................. Rubber Lined
SHAFT:............................................... Stainless Steel
SHAFT SEAL:................................ Carbon / Ceramic
ELASTOMERS:..................................... Buna N (Std)
HYDRAULIC OIL:..... 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:........................ Max 7 GPM (26 LPM)
OPERATING PRESSURE:. Max 2000 PSI (136 Bar)
POWER SOURCE:..
Specifications are subject to change without notice
Any Open Center Hydraulic System
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
Page 2
Model S1.5A Overall Dimensions
HYDRAULIC INPUT:
(A)* 4.5 GPM @ 500-750 PSI
(B)** 6.5 - 6.9 GPM @ 1100-1450 PSI
*Typical performance with
HT6 Power Unit
**Typical performance with
HT13 Power Unit
0
165
150
135
120
105
90
75
60
45
30
15
153045
U.S.G.P.M.
Liters/Minute
Feet
Meters
90
CAPACITY
TOTAL HEAD
150
135
120
10590 7560453015
540
450
360
270
180
13 1/2"
(34 cm)
(39 cm)
15 1/2"
1-1/2"-9 NHT
Male thread
Top View
Return Press.
1 1/2" NPT(F) Discharge
3/8" NPT(F)
Hydraulic
Connections
5 5/16"
(14 cm)
S1.5A Typical Performance
Curves are based on pumping water at 60°F. For performance curves other than shown above, consult factory.
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website
Loading...