Hydra-Tech S6250 User Manual

10” HYDRAULIC SUBMERSIBLE
HIGH PERFORMANCE, SOLIDS HANDLING PUMP
MODEL S6250
10” (250 mm) Discharge
The S6250 is a Solids Handling Effluent Pump for use on jobs such as Waste Treatment, Sewer By-Pass, Barge Transfer, Municipal Lift Stations and Tank Pumping.
FEATURES
Balanced High Efficiency Two Vane
Closed Channel Impeller
Will pass 4" (100 mm) semi-solids
Variable Speed hydraulic drive provides
a wide range of performance
Oil Lubricated Seals (can run dry)
High Efficiency Balanced Vane
hydraulic motor
Can be bolted directly into a pipeline or
used as a booster pump
Safe Hydraulic Drive can be used where
electric power is hazardous or impractical
Operates with our HT100 to HT200
power units or other hydraulic power sources capable of flows of 50 - 90 GPM
C0413
SPECIFICATIONS
WEIGHT:..................................................... 739 lbs. (336 kg)
HEIGHT:............................................................ 43" (109 cm)
WIDTH (@ widest point):.................................... 32" (81 cm)
DISCHARGE:..................................... 10", 125# ASA Flange
INLET:................................................ 10", 125# ASA Flange
SOLIDS HANDLING:........................................ 4" (100 mm)
HOSE PORTS:......1-1/4" Code 61 Flange or 1-1/2" NPT (F)
PUMP BODY:...................................................... Ductile Iron
IMPELLER:.......................................................... Ductile Iron
WEAR RING........................................................ Ductile Iron
SHAFT:.............................................17-4 PH Stainless Steel
SHAFT SEAL:............................................... Silicon Carbide
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:................................. Max 90 GPM (340 LPM)
OPERATING PRESSURE:............. Max 2500 PSI (170 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
Specifications are subject to change without notice
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website: www.hydra-tech.com E-Mail: htpump@hydra-tech.com
Model S6250 Overall Dimensions
26"
8"
(66cm)
(20cm)
(81cm)
10", 125# ASA Flanges
32"
26"
43"
(66cm)
(48cm)
(109 cm)
18.7"
CAPACITY
0
220
200
180
160
140
120
100
80
60
40
20
20
40
60
U.S.G.P.M.
Cu. Mtr./Hr.
Feet
Meters
TOTAL HEAD
A
B
C
5000
4500
4000
3500
3000
2500
2000
1500
1000
500
5500
1000
600
800
400
200
1200
HYDRAULIC INPUT: A) 53 GPM
!!!!!Typical Performance with !!!! HT100 Power Unit
B) 70 GPM !!!Typical Performance with !!!!HT150 Power Unit C) 90 GPM !!!!Typical Performance with !!!!!HT200 Power Unit
S6250 Typical Performance
Curves are based on pumping water at 60°F. For performance curves other than shown above, consult factory.
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website: www.hydra-tech.com E-Mail: htpump@hydra-tech.com