Hydra-Tech S6105 User Manual
4” HYDRAULIC SUBMERSIBLE
HIGH PERFORMANCE,
SOLIDS HANDLING PUMP
MODEL S6105
4” (100 mm) Discharge
The S6105 is designed for applications
where high heads and the ability to
handle solids is required. A typical use
for this pump would be as a temporary
sewage lift station where force main
pressures are encountered.
FEATURES
Balanced High Efficiency Two Vane
•
Closed Channel Impeller
Will pass 3" (75 mm) semi-solids
•
Variable Speed hydraulic drive provides
•
a wide range of performance
Oil Lubricated Seals (can run dry)
•
High Efficiency Balanced Vane
•
hydraulic motor
Can be bolted directly into a pipeline or
•
used as a booster pump
Safe Hydraulic Drive can be used where
•
electric power is hazardous or
impractical
Operates with our HT100 to HT150
•
power units or other hydraulic power
sources capable of flows of 50 - 70 GPM
D0413
SPECIFICATIONS
WEIGHT:..................................................... 605 lbs. (276 kg)
HEIGHT:.............................................................. 36" (91 cm)
WIDTH (@ widest point):.................................... 25" (64 cm)
DISCHARGE:...................................... 4", 150# ANSI Flange
INLET:................................................. 4", 150# ANSI Flange
SOLIDS HANDLING:........................................... 3" (75 mm)
HOSE PORTS:......1-1/4" Code 61 Flange or 1-1/2" NPT (F)
PUMP BODY:...................................................... Ductile Iron
IMPELLER:.......................................................... Ductile Iron
WEAR RING........................................................ Ductile Iron
SHAFT:.............................................17-4 PH Stainless Steel
SHAFT SEAL:............................................... Silicon Carbide
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:................................. Max 70 GPM (265 LPM)
OPERATING PRESSURE:............. Max 2500 PSI (170 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
Specifications are subject to change without notice
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website: www.hydra-tech.com E-Mail: htpump@hydra-tech.com
Model S6105 Overall Dimensions
400
360
320
280
240
200
160
120
80
40
U.S.G.P.M.
Feet
Meters
40
80
120
TOTAL DYNAMIC HEAD
VOLUME
80
0
Cu. Mtr./Hr.
200
400
600
800
1000
1600
2000
1800
1400
1200
160
320
240
400
A
B
HYDRAULIC INPUT:
(A)40-50 GPM @ 2500 PSI Max.
!!!Typical Performance w/HT100 P/U
(B)60-70 GPM @ 2500 PSI Max.
!!!Typical Performance w/HT150 P/U
25"
4",150 lb. ANSI Flange
36"
(91 cm)
(64 cm)
21"
6"
(53 cm)
(15 cm)
S6105 Typical Performance
Curves are based on pumping water at 60°F. For performance curves other than shown above, consult factory.
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website: www.hydra-tech.com E-Mail: htpump@hydra-tech.com
Loading...