Hydra-Tech S10T User Manual

10” HYDRAULIC SUBMERSIBLE
VORTEX FLOW TRASH PUMP
MODEL S10T
10” (250 mm) Discharge
The S10T is designed to handle large solids and stringy material with its fully recessed Vortex impeller. Typical applications include sludge lagoons, sewage digester tanks and fish farms.
FEATURES
Recessed Vortex Impeller
(will pass 8" semi-solids)
Variable Speed hydraulic drive provides
a wide range of performance
Oil Lubricated Seals (can run dry)
High Efficiency Balanced Vane
hydraulic motor
Can be bolted directly into a pipeline or
used as a booster pump
Safe Hydraulic Drive can be used where
electric power is hazardous or impractical
Operates with our HT100 to HT150
power units or other hydraulic power sources capable of flows of 50 - 70 GPM
C0413
SPECIFICATIONS
WEIGHT:..................................................... 745 lbs. (346 kg)
HEIGHT:............................................................ 45" (114 cm)
WIDTH (@ widest point):........................... 42 1/2" (108 cm)
DISCHARGE:...................................... 10" 125# ASA Flange
INLET:.................................................. 10" 125# ASA Flange
SOLIDS HANDLING: (spherical semi-solids)................ 8" (20 cm)
HOSE PORTS:.................... 1 1/4" or 1 1/2" NPT(F) or SAE
PUMP BODY:..................................................... Ductile Iron
IMPELLER:......................................................... Ductile Iron
WEAR RING and PLATE:........................... ASTM A36 Steel
SHAFT:........................................... 17-4 PH Stainless Steel
SHAFT SEAL:............................................... Silicon Carbide
ELASTOMERS:................................................ Buna N (Std)
HYDRAULIC OIL:................ 214-320 s.s.u. @ 100°F (64°C)
INPUT FLOW:................................ Max 70 GPM (265 LPM)
OPERATING PRESSURE:............. Max 2800 PSI (190 Bar)
POWER SOURCE:....... Any Open Center Hydraulic System
Specifications are subject to change without notice
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061
Website: www.hydra-tech.com E-Mail: htpump@hydra-tech.com
Model S10T Overall Dimensions
42 1/2" (108 cm)
45" (114 cm)
42 1/2" (108 cm)
28" (71cm)
19 1/2" (49.5 cm)
CAPACITY
A) Typical Performance When Driven by 100 HP Power Unit
0 500 1000 1500 2000 2500 3000 3500 4000 4500 5000
110
100
90
80
70
60
50
40
30
20
10
10
20
30
U.S.G.P.M.
Cu. Mtr./Hr.
Feet
Meters
200 400 600 800 1000
TOTAL HEAD
B
A
B) Typical Performance When Driven by 150 HP Power Unit
S10T Typical Performance
Curves are based on pumping water at 60°F. For performance curves other than shown above, consult factory.
167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061 Website: www.hydra-tech.com E-Mail: htpump@hydra-tech.com