![](/html/ac/ac25/ac2590f5ae7d26be2ca66ec175f36f8d148a389a86c0e604c9a8d6a72e5806e3/bg1.png)
Installation • Operation • Care
Palm Beach™ Polysatin™ Shutters
PowerView® Motorization Insert
![](/html/ac/ac25/ac2590f5ae7d26be2ca66ec175f36f8d148a389a86c0e604c9a8d6a72e5806e3/bg2.png)
INSTALLATION
Battery Cover
Manual
Control
Button
Back side of rail
Now that you have completed your shutter installation, you are ready to program your
PowerView® Shutters.
Connect the Power Source
NOTE: When power is connected to the motor, a green LED inside the manual control button
housing will flash to indicate the louvers are ready for operation.
Remove the Battery Cover
NOTE: PowerView shutters with a divider rail or split tilt will have two battery wands, one in
the top rail and one in the bottom rail.
Remove the battery cover plate from
the top and/or bottom rail by sliding in
direction of the unlock icon indicated
on the battery cover.
Button
Back side of rail
Battery Cover
Plug the Power Cable into the Battery Wand
Locate the power cable inside the rail and plug it into the socket on the battery wand.
Place the battery pack into the clip
on the back of the battery cover.
Insert the battery cover into the rail
Clip
and secure it by sliding in the direction
of the lock icon indicated on the battery cover.
Testing the Louver Section
Testing the louver section with the manual
control button will allow you to ensure
that the motor and power source are
working correctly.
Press the manual control button
on the back side of the rail to test
operation. If the louvers do not
operate, see “Troubleshooting” on
page 5.
Socket
1
![](/html/ac/ac25/ac2590f5ae7d26be2ca66ec175f36f8d148a389a86c0e604c9a8d6a72e5806e3/bg3.png)
OPERATION
Using the PowerView® Remote
Refer to the illustration below to familiarize yourself with the controls on the remote. Activate
the remote by pulling both plastic tabs from the back battery compartment.
OPEN
Tilt louvers
to the open,
horizontal
position
Group 3
Group 2
Group 4
Group 5
Group 1
LEFT ARROW
Tilt louvers down
CLOSE
Tilt louvers to
the closed position
Group 6
Favorite
(Default set at 45 degrees open)
STOP
(Press and hold for
programming mode)
RIGHT ARROW
Tilt louvers up
IMPORTANT: If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView® Shade Network” in the PowerView Motorization Remote Control Guide.
Joining a Louver Section to a Group
IMPORTANT: The louver section will not operate using the remote until it has been joined to
a group.
NOTE: If multiple louver sections must be joined to a group, it is recommended that they be
in different groups for individual operation, as well as in the same group for simultaneous
operation. (Note that any louver section can belong to more than one group.) Louver sections
will also operate simultaneously if their individual group buttons are selected, or the “all”
button is selected.
1. Press and hold STOP on the remote until the indicator lights blink (approximately 6
seconds). The remote is now in program mode.
2. Press the desired group number (1 – 6) on the remote. The backlit group number will flash to
show it is selected.
3. While pressing the manual control button on the rail with the corresponding louver section,
press OPEN on the remote. The green light flashes once and the louvers will move
slightly to indicate the louver section has joined the group. Release the manual control
button.
4. Press and hold STOP on the remote until the indicator lights stop blinking (approximately
6 seconds).
2