Hunter Douglas Window Fashions RC4U2, RC4U User Manual

Mercury Operating Instructions

Channel Selector

Group 1

Group 3

Indicator LED

UP/DOWN

Group 2

Group 4

All

Operation

Individual Mode

• By default, the shade will function on Channel 1. Ensure that the Channel

Selector is switched to Channel 1 by moving it to the left position. (If Channel
2 is desired, switch the Channel Selector to the right position.)

• Point the remote control at the window covering you wish to control. Try to point

at the receiver of the window covering as much as possible. While pointing,
briefly press the
cause the desired shade to move continually in the desired direction. Note that the
Indicator LED lights red when pushing the UP or DOWN button. This
indicates that you are in Individual Mode.

UP or DOWN button as desired. A brief press of the button will

• To stop the shade, point the remote control at the window covering. While

pointing, press either the UP or DOWN button. Either one will stop the shade.

• If the shade is not stopped while moving, it will automatically stop at its end limit.

Group Mode

Please see programming instructions below before attempting to use the Group Mode.

• In order to operate a group, the desired Group button must be pushed (Group 1,

Group 2, Group 3, or Group 4). Note that the Indicator LED lights green

after the Group button is pushed. This indicates that the remote is in Group
Mode. It will stay in this mode with the green Indicator LED for three seconds,
and then return to Individual Mode.

• While in Group Mode, press the UP or DOWN button to operate the window

covering group as desired. A brief press of the button will cause the group of
window coverings to move continually in the desired direction. Note that the
Indicator LED is still green and that the remote will remain in Group Mode for
three seconds after operation.

• To stop the group, enter the desired Group Mode as described above. Press either

the UP or DOWN button. Either one will stop the shade.

• If the shade is not stopped while moving, it will automatically stop at its end limit.

• All Functionality

o All of the window coverings included in groups may be controlled

simultaneously via the

o Use the ALL button just as the Group buttons are used. Press the ALL

button briefly, and then press the UP or DOWN button as desired.

o Every shade that currently belongs to a group will operate as commanded.

• Note that pointing is not necessary to control groups. Control of window

coverings in groups is possible in other rooms or areas out of the line of sight of
the remote control.

ALL Button.