Huffy 89780 User Manual
1
P/N 211487C 04/02
Customer Service
N53 W24700 South Corporate Circle
Sussex, WI 53089
U.S.A.
A Huffy Company
IMPORTANT!
To ensure prompt and correct handling of any problems, or to answer any questions, please contact the Sample
and Display Technician at 1-800-558-5234.
REQUIRED TOOLS AND
MATERIALS:
• Wrenches: (Two each) 7/16”, 1/2”, 9/16”,
and 3/4” or Pliers
• 3/16” Allen Wrench
• Step Ladder, 8 ft. (2.4 m)
Model 89780
SAFETY INSTRUCTIONS
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY
RESULT IN SERIOUS INJURY,
PROPERTY DAMAGE AND WILL VOID WARRANTY.
This unit is intended for display purposes only and
should not be used for play.
To ensure safety, do not attempt to assemble this system without
following the instructions carefully. Check entire box and inside all
packing material for parts. Before beginning assembly, read the
instructions and identify parts in this document. Proper and
complete assembly, use and supervision is essential for proper
operation and to reduce the risk of accident or injury. A high
probability of serious injury exists if this system is not installed,
maintained, and operated properly.
• During assembly, if using a ladder use extreme caution. Two
people are recommended for this operation.
• If technical assistance is required, contact Huffy Sports’ Sample
and Display Technician.
• Serious injury could occur if teeth/face come in contact with
backboard, net or rim.
• Display recommended for 3” (7.6 cm) or 3-1/2” (9 cm) Round or 4”
(10 cm) Square poles only.
• All instructions and warnings MUST accompany any display item
that is sold.
Most injuries are caused by misuse and/or not following
instructions.
Use caution when installing this unit.
Internet Address: http://www.huffysports.com
BASKETBALL
CENTER
BASKETBALL
CENTER
P/N 211487C 04/02
2
PARTS LIST
Item Qty. Part No. Description
1 2 203257 Zip Tie
2 4 207103 Pole Cap for 3.5” Pole Section
3 26 203100 Nut, Hex Flange 5/16-18*
4 6 204872 Height, Decal
5 8 201611 Bolt, Hex Flange, 5/16-18 x 3”
6 16 203218 Washer, Flat, 5/16*
7 8 200516 Bolt Cover, Vinyl*
8 4 200863 POP Header Cards
9 6 200892 Plastic Push Clips
10 4 900013 3.5” Pole Section
11 1 200862 POP Insert
* YOU MAY HAVE EXTRA HARDWARE
3
P/N 211487C 04/02
Move display to location on sales floor and
remove 2 X 4 runners under feet.
P.O.P.
Install pegboard panels onto
corresponding side support
railings. Secure with zip tie to
temporarily hold panel in place.
Remove zip ties after assembly is
complete. Attach P.O.P. sign (11)
with plastic push clips (9) so that it
faces aisle as shown.
FRONT
9
11
1
2
Loading...