HuddleCamHD PTZ CAMERA Installation Manual

Please check HUDDLECAMHD.com for
the most up to date version of this document Ver 1.6 11/20

HuddleCamHD 3x

USB 2.0 PTZ CAMERA

INSTALLATION & OPERATION MANUAL

Page 1 of 15

Ver 1.6 11/20

Precautions………………………………………………………………………………………….

Safety Tips…………………………………………………………………………………………….

• Please read this manual carefully before using the camera.

• Avoid damage from stress, violent vibration or liquid intrusion during

transportation, storage or installation.

• Take care of the camera during installation to prevent damage to the camera

case, ports, lens or PTZ mechanism.

• Do not apply excessive voltage. (Use only the specified voltage.) Otherwise, you

may experience electrical shock.

• Keep the camera away from strong electromagnetic sources.

• Do not aim the camera at bright light sources (e.g. bright lights, the sun, etc.) for

extended periods of time.

• Do not clean the camera with any active chemicals or corrosive detergents.

• Do not disassemble the camera or any of the camera's components. If problems

arise, please contact your authorized dealer.

• After long term operation, moving components can wear down. Contact your

authorized dealer for repair.

In the Box………………………………………………………………………………………….

Supplied Equipment…………………………………………………………………………….

• 3x Zoom USB 2.0 HD Video Conference Camera

• 12V/2.0A DC Power Adapter

• USB 2.0 A-B cable (16ft / 4.9m)

• RS-232C Serial Control cable

• RS-232C to RS-485 adaptor cable

• Wall Mount

• IR Remote Controller

• Quick Start Guide

Page 2 of 15

Ver 1.6 11/20

Physical Description…………………………………………………………………………

1. Front View…………………………………………………………………………………….

1. Lens

2. IR Receiver

To receive IR remote controller signal.

3. Power LED

Blue LED lights when unit is powered, LED is dark for Stand-By status.

4. IR Receiver

To receive IR remote controller signal.

1 2 4

3

Page 3 of 15

Ver 1.6 11/20

2. Rear View……………………………………………………………………………………

5. USB 2.0 Interface

For connection to PC (USB 2.0 port. Will also function in a USB 3.0 port as USB 2.0
device).

6. DC12V In Socket

Only use the power adapter supplied with this camera.

7. IR Receiver

To receive IR remote controller signals.

8. RS232 IN Port

For hard wired remote control from a 3

rd

party PC, joystick, etc...

9. RS485 IN Port

For hard wired remote control from a 3

rd

party PC, joystick, etc...

5

6 7 8

9

Page 4 of 15

Ver 1.6 11/20

3. Bottom View…………………………………………………………………………………

1. Tripod / Wall Mount / Ceiling Mount

Will accept 1/4-20 bolt from 3rd party tripod, wall or ceiling mount.