Page 1
INSTALLATION INSTRUCTIONS - TRUNNION SHEET 1 OF 2
SAVE THESE INSTRUCTIONS
INSTALLATION
INSTRUCTIONS
TRUNNION
ACCESSORY
READ THOROUGHLY BEFORE INSTALATION
WARNING!
Failure to do so may increase the
use so fixture failures do not cause a hazard and use only in environments for which the product is specifically marked.
WARNING!
reproductive harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION!
luminaire operation and burning position. Luminaire label shows electrical and environmental requirements and
restrictions.
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before servicing.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any
work, contact your Hubbell Lighting distributor or techsupport@hubbell-ltg.com or (864) 678-1000
Give instructions to facility owner/manager for future reference.
Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes.
RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH.
This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other
Follow ALL luminaire recommendations, product markings, instructions, restrictions and warnings regarding
Install and
WARNINGS:
Dangerous voltage exist within the unit and all precautions usually observed in handling high voltage equipment should be observed
when replacing light engine or otherwise servicing luminares. Disregarding this warning could result in electrical shock and possible
injury to the individual installing or servicing this equipment. Installation and servicing should be done by qualified personnel.
Tools Required:
#2 Phillips Head Screwdriver
•
7/16in. Nut Driver, Wrench, or Socket
•
93062470 Rev.A
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
www.hubbelloutdoor.com
Page 2
INSTALLATION INSTRUCTIONS - TRUNNION SHEET 2 OF 2
SAVE THESE INSTRUCTIONS
Electrical Connections
RISK OF SHOCK
•
POWER MUST BE OFF
•
Trunnion Installation
If mounting hardware is present, remove from luminaire fixture.
1.
Remove the trunnion cover from the housing by loosening the three screws on the cover.
2.
Route black, white, and green wire leads from luminaire through the open trunnion housing. (See Fig. 1)
3.
Loosely attach trunnion housing to luminaire with provided fastener.
4.
Set the luminaire to the desired mounting angle by rotating the trunnion housing.
5.
Tighten the provided fastener to lock the luminaire at the desired angle.
6.
Splice the branch circuit power leads to the fixture power leads, black to black (hot), white to white (neutral), and green to
7.
green (ground). SO Cord size 16/3. (Fig. 1)
Replace the trunnion cover to the trunnion housing and tighten screws. (Fig. 2)
8.
Trunnion
Housing
(Step #7)
(Be careful not to pinch any wires during attachment.)
(Be careful not to pinch any wires.)
Trunnion Cover
Fastener
Luminaire
(Step #3)
Fig. 1
Cord Entry -
Supplied with Bushing
(16/3 Cord)
Ground
Screw
Splice Area
(Circuit power leads
to Fixture leads)
NOTES:
Contact Hubbell Lighting for any replacement parts.
Contact your local distributor or agent to confirm parts availability prior to ordering replacement parts.
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000
www.hubbelloutdoor.com
Fig. 2
Loading...