HTC 0PM9310 User Manual
Product
Safety &
Warranty
Information
2 Safety and regulatory guide
Please read before proceeding
THE BATTERY IS NOT FULLY CHARGED WHEN YOU TAKE THE DEVICE OUT OF THE
BOX.
YOUR WARRANTY IS INVALIDATED IF YOU DISASSEMBLE OR ATTEMPT TO
DISASSEMBLE THE DEVICE.
Privacy restrictions
Some countries require full disclosure of recorded telephone conversations.
Important health information and safety precautions
When using this product, the safety precautions below must be taken to avoid possible
legal liabilities and damages.
Retain and follow all product safety and operating instructions. Observe all warnings in
the operating instructions on the product.
To reduce the risk of bodily injury, electric shock, fire, and damage to the equipment,
observe the following precautions.
Electrical safety
This product is intended for use when supplied with power from the designated battery
or power supply unit. Other usage may be dangerous and will invalidate any approval
given to this product.
Safety precautions for proper grounding installation
CAUTION:
Connecting to improperly grounded equipment can result in an electric
shock to your device.
This product is equipped with a USB Cable for connecting with desktop or notebook
computer. Be sure your computer is properly grounded (earthed) before connecting
this product to the computer. The power supply cord of a desktop or notebook
computer has an equipment-grounding conductor and a grounding plug. The plug
must be plugged into an appropriate outlet which is properly installed and grounded in
accordance with all local codes and ordinances.
Safety precautions for power supply unit
Use the correct external power source
A product should be operated only from the type of power source indicated on the
electrical ratings label. If you are not sure of the type of power source required,
consult your authorized service provider or local power company. For a product that
operates from battery power or other sources, refer to the operating instructions
that are included with the product.
This product should be operated only with the following designated power supply
unit(s).
AC adapter:
HTC, TC U250
Handle battery packs carefully
This product contains a Lithium-ion polymer or Lithium-ion battery. There is a risk of
fire and burns if the battery pack is handled improperly.
Safety and regulatory guide 3
WARNING:
To reduce risk of fire or burns, do not disassemble,
crush, puncture, short external contacts or circuits, expose to
temperature above 60° C (140° F), or dispose of in fire or water.
Recycle or dispose of used batteries according to the local
regulations or reference guide supplied with your product.
Take extra precautions
Keep the battery dry and away from water or any liquid as it may cause a short
circuit.
The phone should only be connected to products that bear the USB-IF logo or have
completed the USB-IF compliance program.
Only use the battery with a charging system that has been qualified with the system
per this standard, IEEE-Std-1725. Use of an unqualified battery or charger may
present a risk of fire, explosion, leakage or other hazard.
Avoid dropping the phone. If the phone or battery is dropped, especially on a hard
surface, and the user suspects damage, take it to a service centre for inspection.
If the battery leaks:
Do not allow the leaking fluid to come in contact with skin or clothing. If already in
contact, flush the affected area immediately with clean water and seek medical
advice.
Do not allow the leaking fluid to come in contact with eyes. If already in contact, DO
NOT rub; rinse with clean water immediately and seek medical advice.
Take extra precautions to keep a leaking battery away from fire as there is a danger of
ignition or explosion.
Safety precautions for direct sunlight
Keep this product away from excessive moisture and extreme temperatures. Do not
leave the product inside a vehicle or in places where the temperature may exceed 60°C
(140°F), such as on a car dashboard, window sill, or behind glass that is exposed to
direct sunlight or strong ultraviolet light for extended periods of time. This may
damage the product, overheat the battery, or pose a risk to the vehicle.
Prevention of hearing loss
This device and earphone have been tested to comply with the Sound Pressure Level
requirement laid down in the applicable EN 50332-1 and/or EN 50332-2 standards.
Using Your Phone While Flying
Use of cell phones may be restricted on aircraft. Please check with your airline to see
what restrictions may apply. You may be required to turn off your phone at certain
times. Use of your phone’s cellular connection and use of your phone for voice
communications may be prohibited by law or airline policy. For your safety and the
CAUTION:
Permanent hearing loss may occur if earphones or
headphones are used at high volume for prolonged periods of time.
4 Safety and regulatory guide
safety of other passengers, always follow crew instructions regarding the use of your
phone.
Environment restrictions
Do not use this product in gas stations, fuel depots, chemical plants or where blasting
operations are in progress, or in potentially explosive atmospheres such as fuelling
areas, fuel storehouses, below deck on boats, chemical plants, fuel or chemical transfer
or storage facilities, and areas where the air contains chemicals or particles, such as
grain, dust, or metal powders. Please be aware that sparks in such areas could cause an
explosion or fire resulting in bodily injury or even death.
When in any area with a potentially explosive atmosphere or where flammable
materials exist, the product should be turned off and the user should obey all signs and
instructions. Users are advised not to use the equipment at refueling points such as
service or gas stations, and are reminded of the need to observe restrictions on the use
of radio equipment in fuel depots, chemical plants, or where blasting operations are in
progress.
Road safety
When behind the wheel, driving safely should always be your first priority. According to
the National Highway Traffic Safety Administration (NHTSA), scientific research
indicates that using a wireless phone while driving degrades a driver’s performance,
whether used in a hands-free or hand-held mode. NHTSA advises that the “safest
course of action is to refrain from using a cell phone while driving.” NHTSA’s policy on
“Cell Phone Use While Driving,” as well as Frequently Asked Questions on the subject,
are available at www.nhtsa.gov. For your safety and the safety of those around you,
please consider turning your phone off while you are driving.
If you choose to use your phone while driving, be aware that some state and local
governments have adopted laws governing the use of wireless devices while driving. It
is your responsibility to know and comply with the laws in your area
Safety precautions for RF exposure
Avoid using your phone near metal structures (for example, the steel frame of a
building).
Avoid using your phone near strong electromagnetic sources, such as microwave
ovens, sound speakers, TV and radio.
Use only original manufacturer-approved accessories, or accessories that do not
contain any metal.
Use of non-original manufacturer-approved accessories may violate your local RF
exposure guidelines and should be avoided.
Hearing aids
Some digital wireless phones may interfere with some hearing aids. In the event of such
interference, you may want to consult your service provider, or call the customer
service line to discuss alternatives.
Electrical safety
Accessories
Use only approved accessories.
Do not connect with incompatible products or accessories.
Connection to a car
Safety and regulatory guide 5
Seek professional advice when connecting a phone interface to the vehicle electrical
system.
Faulty and damaged products
Do not attempt to disassemble the phone or its accessory.
Only qualified personnel must service or repair the phone or its accessory.
General precautions
You alone are responsible for how you use your phone and any consequences of its use.
You must always switch off your phone wherever the use of a phone is prohibited. Use
of your phone is subject to safety measures designed to protect users and their
environment.
Avoid applying excessive pressure to the device
Do not apply excessive pressure on the screen and the device to prevent damaging
them. It is also recommended that you store the device in a protective case and only
use your finger when interacting with the touch screen. Cracked display screens due
to improper handling are not covered by the warranty.
Protect your phone
Always treat your phone and its accessories with care and keep them in a clean and
dust-free place.
Do not expose your phone or its accessories to open flames or lit tobacco products.
Do not drop, throw or try to bend your phone or its accessories.
Do not use harsh chemicals, cleaning solvents, or aerosols to clean the device or its
accessories.
Do not paint your phone or its accessories.
Do not attempt to disassemble your phone or its accessories, only authorised
personnel must do so.
Store your phone or its accessories at temperatures between 0° C to 40° C.
Please check local regulations for disposal of electronic products.
Do not carry your phone in your back pocket as it could break when you sit down.
Damage requiring service
Unplug the product from the electrical outlet and refer servicing to an authorized
service technician or provider under the following conditions:
The product has been exposed to rain or liquid, dropped, subject to impact or
damaged.
There are noticeable signs of overheating.
The product does not operate normally when you follow the operating instructions.
Avoid hot areas
The product should be placed away from heat sources such as radiators, heat
registers, stoves, or other products (including amplifiers) that produce heat.
Avoid wet areas
Never use the product in rain, or near washbasins or other wet or high humidity
locations. If your product gets wet, do not try to dry the product with the use of an
oven or dryer, as this may damage your product.
Avoid using your device after a dramatic change in temperature
When you move your device between environments with very different temperature
and/or humidity ranges, condensation may form on or within the device. To avoid
damaging the device, allow sufficient time for the moisture to evaporate before using
6 Safety and regulatory guide
the device.
NOTICE:
When taking the device from low-temperature conditions into a warmer
environment or from high-temperature conditions into a cooler environment, allow
the device to acclimate to room temperature before turning on power.
Avoid pushing objects into product
Never push objects of any kind into cabinet slots or other openings in the product.
Slots and openings are provided for ventilation. These openings must not be blocked
or covered.
Adjust the volume
Turn down the volume before using headphones or other audio devices.
Cleaning
Unplug the product from the wall outlet before cleaning. Do not use liquid cleaners or
aerosol cleaners. Use a damp cloth for cleaning, but NEVER use water to clean the
LCD screen.
Small children
Do not leave your phone and its accessories within the reach of small children or
allow them to play with it. They could hurt themselves or others, or could accidentally
damage the phone. Your phone contains small parts with sharp edges that may
cause an injury or which could become detached and create a choking hazard.
Consult the doctor immediately if the accessories or battery are swallowed.
Repetitive motion injuries
To minimise the risk of RSI, when Texting or playing games with your phone:
Do not grip the phone too tightly
Press the buttons lightly
Electrostatic discharge (ESD)
Do not touch the SIM card’s metal connectors.
Emergency calls
This phone, like any wireless phone, operates using radio signals, which cannot
guarantee connection in all conditions. Therefore, you must never rely solely on any
wireless phone for emergency communications.
Regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of
0PM9310(HTCD200L).
Your phone’s FCC ID is
back of the device.
To ensure continued reliable and safe operation of your device use only the HTC
qualified battery with your
B0PKX100
.
Operating temperature range: 32°F to 104°F (0°C to 40°C)
NOTE:
This product is intended for use with a certified Class 2 Limited Power Source,
rated 5 Volts DC, maximum 1.0 Amp power supply unit.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
NM80PM9310
. This FCC ID can also be found printed on the
0PM9310(HTCD200L)
: Battery Pack, model number
Safety and regulatory guide 7
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
FCC Hearing-Aid Compatibility (HAC) Regulations for Wireless Devices
The FCC has adopted rules to ensure reasonable access to telecommunications
services for persons with hearing disabilities. As part of this effort, the industry uses a
rating system for wireless phones to help hearing device users find phones that may be
compatible with their hearing devices (hearing aids and cochlear implants). This
hearing-aid compatibility (HAC) rating system is described in the American National
Standards Institute (ANSI) C63.19 standard and includes the following ratings:
M-Ratings:
operating in teleco il mode.
are likely to generate less radio frequency interference with hearing devices than
phones with lower ratings. M4 is the better/higher of the two ratings. Your
rated
T-Ratings:
telecoil mode.
more usable with a hearing aid’s telecoil than phones that are not rated. T4 is the
better/higher of the two ratings. Your
This phone has been tested and rated for use with hearing aids for some of the wireless
technologies that it uses. However, there may be some newer wireless technologies
used in this phone that have not been tested yet for use with hearing aids. It is
important to try the different features of this phone thoroughly and in different
locations, using your hearing aid or cochlear implant, to determine if you hear any
interfering noise. Consult your service provider or the manufacturer of this phone for
information on hearing aid compatibility. If you have questions about return or
exchange policies, consult your service provider or phone retailer.
The ratings are not guarantees. Trying out the phone with your hearing device is the
best way to evaluate it for your personal needs. Results will vary depending on a user’s
hearing device and hearing loss. For example, if some wireless phones are used near
some hearing devices, users may detect a buzzing, humming, or whining noise. Some
hearing devices are more immune than others to this interference noise, and phones
also vary in the amount of interference they generate. If your hearing device happens
to be vulnerable to interference, you may not be able to use a rated phone successfully.
Please power off the Bluetooth function while using hearing aid devices with your
0PM9310
For phones that use acoustic coupling with hearing devices that are not
M4.
For phones that use inductive coupling with hearing devices operating in
Phones rated T3 or T4 meet FCC HAC requirements and are likely to be
.
Phones rated M3 or M4 meet FCC HAC requirements and
0PM9310
is rated
T4.
0PM9310
is
Loading...