Page 1
Hard Drive
Installation Instructions
for HP ProLiant BL260c Generation 5 Server Blades
Overview
Use these instructions to install up to two SATA hard drives in the
server blade.
Kit contents
• Hard drive
• This document
Installing a hard drive
WARNING: To reduce the risk of personal injury from hot
surfaces, allow the drives and the internal system
components to cool before touching them.
To install the component:
1. Power down the server blade.
2. Remove the server blade.
3. Remove the access panel.
4. Disconnect all hard drive cables from the system board,
if installed.
5. Remove the hard drive cage/bezel assembly.
© Copyright 2008 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
Part Number 466520-001
February 2008 (First Edition)
6. Open the hard drive cage.
Page 2
7. Install the hard drive.
10. Install the four T-15 screws.
8. Connect the cable to the hard drive and close the hard
drive cage.
9. Locate the T-15 screws on the hard drive cage/bezel assembly.
11. Install the hard drive cage/bezel assembly.
12. Route and connect the hard drive data and power cable to the
system board.
13. Install the access panel.
14. Install the server blade.
15. Determine the status of the hard drive from the hard drive
activity LED. For more LED information, see the server user
guide on the HP website (http://www.hp.com/support
The installation is complete.
).
Page 3
Regulatory compliance notices
European Union regulatory notice
This product complies with the following EU Directives:
• Low Voltage Directive 2006/95/EC
• EMC Directive 2004/108/EC
Compliance with these directives implies conformity to applicable
harmonized European standards (European Norms) which are listed
on the EU Declaration of Conformity issued by Hewlett-Packard for
this product or product family.
This compliance is indicated by the following conformity marking
placed on the product:
This marking is valid for non-Telecom products and EU harmonized
Telecom products (e.g. Bluetooth).
This marking is valid for EU non-harmonized Telecom products.
*Notified body number (used only if applicable—refer to the
product label)
Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140,
71034 Boeblingen, Germany
Korean class A notice
Loading...