HP Slate 7 2800, Compaq Presario SR5618CF, Compaq Presario SR5611CF, Compaq Presario SR5612CF Regulatory, Safety and Environmental Notices

Regulatory, Safety and
Environmental Notices

Regulatory notices for tablet computers

This document provides country- and region-specific non-wireless and wireless regulatory notices and compliance
information for the tablet product. Some of these notices may not apply to your product.
One or more integrated wireless devices may be installed. In some environments, the use of wireless devices may be
restricted. Such restrictions may apply on-board airplanes, in hospitals, near explosives, in hazardous locations, and so
on. If you are uncertain of the policy that applies to the use of this product, ask for authorization to use it before you turn
it on.
Regulatory markings for your country or region may be located on the bottom of the product, either under the battery,
under a user-removable door (or some other user-accessible location), or on the wireless or modem module.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in
compliance with the FCC RF exposure guidelines. SAR information on this model is on file with the FCC and can be found
under the Display Grant section of http://www.fcc.gov/oet/ea/fccid.

Ä CAUTION: Devices not for sale or use in the United States may not have an FCC ID.

Federal Communications Commission notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures.

■ Reorient or relocate the receiving antenna.

■ Increase the separation between the equipment and receiver.

■ Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

■ Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly
approved by HP may void the user’s authority to operate the equipment.

Cables

To maintain compliance with FCC Rules and Regulations, connections to this device must be made with shielded cables
having metallic RFI/EMI connector hoods.

Declaration of Conformity for products marked with the FCC logo (United States only)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 2 conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired
operation.

If you have questions about the product that are not related to this declaration, write to

Hewlett-Packard Company
950 W. Maude Avenue
Sunnyvale, CA 94085

For questions regarding this FCC declaration, call HP at 281-514-3333.
For general questions about the product, call 1-800-HP-INVENT (1-800-474-6836).
To identify your product, refer to the part, series, or model number located on the product.

Products with wireless LAN devices or HP Mobile Broadband Modules

This device must not be co-located or operating in conjunction with any other antenna or transmitter.

Å WARNING! Exposure to Radio Frequency Radiation: The radiated output power of this device is below the FCC radio

frequency exposure limits. Nevertheless, the device should be used in such a manner that the potential for human
contact is minimized during normal operation.
The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC is 1.6 W/Kg. Tests for SAR are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the device while
operating can be well below the maximum value. This is because the device is designed to operate at multiple
power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless
base station antenna, the lower the power output. To avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna should be minimized. This device has been tested and
demonstrated compliance when Bluetooth and WiFi are transmitting simultaneously.

1

Brazil notice

Este equipamento opera em caráter secundário, isto é, não tem direito a proteção contra interferência prejudicial,
mesmo de estações do mesmo tipo, e não pode causar interferência a sistemas operando em caráter primário.
Este equipamento atende aos limites de Taxa de Absorção Específica referente à exposição a campos elétricos,
magnéticos e eletromagnéticos de radiofreqüências adotados pela ANATEL

Canada notices

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations, CAN
ICES-3(B)/NMB-3(B). If this device has WLAN or Bluetooth capability, the device complies with Industry Canada
licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.

L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.

Å WARNING! Exposure to Radio Frequency Radiation: The radiated output power of this device is below the Industry

Canada radio frequency exposure limits. Nevertheless, the device should be used in such a manner that the
potential for human contact is minimized during normal operation.
The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate,
or SAR. The SAR limit set by the FCC is 1.6 W/Kg. Tests for SAR are conducted using standard operating positions
accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR level of the device while
operating can be well below the maximum value. This is because the device is designed to operate at multiple
power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless
base station antenna, the lower the power output. To avoid the possibility of exceeding the FCC radio frequency
exposure limits, human proximity to the antenna should be minimized. This device has been tested and
demonstrated compliance when Bluetooth and WiFi are transmitting simultaneously.

European Union regulatory notices

Declaration of Conformity

The telecommunications functionality of this product may be used in the following EU and EFTA countries: Austria,
Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland,
Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania,
Slovak Republic, Slovenia, Spain, Sweden, Switzerland, and United Kingdom.
Products bearing the CE marking comply with one or more of the following EU Directives as may be applicable:
Low Voltage Directive 2006/95/EC; EMC Directive 2004/108/EC; Ecodesign Directive 2009/125/EC; R& TTE Directive
1999/5/EC; RoHS Directive 2011/65/EU
Compliance with these directives is assessed using applicable European Harmonised Standards.
The full Declaration of Conformity can be found at the following web site: http://www.hp.eu/certificates (Search with the
product model name or its Regulatory Model Number (RMN), which may be found on the regulatory label.)
The point of contact for regulatory matters is Hewlett-Packard GmbH, Dept./MS:HQ-TRE, Herrenberger Strasse 140,
71034 Boeblingen, GERMANY.

Products with wireless modules (EMF)

THIS DEVICE MEETS INTERNATIONAL GUIDELINES FOR EXPOSURE TO RADIO FREQUENCY RADIATION.
The wireless module in your tablet computer is a radio transmitter and receiver. The device is designed not to exceed the
limits for exposure to radio frequency (RF) recommended by international guidelines (ICNIRP). These limits are part of
comprehensive guidelines that establish permitted levels of RF radiation for the general population. The guidelines were
developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The
device also meets the European R&TTE directives, including the protection of the health and the safety of the user and
any other person.
The exposure standard for mobile devices employs a unit of measurement known as the Specific Absorption Rate (SAR).*
The SAR was obtained by testing the device at standard operating positions with the device transmitting at its highest
certified power level in all tested frequency bands. The actual SAR of the device while operating can be well below the
maximum value, because the device operates at multiple power levels and uses only the power required to reach the
network.
When installed in the tablet computer, this device meets RF exposure guidelines when the antennas are positioned at a
minimum distance from the body. In order to transmit data or messages, this device requires a quality connection to the
network. In some cases, transmission of data or messages may be delayed until such a connection becomes available.

2