HP Bluetooth Stereo Headphones User Manual

User’s Guide

HP iPAQ Bluetooth Stereo Headphones

Document Part Number: 378962-001

November 2004

© 2004 Hewlett-Packard Development Company, L.P.

Microsoft and Windows are trademarks of Microsoft Corporation in the
U.S. and/or other countries. Intel is a trademark of Intel Corporation in
the U.S. and/or other countries.

The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.

User’s Guide
HP iPAQ Bluetooth Stereo Headphones
First Edition (November 2004)
Document Part Number: 378962-001

CAUTION: Do not wear HP iPAQ Bluetooth Stereo Headphones
while operating a motor vehicle or in an area in which it is
dangerous for your hearing to be impaired.

Getting to Know Your HP iPAQ Bluetooth Stereo Headphones

Button Function

Forward Tap to track forward to the next media file in the

playlist.

Back Tap to track backward to the previous file in the

playlist.

Volume Up Press to increase the volume in the headphones.

Volume down Press to decrease the volume in the headphones.

Multi Function • Press and hold for fifteen seconds to put

headphones in pairing mode.

• Press and hold for three seconds to turn
headphones on or off.

• Press to pause/unpause audio.

• After initial Bluetooth pairing, press to reestablish
connection.

HP iPAQ Bluetooth Stereo Headphones User’s Guide 3

Installing the Headphones Driver

1. Perform a soft reset on your HP iPAQ Pocket PC by pressing
the Reset button on the back or bottom of the device. For
more information on performing a soft reset, refer to the
User’s Guide that came with your HP iPAQ Pocket PC.

2. Backup your iPAQ Pocket PC using ActiveSync before
installing the Headphones driver.

3. If the Bluetooth Radio on your Pocket PC is on, turn it off.

4. Establish a connection from your iPAQ Pocket PC to your
desktop computer via ActiveSync. Refer to the User’s Guide
that came with your iPAQ Pocket PC for instructions.

5. Place the CD that came with your HP iPAQ Bluetooth Stereo
Headphones into an optical drive on your computer.

6. Click the button that reads “Click Here to Install Software”
and follow the instructions on your screen. If asked to reset
your Pocket PC, tap Reset Now.

7. Once the unit is reset, the driver is installed.

Pairing the Headphones with a Pocket
PC

Before you can use the HP iPAQ Bluetooth Stereo Headphones,
you must first pair them with an iPAQ Pocket PC with Bluetooth.
To pair your headphones to a Pocket PC:

1. Make sure the batteries are charged on both the headphones
and the HP iPAQ Pocket PC.

2. Make sure the headphones are turned off by pressing the
Multi Function button in the center of the right earpiece of the
headphones for about three seconds until the light flashes red
and goes off.

HP iPAQ Bluetooth Stereo Headphones User’s Guide 4

3. On your Pocket PC, tap the iPAQ Wireless icon on the

bottom right of the screen or, for older models, tap the

Bluetooth icon

4. Turn on the Bluetooth Radio by tapping the Bluetooth icon.
For older iPAQ Pocket PCs, turn on the Bluetooth Radio by
tapping selecting “Turn Bluetooth ON” from the dropdown
box in the bottom right corner of the screen.

HP iPAQ Bluetooth Stereo Headphones User’s Guide 5