Howdens LAM9500 Installation Instructions Manual

Contents

LAM9500 Downdraft hob in 950
deep island

Installation Instructions

A B

Rigid

Installation Instructions

NOTE: THIS APPLIANCE IS DESIGNED FOR RECIRCULATION INSTALLATION ONLY

1. Remove the rear right foot from the base cabinet.

C D

290mm575mm

1000 Wall unit

1000 Base unit

Ducting routing

Ducting kit should be placed within the service void.

1000 Wall unit

A

Rigid cut to length

C

B

Flexi

Carbon filter

under plinth

A

1000 Base unit

LAM9500 Page 1

D

Fan under plinth

2. The back wall of the base cabinet and top rails require cutting prior to joining to the wall cabinet.

20mm

105mm

515mm

230mm

170mm

110mm

3. The rear and base of the wall cabinet will need to
be cut using the template provided. It has a fold in it
so that you can create the rear and base cut in
one go.

Centre line of hob/
cabinet

Front top rail

100mm100mm

15mm

4. Tape the flexi ducting and C together and
feed into the service void. Then join the wall and
base cabinets together using fixing plates or
timber offcuts.

Cut out in base

255mm

Cut out from

template

cut the template out and fold along the dotted line
then measure 255mm from the centre of the hob/
cabinet and mark the position.

Place centre line of the template on the cabinet,
make a mark and then fold over the bottome panel
and cut out the base and bottom panel around the
template

FIT THE FEET TO THE WALL CABINET.

Fixed area

LAM9500

Page 2